Where do you mount load resistors? We have an LED guide on our website but recommend installing the resistors inside the front fenders and against the chassis behind the gray trunk carpet in the rear. Make sure not to mount it near anything that would melt. Why do I need to install load resistors for turn signal lights? Why do I need to install load resistors for the LED turn signal lights? If you don't install the LED turn signal bulbs with load resistors (also called equalizers), you will experience the hyper flash issue. Not only is this extremely ugly,...

Why do people wait too long at red lights? Traffic signals tend to be timed in sequence, so that if you make one green light, you will make them all. (This won't always be the case, as some parts of traffic grids do not communicate with other parts of traffic grids.) But, as you go through a green light, take a tiny amount of time to notice the pedestrian signal. How to avoid getting stuck at red light after red light? How do you avoid getting stuck at red light after red light? There's one very simple answer to this:...

How much does it cost to have a shift cable replaced? The average cost for automatic trans shift cable replacement is between $290 and $334. Labor costs are estimated between $166 and $210 while parts are priced at $124. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed. When should I replace my derailleur cable? 5000 to 6000 miles is a good time frame to replace the cables. Other wise wait till they brake and either have a good stiff pedal in or nice...

What year did Dodge Cummins start emissions? DOC, EGR, DPF, SCR Explained. The 6.7L Cummins, introduced midway through the 2007 model year, was designed to meet strict emissions requirements for diesel engines as outlined by the EPA. When did Cummins start making engines for Dodge trucks? Sales were low, and Dodge needed an answer. In 1989, Dodge partnered with Cummins, incorporating a 5.9L 12-Valve Cummins engine into the D/W 250 and 350 trucks. The first generation Cummins engine single-handedly saved Dodge’s truck line-up, and gave them the ability to compete with Ford and GM. How many valves are in a...

Can a 5.7 Hemi engine have a lifter? An expert who has achieved level 1. This is incorrect for the 5.7 Dodge Hemi engines , on these 5.7 Hemis the intake manifold, exhaust manifolds and the cylinder heads have to be removed to access the lifters . What are the symptoms of a 5.7 Hemi lifter roller? HEMI 5.7 Lifter Roller Symptoms. A few symptoms to look out for with a failed lifter roller include: Ticking; Misfires; Check engine light; Unfortunately, lifter roller problems on the 5.7 HEMI can be tough to diagnose. Many simply experience the ticking sounds and...