Common questions

What kind of sensor is the governor pressure transducer?

What kind of sensor is the governor pressure transducer? The governor pressure transducer is actually two sensors in one; the trans- ducer itself, and a transmission oil tem- perature sensor (figure 4). The tempera- ture sensor is a pull-down thermistor: It receives a 5-volt signal, which grounds through the sensor. The transducer is a potentiometer; that is, it’s a three-wire sensor. What should the pressure be on the Governor gauge? Governor Gauge Pressure (Measured Pressure on your Gauge) All three pressures should be equal, and should rise about 1 PSI per MPH, up to about 40 MPH. If governor pres-...
Easy tips

What happens when you shift into reverse on a car?

What happens when you shift into reverse on a car? Shifting into “Drive” or “Reverse” can cause a sudden, jarring movement on the transmission which increases the stress on the transmission bands and clutch plates. Not only can this sudden movement jolt the entire transmission, but it can also cause damage to other drive line components. Is it OK to downshift in an automatic transmission? This practice is not acceptable in automatic transmissions because a forced downshift at high-engine RPMs can result in excessive transmission wear, specifically to the clutch friction plates and the transmission bands. When is it a...
Easy tips

Is the Dodge Ram 3500 still for sale?

Is the Dodge Ram 3500 still for sale? Dealer said vehicle was sold but has a vehicle with same mileage and same truck for 5000.00 more. Way to suspicious to me. And using a stock photo. Not a quality reputable company in my opinion. What kind of engine does a Dodge 3500 have? Dodge 3500 series with V-10 engine , engine runs good. Complete Sprinter van, body rough , engine needs to be tested. Automatic transmission, drivers walk thru cage. 5.9, 6 SPD , FLAT BED. When did Dodge start using diesel in pickup trucks? This was not the first...
Easy tips

What was the fourth generation of Dodge Colt?

What was the fourth generation of Dodge Colt? Fourth generation. From late-1978 for model year 1979, the Dodge Colt and Plymouth Champ nameplates were applied to the front-wheel-drive Mitsubishi Mirage imports into North America. The Colt and Champ (Plymouth Colt after 1982) was a 3-door hatchback, and came in Deluxe or Custom equipment levels. When did Dodge stop making the Dodge Colt? The Dodge Colt were subcompact cars manufactured by Mitsubishi Motors and marketed by Dodge for model years 1971-1994 as captive imports. How many horsepower does a Dodge Colt have? Standard transmission was a four-speed manual, with a three-speed...
Easy lifehacks

When does an ABS brake warning light come on?

When does an ABS brake warning light come on? An ABS brake warning light coming on is annoying. It becomes frustration when you can't find the source of the problem. As with any problem that can not be easily diagnosed always start with the simple things first. This applies to most models from 1985 to 1995 with ABS brakes. Is there a problem with the ABS brake? However, a number of problems can take place in the ABS. According to Garatos.com, the vehicle will show an illuminating ABS light under the dashboard, indicating there’s a problem. You don’t need to...
Other

How do you remove a pulley belt from a car?

How do you remove a pulley belt from a car? With the tension relieved from the belt, pull it off of the pulley that has been placing tension on it, then remove it from the around the rest of the pulleys on the engine. If the belt is severely damaged, be sure to remove any parts that may have come off of it as well. Compare the new belt to the old one. How do you remove a pulley from a lawn mower? Lift the middle sheave slightly so the lawn mower belt will clear the belt guide, and slip...
Easy tips

What tools do I need to change my starter?

What tools do I need to change my starter? Tools needed to replace a starter:Sockets and wrenches.Screwdriver.Pliers.Battery terminal puller.Drive-on ramps, jack or jackstands. How do you replace a starter on a Dodge Ram? Mount the 8mm and 13mm nuts back to the starter. Then tighten down the wire leads. Line the starter bolts up with the transmission. Slide the two 16mm starter bolts back in place. Start with the top bolt and hand tighten it. Then slide in the lower bolt. Torque down the upper and lower starter mounting bolts. How to remove a car starter from the engine? Remove...
Common questions

Does 2007 Dodge Caliber have Turbo?

Does 2007 Dodge Caliber have Turbo? The core of the '07 Caliber SRT4, like its predecessor, is a 2.4-liter turbocharged and intercooled four, transversely mounted and driving the front wheels. It has a production facility in Dundee, Michigan, and the initial DaimlerChrysler yield is a three-engine family - 1.8, 2.0, and 2.4 liters. Where can I get 2007 Dodge Caliber parts? OEM Dodge parts are manufactured by Dodge to maximize the performance of Dodge Caliber vehicles and provide the certainty that the repair will be done right the first time. Parts that fit. Parts that perform. OEM Dodge Caliber Parts....
Easy tips

What kind of swap system does Dakota Durango use?

What kind of swap system does Dakota Durango use? Fully Engineered Swap System that Provides Optimized Component Clearances and Drivetrain/U-Joint Operation Angles & 1 7/8" Swap Headers Welded Steel Construction w/ Black Painted Finish for Durability & Corrosion Resistance Can a 2006 Dodge Dakota Pull A trailer? The 2006 Dakota has specific capacities for pulling a trailer. I'd look at the V-8 Dakota model specs and see what Chrysler had in mind for loads on this vehicle. Tow capacity includes brakes, powertrain, suspension, wheelbase length, track width and frame stamina. What kind of engine does a Dakota Durango use? Transmission...
Common questions

What causes check engine light flash?

What causes check engine light flash? A blinking check engine light will pop up on your dashboard display when your engine misfires. This means that the engine is dumping unburned fuel into your vehicle's exhaust system. This is a serious problem because it can rapidly raise the temperature of the catalytic converter. What does the Check Engine light on a Dodge Dakota mean? When you start your Dakota, the ECM will do a self diagnostic cycle. If it fails the cycle, you’ll get a check engine light. This trouble code will tell you what part of the diagnostic that it...