Other

Where is the radio receiver on a 90-92 corvette?

Where is the radio receiver on a 90-92 corvette? 14: If you’re working on a 90-92, locate the radio receiver below the glove compartment on the multi-use relay bracket. It is marked by #7 in this GM Service Manual drawing. Unplug the radio antenna and speaker connections. You can remove the receiver and store it or leave it in place. Can a Bose receiver be installed in a C4 Corvette? There are challenges to installing an aftermarket receiver in a late-C4 originally equipped with the up-level, UU8 or U1F Delco-Bose music systems. The most significant are: 1) generally, aftermarket receivers...
Most popular

Where does single turbo go on Chev 6.5L diesel?

Where does single turbo go on Chev 6.5L diesel? Personally I have a large single turbo set up on a V8 Chev 6.5L turbo diesel. The far bank runs back down and across and under the rear engine section and joins into the exhaust manifold under the turbo, if that makes any sense. Although the engine has been fitted into a landcruiser, they come crated from the states with this type of turbo set up. Is it safe to run a single turbo on a 5l? If your gonna use a 5l, your best off running a turbo off a...
Most popular

How fast can you drive f150 in 4 wheel drive?

How fast can you drive f150 in 4 wheel drive? 55 mph (88 km/h). Note: Do not perform this operation if the rear wheels are slipping. normal. However, personally if you can drive faster then 55MPH, you do not need to be in four wheel drive mode. What was the price of a 2002 Ford F150? Figures quoted are averages from nationally available service contract providers and are adjusted to eliminate the profit margin from the calculation. Cost to own data is not currently available for the 2002 Ford F150 Pickup-V8 Supercab 139" XLT 4WD. 2002 F-150 listings within 50...
Easy lifehacks

How to tell if a push rod is bent?

How to tell if a push rod is bent? 1 Remove the valve cover on the affected bank of the engine. 2 Wiggle all of the pushrods to determine which rod or rods are bent and mark the rod with a yellow wax marker. 3 Remove the rocker arm by removing the rocker arm nut over the bent pushrod -- if the vehicle is equipped with individual rocker arms. How do you remove a bent pushrod motor? Use a ratchet wrench and the appropriate size socket for the nuts or bolts being removed. Remove the bent pushrod by pulling it...
Other

Does a Ford Focus have a timing belt or a timing chain?

Does a Ford Focus have a timing belt or a timing chain? The Ford Focus 2013 does have a timing chain. The coolant needs to be changed every 60,000 miles or so. Your air filter needs to be changed every 15,000 to 30,000 miles or so. The spark plugs need to be replaced every 100,000 miles unless it's a copper one. When to change the cam belt on a Ford Focus? If it works, don't mend it. This sturdy Zetec engine cambelt was designed back in the 90s to last the life of the car. Our family Focus 1.6 is...
Common questions

Does synthetic oil flow better?

Does synthetic oil flow better? At both low and high temperatures, synthetic oils enjoy better viscosity and stability than conventional oil or synthetic blends. As more cars are built with smaller engines and turbochargers, synthetic oils flow quicker to critical parts, creating the proper lubrication your engine needs. What happens when your oil pressure is too low? When engine oil pressure drops, friction between different parts increases. This results in a steep decline in engine performance. Watch out for common signs of decreased engine performance such as a reduction in fuel economy, loss of power, and engine stalling. Are there...
Easy lifehacks

What kind of oil to put in a diesel F250?

What kind of oil to put in a diesel F250? What oil for diesel? Discussion in ' 2017 - 2022 Ford F250+ Super Duty Forum ' started by Kajtek1, Sep 8, 2017 . I had my 1st oil change done by dealer and they put some cheap oil in it, so I am getting ready to do 2nd myself. What are the features of a Ford F-350 Super Duty? SNOW PLOW PREP PACKAGE, STX APPEARANCE PACKAGE, PLATFORM RUNNING BOARDS, TRANSFER CASE & FUEL TANK SKID PLATES. SPARE TIRE, WHEEL, CARRIER & JACK, UPFITTER SWITCHES (6), POWER EQUIPMENT GROUP, ORDER CODE...
Other

What size tire do I need for a 2005 Ford Escape?

What size tire do I need for a 2005 Ford Escape? The XLT, Hybrid and Limited models all have slightly larger P235/70R16 tires that are mounted on a 16-inch wheel that iS7-inches wide. The tires should be inflated to 30psi, and that pressure remain the same across all models. What size are the lug nuts on a 2005 Ford Escape? M12 x 1.50 Ford Escape 2005, Cone Seat Standard Lug Nuts by Dorman®. Thread Size: M12 x 1.50. Where is the spare tire located on a 2005 Ford Escape? The 2005 Ford Escape's spare tire is mounted beneath the rear...
Easy lifehacks

Will a PB Blaster loosen spark plugs?

Will a PB Blaster loosen spark plugs? Sure! PB blaster is good stuff and won't harm combustion if a little extra gets in there. Thanks! I have a regular socket but it's going to get stuck, not thin enough. How long should you let penetrating oil sit? about 15 minutes In most cases, you will have to wait for about 15 minutes for the oil to work effectively. It will, however, depend on the quality of oil and what it's penetrating. Some penetrants will even need a whole hour and some wrenching to get the nuts loose. Using precision applicators...
Other

How big is the bed on a 2004 Ford F-150?

How big is the bed on a 2004 Ford F-150? For the first time, the 2004 SuperCab also will offer a 5.5-foot bed, making it the only F-150 body style to offer three bed lengths. Styleside (flat) and Flareside (with fenders and integrated steps) box styles are available on the STX, XLT and FX4 trim levels, depending on the cab body type. Exterior differences include: When does the 2004 Ford F-150 come out? A recent key example of what you might call a “worst practice” was the parallel development of the new-generation 2003 Ford Expedition full-size sport utility vehicle and...