What kind of coolant does my Dodge Ram 1500 take?
What kind of coolant does my Dodge Ram 1500 take?
1. ACDelco DEX-Cool Coolant Antifreeze – 12346290. And finally, we have the ACDelco DEX-Cool Coolant Antifreeze – 12346290 for the Dodge Ram 1500 Pickup. This is an OEM compatible coolant manufactured by ACDelco which is suitable for engines from various different manufacturers, the Ram 1500 included.
Where is the drain plug on a Dodge Ram?
Locate the radiator’s drain valve on the bottom of the radiator. You don’t need to raise the Dodge Ram since it’s a high truck with enough room for this job. Place a tray underneath the drain plug.
How do you flush a Dodge Ram radiator?
After you dispose the old coolant, close the drain plug and fill the radiator with distilled water. Once again, open the drain valve and let the water drain out of the radiator. Repeat this process at least three times.
Where is the radiator located on a Dodge Ram?
It’s located in the front of the car on top of the radiator. Before removing the radiator cap, be sure to put your hand on top of the engine to check if it is hot. If you can’t touch the engine, the coolant inside the engine is too hot and will burn you.
How do you replace a radiator drainage plug?
This is a short tutorial video on how to replace your radiator drainage plug. Mine snapped off because it is plastic so I had to figure out a way to replace it. Vehicle: Used a Ford Ranger but process can likely be used in many scenarios. Supplies needed: Needle nose pliers, bucket, replacement plug. Loading…
Locate the radiator’s drain valve on the bottom of the radiator. You don’t need to raise the Dodge Ram since it’s a high truck with enough room for this job. Place a tray underneath the drain plug.
After you dispose the old coolant, close the drain plug and fill the radiator with distilled water. Once again, open the drain valve and let the water drain out of the radiator. Repeat this process at least three times.
How to get coolant out of Dodge Ram?
Begin draining the water out of the radiator just like before as well as the heater core hoses, lower radiator hose, and remove the thermostat housing bleeder plug again. Let everything drain and then move to the passengers side block drain. Allow that to drain just like before and the drivers side as well if you can get it out.
It’s located in the front of the car on top of the radiator. Before removing the radiator cap, be sure to put your hand on top of the engine to check if it is hot. If you can’t touch the engine, the coolant inside the engine is too hot and will burn you.
