Easy lifehacks

Where is the EVAP canister located on a Ford Explorer?

Where is the EVAP canister located on a Ford Explorer? Evap Canister Location: Where Is Evap Canister Location on Ford Where is evap canister location on ford 2002 explorer? have the same problem? The EVAP canister is located at the rear of the car near the fuel tank here are diagrams below to help you change it out. What are the components of the EVAP system? The powertrain control module (PCM) uses three simple but robust components to purge gas vapors and test the gas vapor system for leak integrity. The canister purge solenoid (CPS), canister vent solenoid (CVS) and...
Other

What kind of wire do you use to hook up a light fixture?

What kind of wire do you use to hook up a light fixture? In most cases, the nuts are the same color, such as red, yellow or black. Again, this depends on the manufacturer, and any color wire nut can be used to connect a corresponding color of electrical and light fixture wires. Light fixtures with more than one lamp may have a pair of black and white wires for each lamp. What kind of wire do you need to connect a speaker? Connecting Receivers or Amplifiers. Wires must be connected correctly on both the receiver or amplifier and speakers....
Common questions

How does a 12V fog light relay work?

How does a 12V fog light relay work? 12v universal wiring harness kit relay fuse switch. Fog lights off with high beams on relay wiring diagram. Draw a diagram on plain white paper with wire gauge noted and colors identified. Learn what a relay is how it works and why you should use one. The lamps and relay harness are to be used only with 12 volt automotive. Use as reference only. How does a dipper switch work on a fog lamp? Run the Fog switch S2 wire to relay COM-right, and run the Dipper switch high beam wire to...
Easy lifehacks

Why do trailer air brakes lock up?

Why do trailer air brakes lock up? A brake that locks up is often the symptom of air pressure loss, slack adjuster out of adjustment or a failed s-cam bushing- so check all 3 components as well as the brake chamber setters and diaphragms. What's the best way to free a frozen parking brake? Direct your strikes at the ice only, and don’t hit it so hard that you damage or dent the brake components. Move the cable around to free ice surrounding it. Gently wiggle the cable back and forth. It should move freely. If it doesn’t, inspect the...
Easy lifehacks

What is the ratio of 40 minutes to an hour?

What is the ratio of 40 minutes to an hour? 2/3rd Answer: 40 minutes is 2/3rd of an hour. What is the ratio of 40 minutes to 4 hours? = 4×60= 240 mins. What is the ratio of 2 hours 40 minutes? 2hrs 40 min = (2 × 60 + 40)min = 120 + 40 min = 160mins. How do you find the ratio of hours and minutes? Explanation: To find ratio of the two, weshould first convert them first to same units. One hour is 60 minutes and as such 14 hour is 14×60=15 minutes and 114 hours is...
Common questions

What are pending trouble codes?

What are pending trouble codes? These codes are referred to as pending or maturing codes. Pending codes are caused by intermittent faults or faults that the PCM needs to see happen in two consecutive warm-up cycles to set the code. If the fault does not reappear within 40 warm-up cycles, the code will be cleared from memory. What do you do when you get a trouble code? When all trouble codes are outputted, it will flash the code 12 – 1 flash * Pause * 2 flashes. Write down all the trouble code numbers you got and check the trouble...
Easy lifehacks

How do you check the voltage on a 7.3 injector?

How do you check the voltage on a 7.3 injector? Test the Fuel Injector Wire VoltageTurn the ignition key to the "On" position. It is not necessary to start the engine. Disconnect the electrical plug from the fuel injector to be tested.Set the multimeter to "Volts." Insert the multimeter leads into each side of the injector plug. No specific polarity is required. How to test fuel injector resistance on 7.3 liter Ford PowerStroke? This feature is not available right now. Please try again later. Here's a quick video showing testing resistance from the fuel injector using a test connector into...
Easy tips

How long can a car be on before the battery dies?

How long can a car be on before the battery dies? When stored properly out of the car in a secure place, a detached car battery has the chance to last up to six months. Just like any other car battery, it will need charging, but not as often as if it were attached. Giving the battery a charge around every 12 weeks is a good rule of thumb. What happens when a car battery dies for the first time? When your car battery dies once, it may be tempting to just write it off as a fluke. Car batteries...
Most popular

Why do I hiccup intermittently?

Why do I hiccup intermittently? Some causes of hiccups include: Eating too quickly and swallowing air along with foods. Eating too much (fatty or spicy foods, in particular) or drinking too much (carbonated beverages or alcohol) can distend the stomach and cause irritation of the diaphragm, which can cause hiccups. Why won't my hiccups go away? A cause of long-term hiccups is damage to or irritation of the vagus nerves or phrenic nerves, which serve the diaphragm muscle. Factors that may cause damage or irritation to these nerves include: A hair or something else in your ear touching your eardrum....
Most popular

How does the air vent in a car work?

How does the air vent in a car work? On later cars, all the entry points have flaps for opening and closing them as needed. At the rear there are exit vents to the outside. They are in an area of low pressure when the car is moving, and so extract air, thus giving a constant through-flow. What should the air vent Temperature be in a car? Place a probe thermometer into the lower air vents on both the driver and passenger sides. Any reading around 115F-120F (46C-49C) is acceptable. Some vehicle manufacturers boast their heaters will do 135F-155F (57C-68C)...