Where does the diagnostic wire come from on a Dodge D250?
Where does the diagnostic wire come from on a Dodge D250?
But the diagnostic connector gets power on the dark blue wire which comes from the ignition switch. Fred, as it turns out, as I was digging through diagrams, the red wire going to the ignition switch (which allows this dark blue wire leaving the ignition switch to get power) comes from the same fusible link as the red wire for the ASD relay.
Where is the power line on a Dodge D250?
It is located under the hood on the on the drivers side just above or on the wheel well or just below the drivers side hood hinge (that pivots open and closed). You will see a lot of wires in that area. Look for the big black wire and orange fusible link and check to see if it has power. Was this answer helpful? ASE MASTER TECH, REP…
What makes up the brain of a car?
On Board Computer – The Brain of your Car. If the engine is the heart of a car, the Engine Control Unit (ECU) is the brain. It is the brain that controls the heart. The ECU is a computer, equipped with a 32-bit 40Mhz processor, that manipulates the engine’s ignition systems according to the data it gets from the engine’s sensors.
How to dodge the attack in brain out level 221?
In order for you to find the solution of each level, you need to use your imagination, logic and of course your creativity. Below you’ll find the solution to Brain Out Level 221 How to dodge the attack?
Where are the fusible links on a Dodge D250?
Most of the fusible links on this vehicle are located near the left front fender area. The green wire going to the alternator is the signal wire from the computer correct. But the diagnostic connector gets power on the dark blue wire which comes from the ignition switch.
Why does my D250 pickup have no power?
If you are sure that the alternator is getting battery voltage on the black wire and there is no power on the red wire going to the ASD relay, then we found our problem.
But the diagnostic connector gets power on the dark blue wire which comes from the ignition switch. Fred, as it turns out, as I was digging through diagrams, the red wire going to the ignition switch (which allows this dark blue wire leaving the ignition switch to get power) comes from the same fusible link as the red wire for the ASD relay.
It is located under the hood on the on the drivers side just above or on the wheel well or just below the drivers side hood hinge (that pivots open and closed). You will see a lot of wires in that area. Look for the big black wire and orange fusible link and check to see if it has power. Was this answer helpful? ASE MASTER TECH, REP…
If you are sure that the alternator is getting battery voltage on the black wire and there is no power on the red wire going to the ASD relay, then we found our problem.
Most of the fusible links on this vehicle are located near the left front fender area. The green wire going to the alternator is the signal wire from the computer correct. But the diagnostic connector gets power on the dark blue wire which comes from the ignition switch.
