Easy tips

Why does oil pressure switch go bad?

Why does oil pressure switch go bad? Damage to the wiring harness, a corroded plug, or simply an unplugged connection could be the culprit. Once more, it is important to rule out actual low oil pressure by checking the dipstick and listening to your engine. How to convert an R12 compressor to a R134a? R12 to R134a Conversion steps. The first step is first to make sure that the AC system is empty. Discharge and make sure to recycle it properly. Make sure your AC compressor is in good shape, otherwise replace it. Flush your current system entirely of R12...
Easy tips

How many volts should alternator?

How many volts should alternator? A good alternator should put out between **13.5-14.5 volts. Stress test the alternator - Place a load on the alternator by turning on the headlights, the radio and the air conditioning. The voltage should remain high with these circuits on. What should the voltage be on a bat alternator? Measure the voltage across the battery and the big bat alternator terminal to alternator case. There are two things that you are looking for. The charging voltage should be between 13.9v to 14.4v. Also the voltage at the battery and the voltage at the alternator should...
Other

What causes the power window to rotate and lower?

What causes the power window to rotate and lower? Both leads may show continuity to ground, depending on the design of the switch. Pressing the switch to lower a power window, directs current to one wire and grounds the other wire. Direct current flow in this position causes the motor to rotate and lower the power window. How does a window regulator raise or lower the power window? Turning one way will lower the window and rotating in the other direction will raise the power window. Converting the rotation of the motor into vertical window motion is the task of...
Easy tips

Why would a car dealership over inflated tires?

Why would a car dealership over inflated tires? The short answer is that when they service and change your oil the tires are generally hot. The PSI in your door is for cold (car has sat overnight). If your tires are hot the pressure will be higher than cold. Thus when they fill the tires they do so to the appropriate “hot” level. What should I do if my tire pressure light is not working? Once the light blinks for three times on the dashboard, this means the TPMS is reset. After this, turn off the engine and again start...
Common questions

When to replace both calipers when just one goes bad?

When to replace both calipers when just one goes bad? This is why it is also critical to replace calipers in pairs. Doing just one is not doing the customer a favor. In fact, you can be causing a comeback to your shop when that customer says that they have a brake pull on their vehicle. Keep this in mind and replace calipers in pairs. Why is brake fluid coming out of the caliper? If you think that the brake pedal is so light and at the same time there is no brake fluid to a right front caliper/left front...
Common questions

When testing a good fuse what reading should you get?

When testing a good fuse what reading should you get? Set your ohmmeter to the lowest scale on the resistance setting. Usually, it will have Ω (Greek letter omega) for resistance. When testing a fuse, touch the end of each ohmmeter cable to the opposite ends of the fuse. A reading between 0 and 2 indicates continuity—the circuit is good/complete. What do you need to know about fuses? Visual Test of a Fuse. The first test is to do a visual check of the fuse. If the fuse has a broken or melted connector, it is blown. The picture below...
Easy tips

How much torque can a g56 handle?

How much torque can a g56 handle? Registered. From what I have read the manufacturer rates the g56 up to 600 ft lbs of torque which who knows if that's accurate or not. From personal experience though, mine is a 2015 and its fully deleted with anarchy tunes. On the 100hp tune in 5th and 6th gear if I hammer on it the clutch slips pretty good. Are there any problems with the 48RE torque converter? The 48RE torque converter is tested for leaks, lockup, concentricity, and balance, Upgrades, including billet converter cover with machined mounting pads, surpass OE requirements,...
Common questions

Where is the fuel filter on 2003 Dodge Durango?

Where is the fuel filter on 2003 Dodge Durango? The 2003 Dodge Durango fuel filter location is inside of the gas tank. Having the fuel burn optimally is crucial to maximizing Your miles per gallon. Your gas tank needs to be in the best of shape. Where is the fuel filter on a Dodge Durango? This is the first one that was actually built into the gas tank. Click to expand... The “fuel filter” in your durango is actually a strainer or sock like almost every vehicle has on the bottom of the pump module. Don’t know why dodge decided...
Easy lifehacks

What happens when you find out you Were Wrong?

What happens when you find out you Were Wrong? No one enjoys being wrong. It’s an unpleasant emotional experience for all of us. The question is how do we respond when it turns out we were wrong—when there wasn’t enough milk left for coffee, when we hit traffic and missed the flight, or when we find out the man who sat in jail for five years based on our identification was innocent all along? Why do certain people will never admit they were wrong? As a result, they come up with statements, such as, "I checked in the morning, and...
Easy lifehacks

What happens to the engine rpm when idle?

What happens to the engine rpm when idle? At idle, on an intermittent basis, the rpm repeatedly sur... While idling, my rpm will surge from about 1100 to 1700 over the time frame of a second or two then return to 1100 over that same time frame, then repeat. If I put a load on the engine by turning on the airconditioning compressor, the surging will often stop. Why does the engine surging stop at idle? If I put a load on the engine by turning on the airconditioning compressor, the surging will often stop. This is an intermittent problem...