What size is the axle nut on a 2007 Dodge Ram 1500?

What size is the axle nut on a 2007 Dodge Ram 1500?

The Dodge Ram 1500 truck has an axle nut size of 36 mm. This is also measured aS3/16 to 3/18 of an inch. You will need a 30 mm 12 point axle nut socket wrench to apply and remove the axle nuts from Your vehicle.

How big is the axle nut on a Dodge?

It is 1 3/4 in. Napa has it as an “Axle nut socket” Dodge. it is 1/2 in drive. about 20 bucks. It is 1 3/4 in. Napa has it as an “Axle nut socket” Dodge. it is 1/2 in drive. about 20 bucks.

What size socket do I need to remove the front axle nut on my’06 2500?

What size socket do I need to remove the front axle nut on my ’06 2500? Going to change my front axle u-joints and I heard its a 1-11/16″ but I can’t find one that big. !05RAM05! You can use a 1 11/16ths.

How big is the spindle nut socket on a Dodge Ram 2500?

The spindle nut socket size for a 2014 Dodge ram 2500 is 1 5/16. Ratchet sockets are 12 point so that you can get the proper handle swing in tight places. You can not break a 12 point that thick by hand if properly fit. If you want 6 point you will find them in black impact sockets.

How big is the socket on the front axle?

9/16 12 point for unit bearing bolts. 98% sure 1 11/16 for the spindle nut. Not sure on calipers but it’s nothing special. Loosen spindle nut w/ truck still on ground so wheel won’t spin. Have a box of bandaids and a case of beer on hand. What year? 99 calipers have 10mm think, Allen head. You may require metric size to be exact.

How big is the front axle nut on a ram truck?

Anyone know what size the front axle nut is,don’t have my truck here and need to get one in the morning. I thought it was 43 or 44 mm but can’t remember. Thanks Click to expand… Did a 2011 ram 1500 4×4 today. 36mm for axel bolt and 18mm for three bolts holding hub on.

How to replace the CV axle on a Dodge Ram 1500?

7.Removed the brake caliper and tied it out of the way and removed the abs sensor cable by removing the clips holding it. You must undo the connector clip as well which is plastic riveted into the inside of the wheel well. 8. I used a pitman arm puller to pop the upper ball joint.

How big of a bolt for upper control arm?

Luv me an old thread that smells of cat litter and cigs . My socket is a 1/2″ drive, but my 1/2″ Milwaukee eats stuff like that for breakfast. One of the other cars I’ve owned was a 3 link SRA and the bolt for the upper control arm was 300 ft-lbs with blue loctite and it would take that out with ease.