Where are the side seals on a Dodge Caravan?
Where are the side seals on a Dodge Caravan?
These are the side seals, where the axle shafts insert into the transmission. While difficult to replace, the home do-it-yourselfer can do this with a little patience. It is recommended that one side be done at a time, since the Caravan will have to be jacked up, and the front steering spindle loosened to pull the axle shafts out.
Where is the front crankshaft seal located on a car?
At the front of the engine there is a seal that designed to control oil from leaking out. This seal is located at the front of the crankshaft as it protrudes out of the front of the engine block. The front part of the crankshaft is where the balancer or dampener (same thing) is bolted too and is where the serpentine belt is driven from.
What causes a Dodge Caravan to go out of Spec?
The second most common problem is caused by the Dodge Caravan’s crankshaft end play being out of spec, as reported by 54 owners. The end play is measured by the amount of clearance between the crankshaft’s thrust plate and the main thrust bearing’s vertical surface.
Can a transmission gasket be replaced in a Dodge Caravan?
This is the easiest of all the gaskets to replace. Since it is under the transmission it is relatively accessible, and only requires the removal of bolts, and then the pan, to replace. The Dodge Caravan, like most vehicles, has a transmission cooling radiator, with lines that run from the transmission to the radiator and back.
At the front of the engine there is a seal that designed to control oil from leaking out. This seal is located at the front of the crankshaft as it protrudes out of the front of the engine block. The front part of the crankshaft is where the balancer or dampener (same thing) is bolted too and is where the serpentine belt is driven from.
The second most common problem is caused by the Dodge Caravan’s crankshaft end play being out of spec, as reported by 54 owners. The end play is measured by the amount of clearance between the crankshaft’s thrust plate and the main thrust bearing’s vertical surface.
How do you clean a front crankshaft seal?
Also clean the front of the crankshaft as well. Match the old seal to the new unit to make sure the inner and outer diameters are the same. Then apply a small amount of silicone sealer to the outer rim of the seal. This will help protect against any oil leaks from around the outside of the seal body.
How much does it cost to replace a front crankshaft seal on a car?
If you are having the job done at a repair shop except to pay between $250.00 and $550.00 depending on manufacturer and if the car is front wheel or rear wheel drive. A video of our mechanic performing this job is at the bottom of this guide. The car will need to be jacked up in most cases and supported on jack stands.
