Easy tips

How long should I wait to put water in my car?

How long should I wait to put water in my car? Once the hood is open, there's a risk of being sprayed with hot water or steam. “Your personal safety is most important,” he says. “Waiting for at least 15 minutes allows the hood, engine and leaking coolant to cool.” Widely used phrases You have to check the tranny fluid with the engine running. Pull stick and wipe clean, put back in and check the level. If low, you will have to buy a transmission funnel. It goes in the same hole that you pulled the dipstick from. If possible,...
Easy lifehacks

When do you step on the accelerator does the car start?

When do you step on the accelerator does the car start? When you step on the accelerator while starting the engine, this opens the throttle plate which allows air into the engine. This then allows the engine to start. If you leave the key in the on position for 20 seconds before you try and start the car and it starts right away let us know. What's the problem with a " rough idle "? Rough idle, bad hesitation... This problem started suddenly. Very rough idle with a repetitive cycle that is smooth for a couple of seconds then misses...
Easy tips

Who is Frank Taylor in the TV series Haunted?

Who is Frank Taylor in the TV series Haunted? After having a near-death experience, ex-cop-turned-private-eye Frank Taylor learns that he has the ability to see and communicate with restless ghosts of murdered people who ask for his See full summary » Frank sees Jess with her colleague. Is the book Haunted a satire of reality TV? The synopsis on the dustjacket describes Haunted as a satire of reality television, but according to Palahniuk, the novel is actually about "the battle for credibility" that has resulted from the ease with which one can publish through the use of modern technology. When...
Common questions

How often do you Regen a Ford Transit 3.2L?

How often do you Regen a Ford Transit 3.2L? When ford decided to combine the DPF and the Oxygen Catalyst into one small container for the 3.2l transits they were thinking of lower costs, not performance or economy, which is why you will never see this "single brick system" in any higher cost diesel vehicle. This "SBS" will fill up and needs a regen cycle every 60-130 miles. What should the engine temperature be in a Ford Transit? 220-230f is now standard operating temperatures for modern engines due to emissions and higher quality oils. Once you start exceeding 260-270f is...
Easy tips

What does P2033 mean?

What does P2033 mean? P2033 is an OBD-II generic code for the exhaust gas temperature sensor circuit high bank 1 sensor 2 to the engine control module (ECM). What is the diagnostic code for Ford check engine light? Refer to our Generic OBD II code list for definitions on all other Ford diagnostic trouble codes. P1000 OBD System Readiness Test Not Complete P1001 KOER Test Cannot Be Completed What are the trouble codes for Ford PowerStroke? P0344 CMP Sensor Circuit Intermittent P0360 Glow Plug Circuit Malfunction P0381 Glow Plug Indicator Circuit Malfunction P0460 Fuel Tank Level Indicator Circuit Malfunction P0470...
Common questions

Why does my Ford PowerStroke not start while cranking?

Why does my Ford PowerStroke not start while cranking? I cant get my 7.3 to start it cranks over r.p.ms are all guages work wait start works...etc but while cranking it makes a buzzing noise under the dash by my feet? what could be the issue. i had to charge my batteries casue they got run dead and found out one of them was bad and wouldnt take a charge. What's the minimum crank speed for a Ford PowerStroke? RPM, minimum 100 rpm cranking speed (When warm it should be over 180 rpm) 2. ICP, minimum required for starting 500...
Other

Why is the power lift gate not latching on my 2013 escape?

Why is the power lift gate not latching on my 2013 escape? I have not had an issue with the hatch closing on my 2013 Escape but what occasionally happens only in cold weather is that I will get a false signal/warning that the hatch is ajar. This occurs only in cold weather down here (infrequent). I have learned that simply re-opening and re-closing the hatch will correct the issue. Why is the power hatch on my 2017 escape not closing? Click here to learn how! Just bought a 2017 escape with a power rear hatch, when it closes it...
Easy lifehacks

How are the LRP spacers on a Land Rover?

How are the LRP spacers on a Land Rover? If the vehicle is equipped with traditional coil spring suspensions (from factory or converted), the LRP suspensions provide to rise +50mm (+2″) the vehicle. To reach the main goal of treatment against corrosion, the LRP suspension spacers, before being powder coated, are subjected to a primer painting by cataphoresis process. Why do overhead line spacers need to be installed? Overhead line spacers add reliability and protection to the conduc- tor bundle, by separating conductors preventing clashing under operating conditions. To provide this protection, it is necessary to install the correct number...
Most popular

Why did my Ford Escape have a fuel leak?

Why did my Ford Escape have a fuel leak? The contact stated that the vehicle was leaking fuel from underneath the vehicle. The contact was unaware of the exact location of the fuel leak. The contact was concerned about the safety of driving the vehicle with the fuel leak. The vehicle was not taken to be diagnosed nor repaired. Why does my 2001 Ford Escape not start? The condition can cause intermittent problems involving the Powertrain Control Module (brain) and No Starts are one symptom. 2001 Ford Escape V6 cranks, but will not start. This occurs inter'mittently during cold startup....
Easy lifehacks

How to remove a stuck CD from a navigation drive?

How to remove a stuck CD from a navigation drive? Here are some tips and tricks for removing a stuck disk from your navigation drive unit. It is recommended that you try these in the following sequence, as each progressive step becomes more complex and riskier. Put the key into the ignition and turn to position 1 or 2. Go to the nav computer and press and hold the eject button. How do you eject a CD from a nav? Go to the nav computer and press and hold the eject button. The button will flash while pressed, and you...