Easy tips

What is the fabric on the ceiling of a car called?

What is the fabric on the ceiling of a car called? The headliner, or headlining, is the fabric part attached to the roof of your car. It gives. the roof a nice finish, dampens noise and keeps the cold out. Over time the. headlining fabric can separate from its backing board, resulting in a so-called “sagging. How do you reattach car upholstery? Here's how to repair your car's upholstery on your own.Peel back the material. Gently peel back the loose upholstery. Scrub the exposed panel with rubbing alcohol. Tape the area above the seam. Apply the adhesive. Reattach the upholstery....
Common questions

What does a voltage regulator do on a Mercury outboard?

What does a voltage regulator do on a Mercury outboard? What Does a Voltage Regulator Do on an Outboard? The voltage regulator is strictly used to regulate the voltage of the outboard. In comparison, the rectifier is responsible to convert AC power to DC. Because of where the voltage regulator is located on the outboard ignition system, it endures a lot of abuse. How to check Mercury outboard motor stator output? With a Fluke Meter set on DC Voltage equipped with a DVA or Peak Reading Adapter, stator and pack output can be quickly checked. It takes 150+ volts supplied...
Other

How do you eject a CD from a car stereo?

How do you eject a CD from a car stereo? Press the EJECT button to ensure a disc is not already inserted. Verify the disc is inserted into the CD player properly. The disc may eject if inserted upside down. Press the RESET button on the front of the car stereo. Why does my CD player not eject a CD? The rubber roller rides on a metal axle, and over time, the rubber became loose, allowing the metal axle to spin independently of the rubber- when the CD was inserted or an attempt was made to eject it, the metal...
Other

Is it bad to drive over speed bumps?

Is it bad to drive over speed bumps? Cars with low ground clearance should be driven over speed bumps carefully and sometimes at an angle to avoid serious damage. Don’t make a habit of racing over speed bumps no matter the size of your vehicle. How big was the speed bump I hit? This thing was probably 8 ft long and 7-8 inches deep with lips that protruded out to form asphalt knives. It jolted the whole right side of the car and sounded like a small gunshot when the front wheel was forced over the end of the pothole....
Easy lifehacks

What is the powertrain on a Ford F-150?

What is the powertrain on a Ford F-150? The six powertrain options for the 2021 Ford F-150 lineup are as follows: 3.3-liter Ti-VCT V6 FFV engine – 290 HP & 265 lb-ft. 2.7-liter EcoBoost V6 engine – 325 HP & 400 lb-ft. 5.0-liter Ti-VCT V8 engine – 400 HP & 410 lb-ft. Is the Ford F-150 a power stroke truck? Ford, long the sales leader in the segment, has given the Power Stroke treatment to this F-150, and we were curious if it improves an already impressive truck. What does it mean when Ford Power Stroke does not start? Ford...
Most popular

How do you remove a power steering pump on a Ford truck?

How do you remove a power steering pump on a Ford truck? Pulley removal tool assembly. Using a long open end or adjustable wrench, fit it on the base of the pulley removal tool, with the other end resting on the frame of the truck. Use a ratchet and correct size socket for the screw on the pulley removal tool (Figure 3). Turn the ratchet clockwise to tighten and begin the removal process. How to replace power steering fluid in Ford F150? (Related Article: How to Replace Power Steering Fluid - Ford-Trucks.com) Using a flat tip screwdriver to relieve the...
Easy tips

What to do when your wheel bearing is stuck?

What to do when your wheel bearing is stuck? If the threads aren't too screwed up on the axle yet, put the castle nut back on, but backwards so you don't mushroom the end as much. Then go back and forth between beating on the puller and beating directly on the axle with your sledge. It'll take time, but has always worked for me. Why is my trailer bearing stuck on the spindle? You don't want to hit it too hard because you can damage the spindle. It is possible that the bearing has become welded to the spindle. This...
Other

Why are my lug nuts rusting?

Why are my lug nuts rusting? What would be a good product to prevent rust from reforming on the lug nuts? Well, they're rusting because they're steel and exposed to air. That means that whatever coating that may have been on there has been compromised and once that happens it's pretty much a losing battle. Is rust on lug nuts bad? Most lug nuts are chrome or nickel plated steel. Once they've been installed and removed a few time the sockets tend to chew up some of the plating, exposing the steel which then forms a bit of rust. It's...
Common questions

Why does my van have two batteries?

Why does my van have two batteries? andy63. The front one is the aux battery that runs the vehicle systems when the ignition is off... As said the two batteries are connected when the engine is running and isolated from each bother when engine is off.. A good system that ensures you can always start. What kind of battery does a Ford 350 use? With such a quality big rig, skimping on the Ford F-350 battery would be a mistake. Keep your truck in action with the top-of-the-line batteries at AutoZone. If you want the strength of your battery to...
Common questions

When did the first power stroke engine come out?

When did the first power stroke engine come out? The Power Stroke story actually starts long before the first Power Stroke engine ever saw production. In 1982, General Motors began offering the economical 6.2-litre Detroit diesel in their C/K pickup trucks. Almost immediately, Ford realised the potential for diesel trucks in the marketplace. When did Ford stop producing the 6.0 power stroke engine? The 6.0 and 6.4 Power Strokes were so disastrous for Ford that they ended its partnership with Navistar in 2010, and began producing its own diesel engines. Not only was this a huge risk for Ford, it...