Most popular

Why did Ford get rid of the Windstar?

Why did Ford get rid of the Windstar? Another reason for getting rid of this Windstar is a safety factor. If your Windstar is from a state where salt is used on the roads in the wintertime, these Windstars suffered from rear axle failure. The fix was either to use an epoxy to affix plates to the rear axle or for Ford to buy the vehicle. Which is better Ford Windstar V-belt or serpentine belt? The serpentine belt on the Ford Windstar has a better construction and tends to last longer than traditional V-belts. Unfortunately, newer belts normally wear out...
Easy tips

How do you fix a spring suspension?

How do you fix a spring suspension? Part 1 of 1: Replacing the suspension springsMaterials Needed. Step 1: Remove power from the vehicle. Step 2: Locate the springs and the strut connections. Step 3: Raise the vehicle. Step 4: Remove the wheel and tire. Step 5: Remove the lower control arm bolts. Step 6: Lower the control arm and remove the spring. How are coil springs held in place? The axle housing is held in place on the leaf springs by large U-bolts. Rubber bushings are used at the front and rear of the leaf spring to reduce road shock...
Other

Where is the ergr on a Ford Ranger?

Where is the ergr on a Ford Ranger? The test should be done with the fluoro liquid both hot and cold, as some EGRs seem to leak with the engine hot or cold but not both. It’s a pain in the neck, though, as the ERGR is right at the back of the engine behind the cylinder head, so it’s fiddly. What does trouble code P0300 mean on Ford Ranger? More often than not, your engines computer will be able to detect bad Coil Packs in your Ranger. There are several misfire related trouble codes. P0300 – this trouble code...
Easy tips

Why is my fuel pump not working on my Ford F150?

Why is my fuel pump not working on my Ford F150? It’s possible to have an ignition module fault which can then lead to an inoperative fuel pump. This may show up as a code for loss of PIP or something like that. It’s also possible to have an internal ECM fault which means no ground to trigger the relay. Is there no power to the fuel pump? No power to the fuel pump and the fuel relay is not getti... Q: No power to the fuel pump and the fuel relay is not getting power. My car has 190000...
Easy tips

When did the Ford Expedition smart junction box fail?

When did the Ford Expedition smart junction box fail? This repair service is for an existing Ford Expedition Smart Junction Box (SJB) for model years 2003, 2004, 2005, and 2006. A Smart Junction Box (Central Junction Box) failure commonly appears as a fuel or battery... What kind of repair can you do on a Ford Excursion? This is a repair service for the overhead compass / temperature display on many 1998-2005 Ford models, including: Explorer, Explorer Sport Trac, Expedition, Excursion, or F150, F250, F350, F450, and F550 Super Duty... This Ford Fuse Box repair service is for a failing or...
Easy tips

Why is my wood floor making popping noises?

Why is my wood floor making popping noises? The most common reason for hardwood to make a popping sound, specifically at night, is a change in humidity. The home cools during the transition from day to night and that can impact humidity levels in the home. The popping sound can be especially loud if the fit of the wood is very tight. How do you fix popping floor boards? To fix popping hardwood floors, you'll need to walk across the floor to identify the popping spot. Next, access underneath your subfloor to drive screws into the loose planks or inject...
Most popular

Why does my car stutter at 3000 RPM?

Why does my car stutter at 3000 RPM? Among the causes of cylinder misfiring are faulty spark plugs, low compression, damage or excessive wear of spark plug wires and/or coils, faulty fuel injector, clogged EGR valves or tubes, burned valves, improper ignition timing, vacuum leaks, leaking head gasket, faulty camshaft sensor, faulty crankshaft sensor. Why is it when driving the RPM gauge drops or jumps up? Somewhere the fuel drop then suddenly rpm decrease better check the complete fuel system from tank to injectors also check the rpm sensor . Was this answer helpful? This could possibly be your output...
Most popular

Why do you need a fan in the winter?

Why do you need a fan in the winter? Keep the fan near the heat source but not too close corner of the room, to help gently blow the air away from the heat source to warm the room effectively. “Using a fan in the winter helps to circulate heated air more efficiently around the room,” says Sally Fok, Ecoair co-founder and MD. How can you tell if your ceiling fan is set for winter? So, how can you tell if your ceiling fan direction is set for winter? Turn on the ceiling fan, stand directly under the fan blades...
Easy tips

What happens when a throttle is dirty?

What happens when a throttle is dirty? Too much air or too little air can make your engine run lean. When the throttle body is dirty, clogged up or malfunctioning this stops the flow of air into the engine, which not only causes problems with performance, but can cause issues with unburned fuel passing through the exhaust system. Are there any problems with the Ford Focus? Early on Ford definitely had a spotty record when it came to building reliable cars. The early Focus models were popular when they came out, but they were littered with reliability issues. 2005 included...
Common questions

What are the repair panels for a Ford Ranger?

What are the repair panels for a Ford Ranger? Raybuck offers an extensive inventory of repair panels for your Ford Ranger. They’re designed for the front, rear, passenger and driver sides of your truck! Some of our repair panels include cab corners, wheel arches, door skins, spring hanger kits, spring shackle kits and more. How do you remove the door panel on a 1995 Ford Ranger? Slip your fingers in behind and pop off the cap, then rotate it over to expose the screw in behind. This has a T20 torx screw. Then pull the window crank off the spline....