Why does my Dodge Ram run when the AC is on?

Why does my Dodge Ram run when the AC is on?

Even when it is cold outside, the condenser fan for the AC will run when the AC is on. I noted it was loud on both my old gen 3 and my 2017. Do you have your defrost on? The fan will come on with defrost no , ac is not one, defrost is not on. something is not right, either a relay got stuck in on position or the temp sensor has lost its mind.

How to test the blower motor ( 2001-2003 Dodge Dakota?

Testing the blower motor on the 2001-2003 Dodge Dakota and Durango, to find out if it’s bad (or not), isn’t hard. I’ll explain the two tests that’ll help you find out if it’s defective or not.

What should the temp be on my Dodge Ram?

Temp is reading normal I beleiv about 160-170 at most, never has over heated, or even come close to it. I do have a lot of mods on it but I doubt that has anything to do with it. Could it be an error with my custom tune? If not, what should I replace? It just drive me nuts hearing the face all the time. Click to expand…

Is it a clutch fan or electric fan?

Might be again the relay or the tune. Is it a clutch fan or electric? Temp is reading normal I beleiv about 160-170 at most, never has over heated, or even come close to it. I do have a lot of mods on it but I doubt that has anything to do with it.

What should the engine temperature be in a Dodge Durango?

If the engine temperature exceeds 99° C. (210° F.) during normal operating conditions, the cooling system must be inspected and repaired. Refer to the 1999 Durango Service Manual (Publication No. 81-37091 16), pages 7-9 through 7-20 for information regarding Cooling System Diagnosis And Testing.

Where is the fan drive located on a water pump?

Discussion: Vehicles built after January 5,1998 have the water pump pulley pressed onto the water pump hub shaft. As in previous models, the viscous fan drive is threaded onto the water pump hub shaft. Because the pulley is pressed onto the hub shaft, viscous fan drive removal/installation procedures are unique.

How do you change the fan shroud on a Dodge?

To allow for adjustment of the fan shroud, drill the upper fan shroud attachment holes to 15 mm (0.59 in.). 8. Attach the new fan blade p/n 52027709 to the new viscous fan drive p/n 52029767AA using the four bolts removed from the old assembly. Tighten the bolts to 23 N.m (17 ft. lbs.). 9.