Common questions

How do you know you need wipers?

How do you know you need wipers? Here are some other signs that new wiper blades are in order: Streaking or hazing on the windshield when it rains or snows. A chattering sound when your wipers are on. The blades are pulling away from the windshield at higher speeds, instead of sitting snugly against the windshield. What is turn signal wipers stalk? The left hand stalk signals and cancels turn indications when moved up or down. It honks the horn if pushed in toward the column. It flashes the high beams if pulled toward the driver, whether the headlights are...
Other

How to remove plastic door panels on Chevy Colorado?

How to remove plastic door panels on Chevy Colorado? Insert the plastic pry bar tool in between the bottom edge of the plastic door panel and the metal door frame. Firmly pull out the bottom edge of the door panel to release the plastic pop rivet fasteners. Continue pulling out the pop rivets all along the bottom and both sides of the door panel. How to remove front door panel 05-10 Chevy Cobalt? 1A Auto shows you how to remove or replace the interior door panel trim on your vehicle. You need to remove the door panel for a number...
Easy lifehacks

How does the OBD-2 diagnostic interface work?

How does the OBD-2 diagnostic interface work? If the vehicle's onboard diagnostic system detects a malfunction, a DTC corresponding to the malfunction is stored in the vehicle's computer, as well as realtime data from the sensors connected to the on-board computer. In addition, the OBD-II interface provides a means to clear the DTC's once maintenance has been completed. When was a diesel engine required to support OBD? Diesel (compression ignition) vehicles were not required to support OBD until 2004. Some pre-2001 petrol vehicles and pre-2004 diesel vehicles have a 16-pin connectors but they may not be OBD-II or EOBD compliant....
Other

Can a master cylinder have an internal leak?

Can a master cylinder have an internal leak? A master cylinder with an internal leak struggles to achieve the necessary hydraulic pressure. Instead of pushing on the calipers, the brake fluid leaks backwards around the rubber seals protecting the piston. Degraded seals often lie at the heart of this issue. Why does my brake fluid leak out of my master cylinder? In your car's brake system, a plastic reservoir supplies the master cylinder with brake fluid. If the reservoir cracks or becomes damaged, it can leak fluid or let in contamination. You will need to remove it from the master...
Easy tips

Will a performance shock work on a daily application vehicle?

Will a performance shock work on a daily application vehicle? Performance Daily Driver Shocks Most drivers shopping for performance shocks fall into this category. If you use your truck for your daily commute but also tow a trailer a few times a week or need to get down unpaved trails, or if you like to open your car up when the road allows it, these are the shocks for you. Can a car's shocks be replaced in the back? Your car may even have a combination, using shocks in the front and struts in the back. Struts can be difficult...
Common questions

When do you think about electrical and lighting?

When do you think about electrical and lighting? Usually the homeowner will walk through the framed house with the electrician and/or builder and discuss where fixtures, outlets and light switches will go. But thinking through the electrical and lighting plan well before you do the electrical walkthrough will allow you more time to consider exactly what features and outlets we want, and where. What are the requirements for an emergency lighting system? Clause 5.2.7 recommends that an emergency illumination of not less than 10% of the normal lighting (average value) is provided at the relevant point of the location of...
Most popular

Where is the PCV valve located on a 2003 Ford Taurus?

Where is the PCV valve located on a 2003 Ford Taurus? here's where it is. It's attached directly to the oil separator, underneath the lower intake manifold. It looks like a 3" x 4" x 2" black box bolted to the block. The PCV connects to it, and the PCV tube runs to the intake. Where is the knock sensor on a Chevy 6.0? In Chevy 6.0 engines the knock sensor sits underneath the intake manifold in the lifter section. The sensor is responsible for measuring engine vibrations and detecting if there are any unusual vibrations, aka if any “engine...
Common questions

What is the cost of the GMC MultiPro tailgate?

What is the cost of the GMC MultiPro tailgate? The cheapest truck that GMC offers equipped with the MultiPro tailgate is $38,195 before destination ($35,790 with destination and current discounts). For that price, you get a 2500 regular cab, long bed, 6.6-liter gasoline V-8, 2WD Sierra trim. How long has GMC Sierra 1500 been on the road? It has been on the road for 17 years, every day, 7 days a week. We have never had any major problem with it. In 2016, at 345,000 miles, we replaced engine and transmission. Today, we are pushing 420,000 miles. Everything works -...