Where is the Central Timing Module on a Dodge Durango?

They said it’s under the dash behind the steering column, but if it’s in the kick panel I should be able to unscrew the three screws and plug it in myself, right? I’m also guessing I’ll have to get my aftermarket “Viper” alarm system reprogrammed at the installer?

How do you reset the PCM on a Dodge Ram?

Disconnect the negative battery terminal. Insert the key in the ignition and turn it to the “on” position. Do not turn it past this position as if you are starting the truck. Wait 30 seconds, then turn the key to the “off” position and remove it from the ignition. Figure 2. Turn the key to the “on” position and wait 30 seconds.

What does O2 sensor mean on Dodge Ram?

By doing this, the computer and all related sensors go into a sort of learning mode, allowing it to adapt to changes made that could affect airflow or exhaust (O2 sensor) readings. This article applies to the Dodge Ram 2nd Generation (1994-2001).

Where is the CTM located on a Dodge Durango?

The CTM is located behind the kick panel to the left of the drivers feet. It’s roughly a $500 repair at the dealer and you’ll need to bring all of your remote key fobs as they get programmed to it. The part itself is around $300 and I wouldn’t buy a used one as you may end up with the same issue in short order.

What does the PCM do on a Dodge Ram?

This article applies to the Dodge Ram 2nd Generation (1994-2001). Your truck’s PCM (powertrain control management) manages your engine as well as driveline components by reading data from sensors and using that data to make adjustments.

Where is the distributor on a Dodge Ram?

The distributor is not easy to get to. It sits all the way on the back of the engine, and there are plenty of other parts blocking your way. The best way to get to it is to remove the intake system, including the throttle body. Put them aside, and set yourself up to gain easy access to the back of the engine bay.

Why is my alarm not working on my Dodge Durango?

I took the D into the shop to get the alarm checked out and they’re telling me the driver’s side door lock actuator not working is messing up the system and causing it to work intermittently.

Can you use driver’s door controls on a Dodge Durango?

I can only use the driver’s door controls to work the windows on all my doors (none of the other doors work by themselves!) Hey Joe, you should be able to take master switch out and “glue” the contact back into it for the cost of a bottle of super glue. Yeah, I’m going to take a look at it when the speakers get installed.

I took the D into the shop to get the alarm checked out and they’re telling me the driver’s side door lock actuator not working is messing up the system and causing it to work intermittently.