Common questions

Is it OK to drive on cupped tires?

Is it OK to drive on cupped tires? For some reason, they seem to get cupped more often than better-quality rubber. TOM: Unfortunately, it's really not safe to drive on cupped tires. So every time the tire rotates, there are high spots that aren't touching the road. That means you have less traction, and less ability to stop and turn. Can I drive with a gash in my tire? A sidewall tire damage is not safe to drive around with. The sidewalls of the tires are much more sensitive than the tread area. In many cases, the damage is damaging...
Common questions

How many camshafts are in a DOHC engine?

How many camshafts are in a DOHC engine? Flat engine and V-engine will contain 4 camshafts as they have two headers. The DOHC engines usually come in 4 valves. One camshaft for the intake valves and the other for the exhaust valves. How many camshafts does an inline engine have? That means each header has two camshafts. Hence, an inline engine will contain 2 camshafts as it has only one header. Flat engine and V-engine will contain 4 camshafts as they have two headers. The DOHC engines usually come in 4 valves. One camshaft for the intake valves and the...
Other

How much does a dually rear fender cost?

How much does a dually rear fender cost? Dodge dually fenders D350 1973-1992 D350 Rear Dually Fenders for single Long Bed or Short Bed conversion from single wheel rear SWR into dually rear wheel DRW including mounting hardware sale only in a pair left and right . Prices: $950.00 dollars Item Number: 052473 What are the rear fenders on a Ford F350? Ford Dually Fenders f350/450 1998-2010 rear dually fenders short bed driver side, replacement factory dually including mounting hardware. Note: this fender work for dually conversion. Price: $ 450.00 Dollars Item#00402 Ford f350/450/650 all series rear dually fenders custom...
Other

Can you replace an alternator with a high output alternator?

Can you replace an alternator with a high output alternator? The good news is that replacing a factory alternator with a high output alternator, in and of itself, isn’t going to damage the rest of the electronics in your car, even if the new alternator is much, much bigger than the old one. As an example that trends closer to the ridiculous than the likely,... What happens when the alternator of a car is dead? The alternator and the car’s battery work hand in hand. A good battery should give you service for the next five years before its lifespan...
Most popular

What are the possible causes of a p1125 Chevy?

What are the possible causes of a p1125 Chevy? P1125 CHEVROLET Possible Causes 1 Faulty Accelerator Pedal Position Sensor 2 Accelerator Pedal Position Sensor harness is open or shorted 3 Accelerator Pedal Position Sensor circuit poor electrical connection What does the DTC p1125 code stand for? The APP sensor 2 signal voltage is low at rest and increases as the pedal is depressed. When the control module detects that the APP sensor 1 and the APP sensor 2 signal circuits are out of correlation with each other, DTC P1125 sets. What causes a faulty accelerator pedal on a Chevrolet? P1125...
Easy lifehacks

Why are there unprotected left turns?

Why are there unprotected left turns? Center Turn Lane Center left turn lanes are also referred to as two-way left turn lanes. These lanes are designed to improve the flow of traffic at busy intersections, by allowing drivers to safely turn left without interfering with motorists traveling straight on. Where can you not make left turns? Some cities have already started limiting left turns to improve safety and traffic flow. San Francisco, Salt Lake City, Birmingham, Alabama, Wilmington, Delaware, Tuscon, Arizona, numerous locations in Michigan, and dozens of other cities in the US and around the world all limit left...
Easy tips

What happens to the rotor after 0.2 s?

What happens to the rotor after 0.2 s? After 0.2 s phase U carries a positive d.c. current of 10 A while phases V and W each carry a negative d.c. current of 5 A. The rotor remains at rest, with full rotor flux now established, and at this time there is no demand for torque, so the motor remains stationary, the slip being zero. How is the rotor time constant in a slip calculator tracked? The rotor time constant was tracked by a proportional integral (PI) regulator that corrects any errors in the slip calculator. The output of this...
Easy tips

What does the cruise control warning light mean?

What does the cruise control warning light mean? What the cruise control light means. Most cruise control lights use 2 different colors to let you know what state the system is in. Typically, the cruise control light will be orange when the system is on, but a speed hasn’t been chosen yet. Once a speed is selected, this light will turn green. Can a faulty brake switch cause cruise control to go off? If a fault has been detected, most of the time only the cruise control will be affected. However, some of these faults can cause issues with other...
Easy tips

Do you need reflectors on the back of your car?

Do you need reflectors on the back of your car? Reflectors at the front of the car must be yellow or white. Reflectors at the rear of your car must be yellow or red. Reflectors on the central part of your car must be yellow. What does a rear bumper reflector do? The reflectors offer some visibility if the taillamps are burned out, or if the car is merely parked on the side of the road and turned off. Can you get pulled over for broken reflector? The short answer to this question is yes, you can get pulled over...
Easy tips

Is the Chevy HHR coolant thermostat too low?

Is the Chevy HHR coolant thermostat too low? The fan can come on at any time. P0128 is not a serious threat to the immediate drivability of your HHR. It should be noted that most modern fuel injected engines to like to run at 200+ degrees. Letting them run too cool can problems after an extended period of time. What do I need to change my HHR thermostat? Need to open two bolts on the housing and nothing else. The cover pulls off. Becareful not to cross thread the aluminum housing when tightening and also make sure the gasket is...