Most popular

What does it mean when your car says P0300?

What does it mean when your car says P0300? Many times, P0300 occurs when there are worn out spark plugs, spark plug wires, or a faulty ignition coil. P0300 should be repaired immediately. Ignoring this error could result in ignition failure, catalytic converter damage, and unsafe/dangerous conditions while operating the vehicle. What are the causes of a P0300 leak? P0300 Causes 1 Faulty or worn spark plugs * 2 Faulty spark plug wires or coils * 3 Distributor failure * 4 Faulty fuel injector 5 Vacuum leak 6 Low fuel pressure 7 Camshaft sensor defective 8 Crankshaft sensor defective 9...
Easy tips

Can a 1994 Jeep Cherokee ignition switch be replaced?

Can a 1994 Jeep Cherokee ignition switch be replaced? Replacing the ignition switch on a 1994 Jeep Cherokee can be completed after removing the lower dashboard trim piece panel. A failing ignition switch can cause problems when turning the key or can stop the key from turning completely, leaving a driver stranded. The task can be completed by most novice mechanics with limited automotive experience. How do you replace an ignition switch on a car? Installing a Replacement Squeeze the release pin on the ignition switch so it’s flush with the side. The same release pin that stopped the switch...
Common questions

Is there a product to stop transmission leak?

Is there a product to stop transmission leak? You can fix it yourself with Bar's Leaks Transmission Stop Leak Concentrate. This product is specially designed to stop seal and gasket leaks caused by normal transmission wear and age. It even works with ALL domestics and imports, as well as all automatic and manual transmission fluids. What should I do if I have a transmission leak? When the housing is damaged, the fix is usually to replace (rather than rebuild) the transmission. Before you can fix a transmission leak, you must first find out where the leak is coming from. Safely...
Common questions

What is the belt diagram for a 5.4 liter engine?

What is the belt diagram for a 5.4 liter engine? Here is the 5.4 Liter belt diagram by popular demand. Engine belt noise is a common complaint on many vehicles and many different engines. The Ford 5.4 L engine is no different in this respect. What kind of belt do I need for GM 2.4 liter engine? Pictures and diagrams of some common serpentine engine drive belt routing for the GM 2.4 liter four cylinder engine in Chevrolet, Buick, Pontiac and Oldsmobile cars. When replacing your car serpentine drive belt, use these diagrams to help with the installation if you...
Common questions

How much does a Chevy 396 / 402 piston weigh?

How much does a Chevy 396 / 402 piston weigh? Chevrolet 396/402 pistons forged dome top piston and ring set | .060 oversize 4.185 bore | 9.6-1 compression with 105cc chamber | 3.760 stroke | 6.135 rod | 1.765 compression height | .990 wrist pin | 5/64 5/64 3/16 ring grooves | dome top 17cc | 4032 Alloy | weight piston 674 grams wrist pin 141 grams What was the compression ratio of a Chevy 402 engine? Technical Specifications This engine had a bore of 4.124 inches and a stroke of 3.76 inches; to compare, the 396 had a bore...
Easy tips

Can MAP sensor be cleaned?

Can MAP sensor be cleaned? Clean the outer surface of the MAP sensor using electric parts cleaner. Place the MAP sensor on a flat surface with the sensor facing upward. Spray a dry rag with electrical parts cleaner. Gently scrub the rest of the sensor with the rag, taking care not to scrub the sensor itself. Can a map sensor be bypassed? Map sensor bypass. To install a map sensor bypass (check valves not missing link) you have to take the map sensor off the manifold and then take the t connector and stick it in the hole that is...
Easy tips

Where are the gas tanks on a suburban?

Where are the gas tanks on a suburban? It’s a 2000 model, and the 3/4 tons like mine have two tanks. One in the very rear, above the spare tire, that fills as you put gas in the truck and then spills over into the front tank which is mounted inside the framerail on the driver’s side under both the front and rear seats. How are fuel pumps attached to a suburban? So once the rear tank was out it was time to jack up the driver’s side of the truck enough to be able to drop the main tank...
Common questions

Is there a GPS navigation system for a raxiom Mustang?

Is there a GPS navigation system for a raxiom Mustang? Enter Your Email to Save Products. GPS Navigation System. Upgrade your 2005-2009 Mustang's factory radio to a state of the art Raxiom OE-Style GPS Navigation System with Bluetooth and Back-up Camera. What is the back up camera on a Mustang? Back-up Camera. The included full color back-up camera features an "Instant-on" mode when the gear selector is placed in reverse, which automatically displays what is behind your Mustang when backing up. You also have a touch screen option to activate the camera whenever you desire, whether in park or while...
Other

What kind of suspension does a 1953 Corvette have?

What kind of suspension does a 1953 Corvette have? 1953-62 Corvette frame, with Channel X-member, Chevy performance motor mounts, Automatic Transmission mount, Tubular coil spring IFS with front sway bar, new manual rack & pinion (power rack upgrade available) and one of the following rear suspension: Do you need a rear suspension kit for a C4 Corvette? Our weld-in 1984-96 C4 Corvette IRS rear suspension kits will allow you to bolt your supplied C4 rear end and either Ride Tech Coil overs or ShockWaves for air ride in place. Each weld-in kit is specifically designed per Make & Model for...
Most popular

What are signs of a bad solenoid?

What are signs of a bad solenoid? As a result, the common signs of a bad starter solenoid include:Engine Doesn't Crank or Start. No Clicking Noise When Trying to Start the Engine. Starter Spins Without Fully Engaging the Flywheel (Rare) Engine Cranks Slowly (Rare) Test the battery. Check That Power is Getting to the Starter Solenoid. What are the most common starter solenoid problems? There are 4 most common starter solenoid problems. #1.The starter solenoid failing to reset, even upon releasing the starter button, or turn the car switch in the off position, the starter continues to operate. #2.The sucking...