Easy lifehacks

How do you remove EGR from an intake manifold?

How do you remove EGR from an intake manifold? Unbolt the EGR pipe from the top front of the intake manifold. Then, if your new intake manifold doesn't have EGR provisions, remove the wiring harness going to the egr assembly. You need to unbolt the egr tube from the passenger side header (2 10mm bolts), and then unbolt the 2 15mm bolts holding the EGR assembly to the passenger side head. How do you replace an upper intake gasket? Plug in the harness into the fuel injectors and coolant temperature sensor. Place new upper intake manifold gaskets into place. Put...
Easy tips

How do you bleed rear brake calipers?

How do you bleed rear brake calipers? Bleeding ProcessBegin at the corner furthest from the driver and proceed in order toward the driver. Locate the bleeder screw at the rear of the caliper body (or drum brake wheel cylinder.) Place the box-end wrench over the bleeder screw. Place one end of the clear plastic hose over the nipple of the bleeder screw. How do you change the brake pads on a Ford F-150? Lift the caliper off the brake rotor and then pull the old brake pads out of the caliper by hand. Spray the inside of the brake caliper...
Other

What causes lights to dim and then go bright?

What causes lights to dim and then go bright? The load balance changes when you turn lights or appliances on or off. That's why you may see that a light starts dim and then gets brighter. An open neutral is an unsafe situation that you need to correct as soon as possible. Who Should You Call to Repair an Open Neutral? Is the dimming on a lamp related to the driver? One interesting note is that dimming is always related to the driver, which is a separate component in most fixtures and retrofit kits. Similar to lamps, a compatibility check...
Easy tips

How do you know if your front tie rod is bad?

How do you know if your front tie rod is bad? When your tie rods go bad, the symptom you're most likely to experience first is a vibration or shaking sensation in your steering wheel. You may also hear associated clunking and rattling noises, especially when turning the vehicle at low speeds. These sounds are caused by tie rods that are starting to wear out. Can you wiggle tire side to side? If it wiggles side to side (as in the turning motion) than it has to be either the tire rod ends or the steering rack. You need to...
Easy tips

Does Ford Excursion have limited slip differential?

Does Ford Excursion have limited slip differential? We are proud to offer this remanufactured 10.5-inch Rear Differential for the 1999-2007 Ford Excursion SUVs. This rear diff is configured with a 3.73 gear ratio and Limited Slip. Is the 2004 Ford F-250 Super Duty AWD? Description: Used 2004 Ford F-250 Super Duty with AWD/4WD, Rear Bench Seats, 8ft Bed, Fold Flat Rear Seats, Extended Cab. CERTIFIED EXCELLENT - BUY WITH PEACE OF MIND - CALL FOR DETAILS!**FLEET MAINTAINED**ONE OWNER**ONLY 53K ACTUAL MILES**EXTENDED CAB** Hard to find 2004 Ford F-250 with super low miles! How big is the Super Duty F-350 Crew...
Other

How do you test an electronic injector?

How do you test an electronic injector? Voltage TestingTurn the ignition key to the "On" position. You do not need to start the engine for this test.Disconnect the electronics plug wire from the fuel injector.Turn the multimeter to "volts." Insert the black and red multimeter leads onto each side of the fuel injector electronics plug. Read the multimeter. How does the fuel injection work on a Ford Ranger? Troubleshooting the fuel-injection system in the Ford Ranger can be a daunting task. Understanding how the system functions makes this system easier to diagnose and repair. High-pressure fuel is supplied to the...
Most popular

Why are my RPMs so low while idling?

Why are my RPMs so low while idling? Typically air leaks result in poor mileage. Thanks Nick, you nailed it. After a good cleaning with throttle body cleaner the fluctuations stopped, but the RPMs were still low. I finally replaced it (Ford calls it the IAC valve, stands for idle air control valve) and it's been running like a champ ever since. Is it possible to take the engine off at 3, 000 rpm? You can take it off with a programer. But its there for a reason and its a good thing.:hy: Mine WILL rev over 3,000 RPM's -...
Most popular

Where is the ignition switch on a 2011 Ford f150?

Where is the ignition switch on a 2011 Ford f150? The ignition switch on your Ford truck is mounted on the right side of the steering column. The ignition switch has an “accessory” position that can be activated when the key is turned counterclockwise from the “off” position. How do you turn the ignition on in a F-150? Insert the key for your F-150, and turn the ignition switch to the "Run" position without starting the truck. Push a 1/8-inch drill bit into the hole beneath the ignition switch, and push upward until it depresses the ignition switch retaining pin....
Common questions

Can a Ford F-150 Super Duty be repaired?

Can a Ford F-150 Super Duty be repaired? Rust could ruin the value of your Ford F-150 or Super Duty tremendously. Here are a few steps you can take to fix rust and prevent it from happening. This article applies to the Ford F-150 (2004-2014) and the F-250, F-350 Super Duty (2005-2014). What to do if your Ford F-150 has rust on it? Regularly check for rust for instance, paint bubbles or blisters in the paint is a sign of rust, and it is time to get your car treated. Do your best to keep the interior clean as well....
Easy tips

Why is my Ford Edge running hot?

Why is my Ford Edge running hot? While there are a variety of reasons your Ford Edge is overheating, the most common 3 are a coolant leak (water pump, radiator, hose etc.), the radiator fan, or a failed thermostat. Coolant leak (water pump, radiator, hose etc.) What to do about a Ford Edge engine problem? Dealer initially replaced outer belt, but the noise was not resolved. Dealer replaced inner accessory belt and noise was eliminated. The check engine light came on several times, and after the 4th time, the engine lost power. Other mechanic shops could not diagnose or duplicare...