Easy tips

Why is my emergency brake light not coming on?

Why is my emergency brake light not coming on? The dash light not illuminating when the brake is applied is very likely a wiring issue. When the brake is applied, the power should pass through the switch and onto the bulb illuminating it. Start by checking the parking brake switch for available voltage. Then apply the brake and check for voltage after the switch. When does the emergency brake light stay on? The emergency or parking brake is a mechanical braking system, mainly used when parking cars on slopes. However, as you may have noticed, sometimes, its indicator light stays...
Most popular

What is the best year of the 7.3 PowerStroke?

What is the best year of the 7.3 PowerStroke? the best year is 2000(.) What kind of engine is a Ford 7.3L? The Ford 7.3L Power Stroke diesel is a legendary engine. It’s well known for its reliable history and solid performance from the factory considering the era it was released. However, there are many ways to get more performance out of the 7.3 turbodiesel Power Stroke engine. Why does my 2000 F350 have no power? 2000 F350 7.3 stalling, rough idle, no power, and hard start. - YouTube If playback doesn't begin shortly, try restarting your device. Videos you...
Most popular

How do I make my trailer brakes work?

How do I make my trailer brakes work? You will need to connect the red wire from the P2 brake controller to the cold side of the stop light switch. Use a circuit tester, item # 40376 if needed, and find the wire at the brake switch that has power only when the brake pedal is pressed. Connect the red wire to this circuit. How does the brake system on an ATV work? The brake system consists of these basic components that all work together: Hand Lever The rider pulls or squeezes the lever against the handlebar to operate the...
Easy lifehacks

Why is the fuel tank on my Ford truck delaminating?

Why is the fuel tank on my Ford truck delaminating? Without remedy, this issue could cause every piece of the fuel system in your truck to fail. The cause of the delamination has been debated to an extent. Ford believes the problem is caused by two specific variants of diesel fuel. What kind of fuel tank does a Ford F-350 have? We researched the issue and explored some FAQs to help you understand the situation and why you should consider a non-metal solution. Owners of 1999-2010 Ford F-series diesel pickups (F-250, F-350, F-450, F-550) and E-series diesel vans have experienced...
Easy lifehacks

Does changing caster change camber?

Does changing caster change camber? If Caster is 0 Deg, then Camber does not change when you steer the tires from right to left. But, Camber changes when the tires move to the left or right, anytime Caster has a value greater than 0. The higher the value, either + or -, the more Camber will change as you steer the tires away from Toe in Spec. Position. Do ball joints affect caster? The caster angle is affected by the position of the lower ball joint and the upper ball joint or strut depending on the type of suspension. Consequently,...
Easy lifehacks

What would happen if you put a thermostat in backwards?

What would happen if you put a thermostat in backwards? If you installed the thermostat backwards, it would probably not open up enough to allow coolant to flow, and the temp gauge would shoot up into the far right range, the engine would overheat, etc. Install the new thermostat so the copper heat sensing element is toward the engine. Is it possible to install thermostat backwards? Answer: A thermostat installed backward will cause the engine to overheat quickly, similar to a thermostat being “stuck closed.” Therefore, always double check that the thermostat is installed in the correct direction, and if...
Easy lifehacks

What kind of car is a 2004 Ford Ranger?

What kind of car is a 2004 Ford Ranger? 2004 ford ranger 4000 super cab xlt 4x2 pick up single cab make: ford ranger 4000 v6 supercab xlt mileage: 287000 km year: 2004 condition: used region... Ford ranger 2.2 single cab, manual,2014 model, r120000, 90000km,,air condition... Are there any problems with the new Ford Ranger? Common complaints from reviewers and consumers on the new models include a stiff ride and lackluster materials used in the interior, which to some appear dated. If you’re in a market for an older Ranger, here are some issues that you need to know about....
Common questions

Where is the OBD port on a 2004 Ford Focus?

Where is the OBD port on a 2004 Ford Focus? OBD connector location for Ford Focus (1998 - 2004)The diagnostics port is under the steering wheel in the fuses box.Remover the cover of the fuses box.You can see the OBD plug near the fuses. Where is the OBD2 port on a Ford F150? OBD2 port Ford F150 (2004 - 2008) - Find your plug ! Where is my OBD2 port ? All vehicles are equipped with an OBD port to which you can connect your klavkarr diagnostic case. Sometimes, the most difficult thing is to find this port! What is...
Other

How much does a 2010 Ford Escape weigh?

How much does a 2010 Ford Escape weigh? Need MPG information on the 2010 Ford Escape? Visit Cars.com and get the latest information, as well as detailed specs and features. Curb weight: 3,268 lbs. Front curb weight: 1,895 lbs ... When did the Ford Escape come out in the US? Editor’s note: This review was written in October 2008 about the 2009 Ford Escape. Little of substance has changed with this year’s model. To see what’s new for 2010, click here, or check out a side-by-side comparison of the two model years. Is the Ford Escape a good car to...
Easy lifehacks

What is Red RTV silicone used for?

What is Red RTV silicone used for? CRC Red RTV (Room Temperature Vulcanizing) Silicone Adhesive is the simple way to seal, protect, bond, insulate and waterproof. Superb for forming instant, custom-shaped gaskets, Red RTV Silicone adheres to most materials used in the industrial, electrical, metalworking and construction industries. What does RTV stand for in RTV silicone? room temperature vulcanizing RTV stands for room temperature vulcanizing. RTV silicone begins to cure immediately upon being exposed to air, as opposed to the curing agents in water-based sealants (for example, latex). It lends itself well to working as a sealer because it is...