Other

Why are my power running boards not working?

Why are my power running boards not working? After it was replaced, the power running boards do not work any more. I have tried switching them on and off. When the battery was replaced, the power running board switch was in the off position. Did you check the fuse? Yes, Sorry I did forget to mention that I replaced the 30A fuse. Where is the disable switch on a power running board? Open all front and rear doors. Set the parking brake. Find the running board disable switch located on the center console below the HVAC climate control system. Turn...
Common questions

How many volts does a voltage regulator have?

How many volts does a voltage regulator have? Voltage Regulator Test. Charging voltage can vary between 13.5 and 14.8 volts, depending on ambient temperature. In a nice, 70 F (21 C) day, you can expect a voltage regulator charging your car's battery at about 14.2 volts. Do you need a voltage regulator wiring diagram? Alternator Wiring Diagram Chevy New Voltage Regulator Wiring Diagram – Voltage Regulator Wiring Diagram You can often rely on Wiring Diagram being an essential reference that may enable you to save time and money. Using the aid of this guide, you’ll be able to easily do...
Other

How long will a 6.7 power stroke last?

How long will a 6.7 power stroke last? After years of production, the 6.7L Power Stroke has proven it can storm past the 200,000-mile mark with few repairs. Provided you adhere to Ford's recommended service intervals, there is no reason this engine won't see 300,000 or even 400,000 miles. How much HP does a stock 6.7 Powerstroke have? *475 horsepower at 2,600 rpm with available 6.7L Power Stroke® Diesel engine. How do I add horsepower to my 6.7 Powerstroke? How to Increase Horsepower on Your 6.7 PowerstrokeCustom Tuning. The days of mechanically controlled diesel trucks are long gone. Intake. Intercooler...
Easy tips

Can I use nylon for fuel line?

Can I use nylon for fuel line? One option for replacing metal fuel lines is with a nylon tubing and specific fittings. Nylon tubing can be used for an entire length of fuel line or just a section. This option can be a cost-effective and time-efficient repair when pre-bent lines are not available. Can you use nylon fittings with gasoline? Many late-model production cars are now using hard, black nylon tubing with special connectors to attach fuel-feed lines to the gas tank sending unit/fuel pump modules. This gas-resistant nylon tubing can be purchased by the foot or in short sections...
Most popular

How long does it take to charge a 2002 Ford Think?

How long does it take to charge a 2002 Ford Think? I have recently purchased a 2002 Ford Think. We bought it without knowing the condition of the batteries. It was plugged in for three full days, full charge showing on both the on board charger and dash meter....it will go about 8 feet and they are completely drained. New battery time. When did the Ford Think come out for sale? The Think is a new vehicle released for sale (locally) in Spring 2002, this is Ford’s entry into the electric vehicle market. This Think is classified as a Neighborhood...
Most popular

Why can I read something but not understand it?

Why can I read something but not understand it? A dyslexic can have many reading problems. They may say “animal” as “aminal.” They may read a word correctly on one page, but later, they won't recognize the same word. Some dyslexics can read words well, but they don't understand what they're reading. They must read a sentence several times to get its meaning. Why do I have trouble reading sometimes? Dyslexia is a learning disorder that involves difficulty reading due to problems identifying speech sounds and learning how they relate to letters and words (decoding). Also called reading disability, dyslexia...
Common questions

How do I fix my idle hunting?

How do I fix my idle hunting? Idle surging... Hunting idle.... Lets fix this now.Make sure your coolant system is fairly bubble free. Check for any codes stored in your ECU. Check for any cracked hoses or loose clamps.Turn the motor on and remove the 2 pin plug from the IACV(EACV). Remove the IACV(EACV) from the rear of the intake manifold. What are the downsides of a rough idle? The downsides of a rough idle can be reduced fuel economy, poor performance, starting issues, or potential major engine problems in the near future. It is best to try to diagnose...
Easy lifehacks

Do you need an ISOFIX bracket for a Ford Focus?

Do you need an ISOFIX bracket for a Ford Focus? This post is a quick guide for the easy retrofitting of an ISOfix bracket to a Ford Focus Mk1, in this case, a 2003 model. The ISOfix has been fitted to the near side (passenger side) in the case of this guide. What do you need? To complete this fit, you will need the following: Where are the mounting points on a Ford Focus? There are mounting points to both the rear of the left and the right seats (not the middle). Pull up the base of the seat on...
Easy lifehacks

What year is Ford Focus Mk2?

What year is Ford Focus Mk2? 2005-2011 Mk2 Focus (2005-2011) The Mk2 Focus was announced in 2004, and went on sale in 2005 after six years of massive success with the Mk1. At first glance, it appeared that Ford had played it 'safe' with the design of the new car, especially considering how radical the first generation looked. Is the Ford Focus the second generation car? Though informally considered as the second generation, it was never officially referred to as such by Ford since its platform was the same as the first generation. For the third generation, Ford reunited both...
Easy tips

How do I turn off immobiliser on Ford Galaxy?

How do I turn off immobiliser on Ford Galaxy? How do I disarm my Immobiliser? Turn the key to unlock your car door, but don't release it. Hold the key in this position for 20 to 30 seconds. This lets the system know you have the correct key, and it can allow you to bypass the alarm system. Where is the transponder on the Ford Galaxy remote? The transponder on keys B and C is embedded into the plastic so it can't be lost. Unfortunately on the remote key it sits in a channel within the key shaft which means...