How do you reset the oil change light on a 2008 Dodge Durango?

How do you reset the oil change light on a 2008 Dodge Durango?

2008-2015

1. Without your foot on the brake pedal, press ENGINE START/STOP button to cycle vehicle to ON/RUN mode (make sure engine is OFF)
2. Fully depress and release the accelerator pedal 3 times within 10 seconds.
3. Turn the key to the OFF position and then back on to confirm reset was accepted.

How do you clear the change oil message?

Hold the Reset Button and Turn the Key

1. Press and hold the reset button.
2. Turn the ignition back to the ON position while holding the reset button.
3. Watch the oil change or maintenance light carefully.
4. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.

How to reset the oil change and service warning?

Typically, 2006 or newer come with the GM Oil Life System. Here’s a general guide to resetting your truck’s oil change and service warning message. Insert the key into the ignition and turn it to the accessory power position. Within five seconds, press on the accelerator and push it to the floor three times.

How to reset the oil change due message on a Dodge Ram?

Turn the ignition key to the on position and press the gas pedal three times. Next turn the ignition key back off and then turn it back on. The messages should now be cleared. Some models you can do this in the EVIC screen, without pressing the gas pedal.

Is there a way to reset the oil light?

Once the odometer is showing the total driven mileage, turn off the ignition. Place your finger on the reset button, then press and hold. While holding, turn on the ignition again. As you hold the reset button, the change oil light should start blinking. Let the light blink for a couple of seconds before you release the reset button.

How to reset the oil change message-YouTube?

Please try again later. on a Husqvarna ride-on lawn mower. The mower has an hour meter, that measures the time the ignition on the mower is turned on. It also reminds you to change the oil with a change oil message. http://deltasystemsinc.com/templates/… Loading…

Turn the ignition key to the on position and press the gas pedal three times. Next turn the ignition key back off and then turn it back on. The messages should now be cleared. Some models you can do this in the EVIC screen, without pressing the gas pedal.

How to reset the service interval ( oil change ) light?

How to Reset the Service Interval (Oil Change) Light with MaxxForce Engines 1 Set park brake 2 Turn the key on 3 Turn the cruise on 4 Turn the cruise off 5 Turn the cruise on 6 Very rapidly push the resume switch four times and then hold down on the fifth time for four seconds. 7 The “Change Oil” message should clear from the odometer window.

How to reset perform service indicator on Dodge 6.7L?

This bulletin is to aid you on resetting the Perform Service indicator you will find on a Dodge 6.7L with the EVIC displaying this message. PERFORM SERVICE INDICATOR- RESET the “Perform Service” message will display on the EVIC each time you turn the ignition switch to the ON/RUN position to indicate emission maintenance is required.

What to do if the change oil warning is not on?

If the change oil warning is not on at the when you get your oil changed your Technician may not even know your vehicle has an oil life monitor system and it may not get reset. Let your Technician know your vehicle has an oil life monitor and ask him to reset it.