Where can I find the Diagnostic Code on my car?
Where can I find the Diagnostic Code on my car?
Connect scan tool to the 16-pin data link connector (DLC) located near the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3. Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s). Remember, these are manufacturer specific codes only.
What is the diagnostic code for a Dodge check engine?
Refer to our Generic OBD II code list for definitions on all other Dodge diagnostic trouble codes. Manufacturer Specific Codes P0138HO2S12 High Voltage – Related Information P0442Medium EVAP Leak – Related Information P0455Large EVAP Leak – Related Information P0601Internal PCM Controller Failure- Related Information
How do you reset the computer on a Dodge Grand Caravan?
In order to verify that the cause of the problem has been fixed, the computer on your Grand Caravan will need to be reset. This process is simple and takes less than 10 minutes. Pull the hood release lever under the dash to release the hood. Locate the hood latch under the center of the hood and push the latch to the left.
Why does my Dodge Grand Caravan have a check engine light?
Your Dodge Grand Caravan, like all vehicles manufactured after 1996, has an on-board diagnostic system. When one of your Grand Caravan’s sensors indicates that a system is not operating properly, it will trigger the vehicle’s “check engine” light. Sometimes the cause of the error can be as simple as tightening a loose gas cap.
How to check codes on your Dodge Caravan without..?
Its simple you start at the off position and go ON-OFF,ON-OFF, ON and your trouble codes will be displayed. Just to let you know not all codes set the CEL light as their extremely minor, or are manufacture specific codes, like my case, I had a code but it didn’t set the CEL light.
What is the diagnostic code for a Dodge check engine light?
Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s). Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Dodge diagnostic trouble codes. Manufacturer Specific Codes P0138HO2S12 High Voltage – Related Information
How can I find the trouble code on my car?
Watch the “Check Engine” light for codes as documented previously. Turn the key to the “On” position while simultaneously depressing the odometer “Trip” and “Reset” buttons if your dash cluster is digital. The trouble codes read from the odometer display in this method.
Where do I find the DTC code on my car?
1. Connect scan tool to the 16-pin data link connector (DLC) located near the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3. Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s). Remember, these are manufacturer specific codes only.
