Common questions

Where is the coolant temp sensor on a 2007 Ford Focus?

Where is the coolant temp sensor on a 2007 Ford Focus? In the Ford Focus 2007, with the 2.0L Duratec motor Ford uses just one sensor for both the cylinder head and coolant temps. The sensor is located in the head between the 2nd and 3rd sparkplug. Where is the coolant temp sensor located in a Ford Focus? 2007 ford focus 2.0 where is the coolant temp sensor located and how do you change it 2007 ford focus 2.0 where is the coolant temp sensor located and how do you change it - Answered by a verified Ford Mechanic We...
Easy lifehacks

When did the Ford Focus 1 16V come out?

When did the Ford Focus 1 16V come out? For stopping power, the Focus 1 1.6 16v braking system includes Vented Discs at the front and Drums at the rear. The Focus 1 model is a car manufactured by Ford, sold new from year 2001 until 2004, and available after that as a used car. Independent. How much horsepower does a Ford Focus have? The 2001 Ford Focus 1 1.6 16v has 100 PS / 99 bhp / 74 kW. How much does a Ford Focus 1 1.6 16v weighs? What is the top speed of a Ford Focus 1...
Easy lifehacks

What causes a tensioner to break?

What causes a tensioner to break? The belt can break due to a number of reasons, but the most common is age. One other common problem is the belt tensioner. If the tensioner is bad, it can cause the belt to come loose or cause the pulley to seize, making the belt come off. Why did my SERP belt tensioner bolt snap? VCM has nothing to do with serp belt tensioner bolt breakage. It is all about correct bleeding procedure and tightening bolt up to the specs BEFORE installing serpentine belt. If you didn't apply correct bleeding and tightening, your...
Most popular

Do AU Falcons have OBD2?

Do AU Falcons have OBD2? In AUstralia - the AU flacon is equiped with an obd2 connector - but will not connect with my odb2 scan tool. I'm almost certain that Ford never used the same protocols as GM. Are there diagnostic codes for Ford AU Falcon? -AU Falcon DTC diagnostic trouble codes (are they listed in a service manual?) The standard obd ones and also the extended ones too. It would be nice to get some data out of the ecu, but there is so little real information on the web to connect to any ecu that uses the...
Most popular

How often should you change your engine oil?

How often should you change your engine oil? If you drive, you’ve probably been told that you need an oil change every 3,000 miles. This is a widely accepted standard when it comes to oil changes, but do you really need to change your engine oil after traveling exactly 3,000 miles? Is it bad to go 6000 miles between oil changes? Yes indeed, going 6000 miles between changes could be a problem if there was only 1 quart of oil left in the crankcase… Usually the oil change interval is 5000 miles so if you went 6000 miles it should...
Easy lifehacks

When did the Ford Thunderbird retro bird come out?

When did the Ford Thunderbird retro bird come out? Ford described it as a personal luxury car. 2002-2005 "Retro Birds"In 2002 a new Thunderbird launched; this Retro Bird was again a two-seater and received the model's third Motor Trend Car of the Year honor. What kind of platform did the Ford Thunderbird have? All 1980-1988 Thunderbirds were based on Ford's Fox platform. In 1989 a new Thunderbird was introduced on Ford's brand new MN12 platform. This model was produced until 1997. Ford's iconic Mustang pony car was overhauled for the 80s, featuring a brand new design for the Fox platform....
Easy lifehacks

How much does it cost to diagnose the p0351 Ford code?

How much does it cost to diagnose the p0351 Ford code? The cost of diagnosing the P0351 FORD code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. When is the P0351 FORD code detected? How does the p0351 Ford engine light work? The Engine Control Module ( ECM) controls each ignition coil operation. The ECM sends a ON/OFF signal to energize the ignition coil to create a spark at the spark plug when a...
Common questions

Why is my oil filter dry?

Why is my oil filter dry? there's no way the filter could have been, as you say, “dry”. The oil flow normally runs through the filter media. If, for whatever reason(s), the oil cannot easily pass through the filter media pressure build up will eventually cause the bypass valve to open. Do oil filters dry out? The paper filter media inside most oil filters can deteriorate while exposed to oxygen. When that happens, the filter media may become too porous to filter the oil. Also, if the filter media sheds fibers, the fiber can actually clog up the filter. The...
Most popular

Do manual transmissions have a VSS?

Do manual transmissions have a VSS? Note that both manual and automatic transmission cars require speed sensors to make fuel mixture and emissions control decisions. Automatic Transmission The Vehicle Speed Sensor (VSS) is located on the right side of the transmission near the output shaft. ... How many ohms should a vehicle speed sensor read? The typical reading for a passive wheel speed sensor is between 1,000 and 2,500 ohms. This is a normal range for all passive sensors. The specification for active sensors is between 1,000 and 2,500 ohms. Where is the VSS sensor on my car? Locate the...
Most popular

What kind of mains does Ford 3.8L engine use?

What kind of mains does Ford 3.8L engine use? The XL3E block was carried over from 1999, but it had six, long, studded mains and the thick girdle that had a windage tray in the middle. The 2001 FWD block is a 1F2E casting that has the short mains, but it has six studded main bolts that are used for the stud girdle that has a windage tray in the center. Where are the Spacers in a Ford 3.8L engine? There are four spacers that go between the main caps and the windage tray that move it down far enough...