Where is the thermostat in a 2000 Dodge Durango?
Where is the thermostat in a 2000 Dodge Durango?
If you look down on the radiator, on the left side, there is a larrge hose coming out of the radiator toward the engine. Where the hose ends there is a housing with 2 bolts. The Thermostat is found under that. Remove the 2 bolts an replace the thermostat.
Do you need to change the thermostat on a Dodge Durango?
If your Dodge Durango has an overheating problem, you may need to replace the thermostat. For Durango owners, this process is a bit involved, but once you remove all you need to remove to get to the thermostat, you’ll need to decide if you want to stick with the factory-set 192-degree thermostat or install a lower-temperature one.
How do you replace the thermostat on a generator?
Take out old gasket and thermostat. Clean residue from around the inside of the thermostat housing cover. Slide new thermostat into housing with spring side down. Place new gasket over thermostat. Replace the thermostat housing cover and reattach radiator hose. Reassemble belt tensioner and reattach generator.
How do you change the radiator on a Dodge Durango?
Use a jack and jack stands or wheel ramps to raise the front of your Durango. Locate radiator draincock at left side of the bottom of the radiator, facing the rear of the Durango. Drain coolant into a suitable container. Allow reserve tank to empty, then remove radiator cap and continue draining.
Where is the generator located in a Dodge Durango?
Take out mounting bolts for generator. Leave all wiring attached except for 4-wheel drive indicator lamp wiring at the rear of the generator. Follow the top radiator hose to the intake manifold if the engine of your Dodge Durango is 5.7 or 5.9 liter, and the bottom hose if the engine is 3.7 or 4.7 liter.
If your Dodge Durango has an overheating problem, you may need to replace the thermostat. For Durango owners, this process is a bit involved, but once you remove all you need to remove to get to the thermostat, you’ll need to decide if you want to stick with the factory-set 192-degree thermostat or install a lower-temperature one.
Take out old gasket and thermostat. Clean residue from around the inside of the thermostat housing cover. Slide new thermostat into housing with spring side down. Place new gasket over thermostat. Replace the thermostat housing cover and reattach radiator hose. Reassemble belt tensioner and reattach generator.
Use a jack and jack stands or wheel ramps to raise the front of your Durango. Locate radiator draincock at left side of the bottom of the radiator, facing the rear of the Durango. Drain coolant into a suitable container. Allow reserve tank to empty, then remove radiator cap and continue draining.
Take out mounting bolts for generator. Leave all wiring attached except for 4-wheel drive indicator lamp wiring at the rear of the generator. Follow the top radiator hose to the intake manifold if the engine of your Dodge Durango is 5.7 or 5.9 liter, and the bottom hose if the engine is 3.7 or 4.7 liter.
