Easy tips

Is the passenger side floor wet or dry?

Is the passenger side floor wet or dry? Took the mat out and was dripping like it's just come out of wash. Checked any signs of external water leak but all looked ok, The seats were dry and all the other side floor (driver and rear) are fine too. What does it mean when your car floor is wet? It sounded like we were driving a giant water bottle because the water would swish from front to back. Once they fixed that seal and drained the water the floor was dry and there was no more swishing. I would add...
Other

Do you need to replace the wheel speed sensor?

Do you need to replace the wheel speed sensor? According to a recent BRAKE & FRONT END survey, the most commonly replaced ABS items are wheel speed sensors and wheel bearing hub units with wheel speed sensors. Pulling a wheel speed sensor code does not mean that you should immediately pull and replace the sensor. How do you install an ABS wheel speed sensor? 3. Install the front ABS wheel-speed sensor to the removed the wheel hub, steering knuckle component, and tighten to the specified torque. 1. Measure the gap between the front ABS sensor rotor and the front ABS...
Common questions

When did GM put disc brakes on Silverado?

When did GM put disc brakes on Silverado? Prior to 1999, the Silverado/Sierra pickup trucks had drum brakes at the rear wheels. In 1999, standard four-wheel disc brakes were introduced for these vehicles, but these remained only through 2004. How big is the rear disc on a Chevy Silverado? According to Delphi, disc diameter can be reduced by 25 millimeters, which allows use of smaller, lower-cost wheels. This system is suitable for a wide range of vehicles, from small passenger cars to light-duty sport-utility vehicles and trucks. What to do if your brakes are sticking on your Silverado? Remove the...
Easy tips

Is a loose rotor dangerous?

Is a loose rotor dangerous? The rotors are part of the disc brakes that allow your vehicle to stop once the vehicle is in motion. If the rotors are warped, your vehicle may not be able to stop properly in an emergency situation. This can be dangerous if you need to stop to avoid a car accident, pedestrian, or another driving situation. What happens when a brake rotor wears down? Rotors are designed to have a thickness that wears down over time. However, should it degrade to a certain point, it lowers the overall safety of the vehicle. 4. Increased...
Most popular

What was the horsepower of a 1970 Chevy 350?

What was the horsepower of a 1970 Chevy 350? That same engine was offered in other models and by 1970, several variants of the same engine were being used across Chevrolet's model lineup, including trucks. Power output is as follows: 1970 350 2V: 250 horsepower 1970 350 4V: 300 horsepower 1970 350 4V: 350 horsepower 1970 350 4V: 370/360 horsepower (LT1, Corvette/Z28) When did the Chevy 350 engine come out? The 350 C. I. V8 engine is one of Chevrolet's most popular and mass-produced engines. Introduced in 1967, it was based on the same cylinder block design of many small...
Easy lifehacks

How to find an automotive parasitic draw dead battery?

How to find an automotive parasitic draw dead battery? At night look under the vehicle to check for light near the engine bay, to fix this problem replace the light assembly. If you can't find the cause of the battery drain, a manual draw check of the electrical system will need to be performed. What causes a car to draw power from the battery? Learn more... If your vehicle is drawing power from the battery and all of the lights and other electrical components are off, you might have a parasitic battery drain (or draw). Luckily, you can usually find...
Other

Why does my car click when I Turn on the starter?

Why does my car click when I Turn on the starter? However, a broken wire between the ignition lock and the starter will in the most cases not cause a clicking noise. If the cable is broken, nothing will happen when you are turning the ignition lock. The most common problem is a faulty car battery when it comes to cars that click when turning the ignition. Why does my Mini Cooper click all the time? I don't even own a Mini. But on another car I was convinced the clicking was a duff starter motor - turned out it...
Most popular

What to do if your steering wheel is losing power?

What to do if your steering wheel is losing power? Have your electrical steering parts and components examined by a mechanic as soon as possible. If your steering wheel feels like it’s stuck in quicksand and it takes 5 times your normal strength to make a routine turn, chances are the power steering hydraulic assist is losing power. What causes power steering to stop when making a turn? Raising the engine rpm solves this problem. Air pockets in the power steering system interrupt the flow of power steering fluid, momentarily decreasing the pump pressure. An improper system flush or a...
Easy tips

How much does a 2001 Chevy Tahoe cost?

How much does a 2001 Chevy Tahoe cost? Monthly Estimate based on a 4.4% rate for 60 months, $5,675 vehicle price, $0 down payment, $0 trade-in, $0 sales tax. Greg was great. Talk to dealer. He was to return call and never did. By the time I made contact again car was sold. Read 44 more dealer reviews... Where was the 2001 Chevy Tahoe last serviced? Mileage: 210,808 miles Body Type: SUV Color: White Engine: 8 Cyl 5.3 L No accident or damage reported to CARFAX. Purchased on 05/12/01 and owned in FL until 04/13/21. Driven an estimated 13,406 miles/year....
Common questions

How does a power steering pump work with Hydro Boost?

How does a power steering pump work with Hydro Boost? The power steering pump supplies pressurized fluid for both the power steering gear and hydro-boost. Fluid flow in and out of the hydro-boost is controlled by what is known as a spool valve. Spool valves are used in a variety of hydraulic components, such as the valve body of an automatic transmission. What are the brake problems on a Hydro Boost? Thanks for the reply. All hoses from the steel lines to the calipers are new. No hoses from master cylinder to brake lines. Also changed the hoses from the...