How do you start a 97 Dodge Ram 1500 without the key?

How do you start a 97 Dodge Ram 1500 without the key?

How can I start my truck without a key? Remove the screws that are holding the electrical part (the part with the wires) and the mechanical part of the ignition switch together. Insert a flat-head screwdriver into the key hole and turn in the same direction as you would your key . This will start your car.

How do I start my Ram 1500 with key?

You can still start your Dodge vehicle:

1. Locate the analog key hidden inside the key fob. To do this, flip the fob over, slide the switch at the top left, and pull out the silver key.
2. For safekeeping, place the key back inside the key fob.
3. With your foot on the brake, push the start button with the Dodge key fob.

How much is a Dodge Ram replacement key?

In short, replacing a Dodge Ram key can cost between $50 to $410.

Where is the harness connector on a Dodge Ram 1500?

Occasionally the harness connector is located on the center of the steering column. Don’t be confused with the windshield wipers and headlight harness connector. Those two connectors are located on any one of the corners of the column. To avoid being confused, look at the center. No left, no right. Now look for a brown or yellow wire.

How do you hotwire a battery in a car?

Connect the solenoid to the positive battery terminal. You will see a small wire at the top of the solenoid and the positive battery cable below. Remove the ignition switch wire from the solenoid and, using an insulated screwdriver, short the solenoid’s positive post to the terminal where the ignition switch connects.

How do you start a Dodge Ram 1500?

What you need to do is link the ignition wire on/off the wire to the battery wire. You do that by twisting both of the wires together. Now strip the starter wires about half an inch. Do wear plastic hand gloves before doing this to prevent any electric shock.

What do you need to know about hotwireing a car?

Read the owner’s manual or look online to be sure you can identify all possibilities. Sometimes the ignition wires are brown and the starter wires yellow, but the battery wires are most usually red. Again, the only way to be sure is to read the owner’s manual. You’re not MacGyver; messing with the wrong wires will get you electrocuted.

Connect the solenoid to the positive battery terminal. You will see a small wire at the top of the solenoid and the positive battery cable below. Remove the ignition switch wire from the solenoid and, using an insulated screwdriver, short the solenoid’s positive post to the terminal where the ignition switch connects.

Read the owner’s manual or look online to be sure you can identify all possibilities. Sometimes the ignition wires are brown and the starter wires yellow, but the battery wires are most usually red. Again, the only way to be sure is to read the owner’s manual. You’re not MacGyver; messing with the wrong wires will get you electrocuted.

Is it possible to hotwire a Honda Civic?

Newer models are equipped with a whole host of locking mechanisms in place to keep you from hot-wiring the car unless you’re intimately familiar with the quirks of the model. If you try this on a 2002 Honda Civic, you’re likely to end up setting off alarms and locking the starter, meaning no one can drive it.

Is there a way to hotwire the steering column?

If you have access to the owner’s manual, check to make sure the steering column and gear selector can be overridden. Serious damage to the shifting mechanism and steering column can result from this method. Remove the plastic cover on the steering column. These are usually held in place with concealed clips or #2 Phillips-type screws.