Most popular

When did Ford start using the E4OD?

When did Ford start using the E4OD? 1989 The E4OD was introduced in 1989 and used in both light and heavy duty applications. The E4OD has four forward speeds and electronic shift controls replacing the hydraulic governor control mechanism of the C6. Applications: 1990–1996 Ford Bronco. When did the old Ford Bronco come out? 1965 The Ford Bronco was first introduced in 1965 as a 1966 model. The original Bronco became an icon of an adventurous lifestyle and off-road capability. Available options during the 10-year production of the first Bronco included a CB radio, an auxiliary gas tank, a power...
Common questions

How do you disconnect fuel lines in a Ford F150?

How do you disconnect fuel lines in a Ford F150? To disconnect the fuel lines, you either need a tool that you can get at just about any auto parts store or if you have to you can make a tool out of just about anything that is stiff and will wrap around the hose that you can push into the connector. How do you add Freon to a 1999 Ford F-150? How to add freon to your 1999 Ford F-150: hook up the can of refrigerant (likely r-134a) to the low pressure port. When your compressor kicks on, add...
Other

What is a banjo bolt on a caliper?

What is a banjo bolt on a caliper? A banjo fitting or internally relieved bolt comprises a perforated hollow bolt and spherical union for fluid transfer. The name stems from the shape of the fitting, having a large circular section connected to a thinner pipe, generally similar to the shape of a banjo. Can a hose fitting interfere with a brake line? Sometimes the brake hose fitting can interfere with another part of your brakes. Pay attention to any tight spots when removing your brake lines and communicate any restrictions to the vendor who will be fabricating your replacement brake...
Easy lifehacks

How to make a 7.3 injector a 6.4liter?

How to make a 7.3 injector a 6.4liter? Sticking a longer injector in number 8 is a good way to turn that 7.3 into a 6.4liter:jester:. Going with the AE's might increase the power a little, but the smaller induction on the turbo won't help them without a chip. AB & AD both flow the same. The timing is slightly different. Are there any problems with the Ford 7.3 power stroke engine? It’s also important to note – the Ford 7.3L Power Stroke diesel engine earns high remarks for reliability. They are great engines, however problems can and do occur....
Easy lifehacks

Can a bad carb gasket symptoms?

Can a bad carb gasket symptoms? A larger leak will cause noticeable engine vibration and probable misfire at idle, and severe hesitation under acceleration. One of the vacuum leak's signature symptoms is that it seems to go away under full throttle conditions, particularly at high rpm. Can a gasket leak cause a fuel trim problem? A fuel trim problem can occur if the intake manifold has the tiniest leak. If you just use your eyes and ears to find the leak, it will become very time-consuming. So, Anytime air leaks through the intake manifold, it will cause air to get...
Easy tips

Why is my alternator burning hot?

Why is my alternator burning hot? Most likely causes are; the alternator has been upgraded to a larger unit or the alternator voltage is excessive. High alternator voltage will allow it to produce too many amps and cause the alternator to run hot - too hot will result in premature failure (burning) of your alternator – like really quickly too. What causes an alternator to run very hot? Alternator running very hot. ABS pump not an issue, pulled the fuse and have the same result. Alternator running hot to the point where you cannot touch it and this is my...
Common questions

Is the 2013 Ford Escape fast?

Is the 2013 Ford Escape fast? Getting up to 80 mph is easy, and passing power is exemplary. At our test track, we clocked the AWD Titanium to 60 mph in 6.8 seconds and through the quarter-mile in 15.2 seconds at 88.8 mph. Good numbers, but honestly, the Escape felt quicker. Everyone who drove the 3791-pound CUV commented on how car-like it felt. What's the price of a 2013 Ford Escape? Lacking full leather, a trailer hitch, and a sunroof, the Escape titanium 4WD tested here lists at $34,735; adding those options would hike the sticker above $37,000. We don’t...
Easy lifehacks

Why is my check engine light on my Harley?

Why is my check engine light on my Harley? An illuminated check engine light is an indication that the motorcycle's onboard diagnostic system detects a current or historic trouble code, known as diagnostic trouble codes (DTC). A DTC is directional information for an owner or technician to begin diagnostic work. How to reset the Check Engine light on a Ford F 250? Turn the OBD tool on, using the power switch on the tool. Turn the ignition key to the "II" position and wait for the check engine light to go off. This will reset the error codes and the...
Most popular

Can you reuse 302 head bolts?

Can you reuse 302 head bolts? Can I reuse head bolts? A head bolt should not be reused if the threads are galled or badly damaged. Chasing damaged head bolt threads with a die will clean up the threads but also remove material (metal) and undermine the head bolt's ability to torque down and hold to specs. What should the head nut torque be on a Ford? Ford did not publish actual torque values for the Model A cylinder head nuts, but the long accepted standard has been 55 lb-ft for a stock head, and as much as 65 lb-ft...
Other

How much does it cost to rebuild a rear?

How much does it cost to rebuild a rear? A typical rear differential repair costs anywhere between $200 and $400. These typical repairs would include your bearing, seals, and fluid changes. Of course, when a gear change is required, that's when things get pricey. $1,500 is just the minimum you can expect to pay for new gears. What do you call a rebuilt rear axle? We offer rebuilt rear axle assemblies, reconditioned rear axle assemblies as well as picking up your broken axle for repair or refurbishing. When it comes to shopping for an axle assembly you will find people...