Easy lifehacks

Where is the radio located on a 2008 Chrysler Town and Country?

Where is the radio located on a 2008 Chrysler Town and Country? The 2008-10 Town & Country features a dash assembly that’s actually a series of interlocking pieces starting at the A-pillars. To remove the radio, you’ll need to pry those off, then gradually work your way through a series of trim panels until the radio is fully accessible. What are the optional features of a Chrysler Town and Country? Optional features, like navigation, Bluetooth® connectivity, satellite radio, a rear-view camera, and rear seat DVD entertainment pumped up the Town & Country’s entertainment quotient. As you might expect, the rear-seat...
Easy tips

Why does my Chrysler Pacifica engine not start?

Why does my Chrysler Pacifica engine not start? There are a lot of issues that can cause your Pacifica to crank, but not start. The engine needs air, fuel, and a spark in order to run. It is highly likely that if the engine is cranking, but not starting that it has thrown an OBDII code. It is definitely worth it to use an OBDII scanner to check and see if the engine has thrown any trouble codes. Can a bad alternator cause a Pacifica to not start? Battery is Charged – If the battery is charged, then it would...
Easy tips

Can my child sit in the front seat of a car in Ohio?

Can my child sit in the front seat of a car in Ohio? When Can Kids Ride In the Front Seat In Ohio? There's no law in Ohio on when kids can ride in the front seat, but many car manufacturers specify that kids should not ride in the front until age 13. How old do you have to be to ride in the front seat in Ohio? Like many states, Ohio has strict regulations on restraining children in cars. The law includes stipulations for when children can ride in the front seat of the car, although there are exceptions...
Other

Is rear main seal leak serious?

Is rear main seal leak serious? Rear main seal leaks are so dangerous because it is possible for the leak to occur at a very fast rate. Due to the location, it is subject to high oil pressure. It is also connected to the engine, which must be slick with oil to function properly. What causes the rear main seal to fail? On most modern engines, the seal’s failure is due to a condition inside the engine or a component connected to the back of the engine. Solving why the seal failed in the first place is critical to preventing...
Easy tips

Why does my right front wheel make a clunking sound?

Why does my right front wheel make a clunking sound? This sound happens about 50% of the time on turns. Note that we recently (about 10 days ago) had the ball joint and struts replaced on the LEFT front wheel - could that have done something to the balance of the axle, etc. that is making this sound happen on the right front wheel? Why does my GMC Terrain make a clunking noise? When a tie rod end is worn or loose, they may produce a clunking noise. Worn tie rod ends may also cause more play in the steering...
Easy lifehacks

What years did they make the S10?

What years did they make the S10? Building off the earlier Chevy-dubbed LUV, “light utility vehicles,” produced between 1972 and 1982, Chevy released the first S10 in 1982. Affordable, durable, and dependable, the S10 pickup trucks sold from 1982 to 2003 and came in two-wheel drive with either four-cylinder or V6 engines. When did the Chevrolet's 10 go out of production? The S-Series ended production in Brazil in 2012, being replaced by the Chevrolet Colorado, but still with the name S-10. The first compact truck from the big three automakers was the rebadged Isuzu KB sold since 1972 as the...
Other

Can a 1987-92 GM tuned port injection system be used?

Can a 1987-92 GM tuned port injection system be used? When using the 1987-92 F-Body injection systems, the two center bolts on each side will not fit the earlier engines without being re-drilled for the proper angle to match the early heads. Also 1985-88 manifold plenums have a cold-start passage and ninth injector for start-up. What kind of head does a 1985 Corvette have? Also, the earlier F-bodies (1985 and 1986 305-cu.in.) and the Corvettes using cast-iron heads have the same bolt pattern as the earlier small-block Chevys from the 1950s through the 1980s. When did the Chevrolet 305 V8...
Easy tips

What kind of engine stalls when you accelerate?

What kind of engine stalls when you accelerate? Engine stalls when accelerating ford stalling v8-5.0l f-1... Replaced carb, engine starts good, idles good, and revs fine when in park. What does it mean when your car is stalling? The stalling of an engine happens for a few different reasons, but it’s important to clarify what engine stalling is. It’s when the engine completely shuts off for no obvious reason. It does not include when an engine feels like it’s going to shut off but doesn’t - that’s called an engine stumble, usually due to an engine misfire. Why does my...
Other

How is the valve position of the EGR determined?

How is the valve position of the EGR determined? In closed loop operation, an estimate of the relative air-fuel ratio (λ) based on signals from a mass air flow sensor, intake manifold pressure and temperature and the fuel injection quantity was used to control the EGR valve position. What kind of sensors are needed for EGR control? EGR valve and variable geometry turbine vane position sensors are also important system signals that can be required for EGR control. EGR valve position sensors can be based on a variety of principles including potentiometers and Hall Effect sensors. Gas Composition Sensors. Is...
Easy lifehacks

How to reset the warning light gas cap that is loose?

How to reset the warning light gas cap that is loose? Open the door. Grasp the gas cap handle and twist it counterclockwise to unscrew it. Remove it. Replace the gas cap. Removing and replacing it ensures the thread seals properly, in case it wasn't before. Turn the gas cap clockwise to tighten it. Continue turning until you hear it click three times. This ensures it's seating properly. What to do if your gas cap won't tighten? You can either tighten the cap and wait for the system to reset itself when it determines the problem is fixed, or you...