Most popular

Why is the auto start stop not working on my Ford Ranger?

Why is the auto start stop not working on my Ford Ranger? Auto start stop will not work unless the following conditions are met: The auto start stop button is not pressed / illuminated. The auto start stop button is located on the centre console. The Ford Ranger must exceed an initial speed of 3 mph (5 km/h) after the engine has been started for the first time. The vehicle has stopped. Are there any problems with the Ford Ranger? Ford Ranger owners have reported 11 problems related to engine shut off without warning (under the engine and engine cooling...
Other

Where is the fuel filter on 6.0 Powerstroke?

Where is the fuel filter on 6.0 Powerstroke? The 6.0L and 6.4L Power Stroke is equipped with two fuel filter elements. The larger, primary fuel filter is located inside of the left hand frame rail, below the driver's side floorboard, with the fuel pump. Is the fuel filter on a Ford F-250 Super Duty? This article applies to the Ford F-250 and F-350 Super Duty (2005-2014). A fuel filter is an essential component for every vehicle. It was designed specifically to keep clean fuel funneling through the system, therefore enhancing gas economy and overall performance. What happens if this essential...
Easy lifehacks

How long does it take to replace lowering springs?

How long does it take to replace lowering springs? takes about 4-6 hours on the parking lot and 2-3 hours on the lift. How do you replace lowering springs? Jack up the rear of the car and put it on car stands.Remove the rear wheels.Remove the shock nuts and bolts. (You can locate them by referring to the owner's manual.) Remove the springs.Install the new lowering springs.Replace the shock nuts and bolts.Replace the rear tires [source: Do It Yourself]. Do new springs need to settle? “Springs don't settle but ride height may change”. Your ride height will probably drop slightly...
Easy lifehacks

How can you tell if a fuel pump relay switch is bad?

How can you tell if a fuel pump relay switch is bad? Here are the symptoms of a bad or failing fuel pump relayEngine stalls. One of the first symptoms of an issue with the fuel pump relay is an engine that suddenly stalls. Engine does not start. Another symptom of a faulty fuel pump relay is an engine that does not start. No noise from the fuel pump. Why is the fuel pump and relay not working? The ignition circuit, which includes the ignition switch, controls power to many components, including the fuel pump and relay. If there is...
Other

How do you remove the center armrest on a 1996 Ford Ranger?

How do you remove the center armrest on a 1996 Ford Ranger? Expect the process of installing a new armrest to take about 20 minutes.Grasp the adjustment bar underneath the front driver side seat. Push the seat all the way forward. Push the armrest into the "up" position. Unzip the armrest's fabric. Lift the armrest up to remove it from the mount. What is the center console on a Ford Ranger? Ford Rangers equipped with separate front bucket seats have a center console. The console has an armrest that doubles as a storage compartment, as well as a cup holder...
Other

How many quarts of oil does a 351M take?

How many quarts of oil does a 351M take? 6 quarts is the standard fill. Drain, change filter, and pour 6 quarts in. Will a 351C intake fit a 400? Contrary to popular belief it is possible to use a 351C manifold on a 400 or 351M, despite the wider deck. When did the Ford 351W engine come out? So, when what we know of as the 351W was introduced in 1970 Ford had a dilemma as they already had another 351 cubic inch engine - what we know of now as the 351C. How to swap an I6 engine...
Most popular

What can you put in a gas tank to make it stop running?

What can you put in a gas tank to make it stop running? If you are just mischievous and does not really want to destroy the engine, use sugar or any other sweet, sticky liquid. Sugar in a gas tank is an urban legend and it will clog up the fuel filter, just like other sticky sweet liquids such as honey, molasses, waffle syrup, pancake syrup, and similar things. What does putting wd40 in your gas tank do? WD-40 is a lubricant that has a number of uses, including lubrication, cleaning and rust prevention. Some automotive enthusiasts also advocate putting...
Easy lifehacks

How many gallons is a 66 Mustang gas tank?

How many gallons is a 66 Mustang gas tank? 16-gallon 3. This is the 1965-68 Mustang's standard 16-gallon fuel tank with its flat-top construction. How many gallons does a 2020 Mustang hold? The fuel tank capacity of a 2020 Ford Mustang is 15.5 gallons. How big is the fuel tank on a Mustang GT? Mustang Mustang GT Engine 3.8L SFI 4.6L SFI (2v) Fuel Unleaded Fuel Only- Octane 87 Fuel Tank Capacity 15.4 Gallons (58.3 Liters) Tire Size See tire pressure decal on interior of glove compartment door Tire Pressure See tire pressure decal on interior of glove compartment door...
Easy tips

Where do sunroofs drain?

Where do sunroofs drain? Water Drain Tubes These tubes are generally located at the front and rear corners of the pan assembly of the sunroof/moonroof, travel down the interior of your vehicle and typically drain onto the ground. Unfortunately, these tubes can become clogged with debris overtime. What's the best way to drain a sunroof? Feed the wire or cord in until it comes out the other side if you have a viewable drain exit. After that, remove the wire or cord. Now test using a bottle of water, gradually drain the water around the sunroof drain, do not excessively...
Easy lifehacks

Why is my key not turning in ignition?

Why is my key not turning in ignition? The three main reasons why an ignition key will not turn include: problems with related components, issues with the key itself, and ignition lock cylinder problems. Tip: Always make sure your parking brake is on to keep the vehicle secure when following these steps. How do I get a replacement ignition key? Take your new key to a factory dealer, preferably one who sells your make and model. Tell them you lost your ignition keys and need a replacement. The dealer can cut a new key and have it programmed on-site to...