What causes brakes to lock up on motorcycle? You need to leave some room in the reservoir for the brake fluid to expand when it heats up, otherwise it will expand into the calipers and push the pistons out. Fill to just below the max line. Or you just have air or water in your lines that is expanding with heat and causing the lock up. Can motorcycle brakes lock up? Although this might be not be as common, but if the front brake lever has insufficient lever movement for free play, it could cause your motorcycle front brakes to...

Why do my eyes have a hard time adjusting to light? When the surface of the eye is not well lubricated, the cells on the surface of the cornea die and sensitive corneal nerves are exposed. This is a common and frequently unrecognized cause of light sensitivity. Using over-the-counter lubricant eyedrops may improve this problem considerably. What happens if you look at bright light too long? In short, yes, staring at bright lights can damage your eyes. When the retina's light-sensing cells become over-stimulated from looking at a bright light, they release massive amounts of signaling chemicals, injuring the back...

How do you install a torque converter on a transmission? When ready to insert on the input shaft, turn the converter vertically with the bolt holes facing towards you. Hold the torque converter by its sides at 3 and 9 o'clock and slide onto the input shaft while slowly rotating it back and forth, as in Step 2, until you hear the first “clunk.” Can a torque converter be improperly installed? The torque converter is not properly seated yet and this is where the mistake of improperly installing it happens. Continue gently pushing on the torque converter while slowly rotating...

How do you reseat piston rings? Yank the plug on the bad cylinder, squirt in some kind of penetrating oil like PB Blaster and let it sit for a couple days with with occasional engine rotation by hand and re-sprays. Then put the plug back in. Maybe try a recessed tip plug also for that cylinder. Can you unstick a piston ring? Here's how I personally do it; Pour enough selected oil down spark plug holes until your're confident that the entire piston is covered. Let oil sit for 24-48 hours while occasionally turning engine slightly by hand. The oil...