Easy lifehacks

When do you need to replace the brake light switch?

When do you need to replace the brake light switch? If the brake lights either stay on when they shouldn't or do not turn on at all, you may have to replace the brake light switch. The brake light switch is the electrical switch that is responsible for activating the brake lights. When the pedal is pressed, the brake light switch makes contact, and the the brake lights are illuminated. What to do if your brake light is not working? Step 3: Check the brake lights again to verify they are working properly. If you replaced the bulb, this may...
Easy tips

How do you adjust the emergency brake on a 2015 Ford f150?

How do you adjust the emergency brake on a 2015 Ford f150? Turn the adjustment star sits under the cap with the flat-head screwdriver. Turning it clockwise will tighten the emergency brakes and turning it counterclockwise will loosen the emergency brakes. Are there any problems with the parking brake on the Ford F-150? Ford F-150 owners have reported 36 problems related to parking brake (under the parking brake category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford F-150 based on all problems reported for the F-150. What to do...
Other

What happens if you pull more than towing capacity?

What happens if you pull more than towing capacity? When you ask your truck to pull more than it was meant to -- exceeding its towing capacity -- a number of things start to happen: The brakes begin to fade, the added weight contributes to tire failure, and the extra work required of your engine causes it to overheat, which, in turn, overloads the drivetrain and ... Can you increase your towing capacity? To help your truck pull a heavier load, you'll have to upgrade its performance. Adding a better exhaust system is one way you can do this. An...
Common questions

What happens if you hold the brake and accelerator at the same time?

What happens if you hold the brake and accelerator at the same time? When you press the brake and accelerator together, the torque converter allows slippage to a certain extent and doesn't let the engine rev higher than a certain RPM and when the brake is released, the car bolts off. When you take your foot off the brake, the clutch is simultaneously released so the car can accelerate. What causes a car to accelerate even when you brake? A stuck throttle body will cause the car to accelerate even when you brake. Unintended acceleration may also occur when the...
Easy tips

When to replace solenoid on Ford Ranger starter?

When to replace solenoid on Ford Ranger starter? Have a helper turn the switch to the start position while the voltage is checked. If there is 12 volts in the first step and there is 12 volts when the key is in the start position, the solenoid or the starter is bad. On a starter with a solenoid attached, the whole starter gets replaced. Where is the remote starter on a Ford Ranger? The remote starter solenoid is located on the passenger-side fenderwell. This means that a small-sized starter can fit in tighter locations. It also allows for a cheaper...
Common questions

What causes fuse 47 to keep blowing out?

What causes fuse 47 to keep blowing out? Fuse 47 keep blowing and discovered it was the bank 1 upstream O2 sensor that was causing the fuse to blow causing all types of codes. I replaced … read more What's the meaning of fuse blown ( 42 )? What is meant by Fuse Blown (42) - The internal fuse of the battery is no longer working, there's no option to replace that, hence the entire battery will need to be replaced. 2. Where is the fuse located? Is the fuse box still in the House? Most people nowadays have had...
Easy lifehacks

Why does my F-250 cab door not open?

Why does my F-250 cab door not open? For starters, remove the door panels to look for possible issues. Remember, the cables go bad often, and the plastic pieces that hold the cables are known to break so be very careful when removing the panel - remove all the screws, slightly pull upwards, and the panel comes right off. How do you open the back hatch on a 2005 Ford Freestar? Go inside and remove the plastic 2" square plastic cover. By pushing on the lever inside this area, the latch will release. Push on the door at the same...
Other

Why did my Focus ZX3 blow the motor?

Why did my Focus ZX3 blow the motor? I have an 03 focus zx3, I blew the motor because whoever put my K&N in they ran in straight down with no hydro shield so when it flooded, my filter sucked water all in my motor and completely shut down in the turning lane. My problem is I could only find an 01 motor which hooks up correctly but I now have no fire. How can I tell what engine is under my focus? Some Focus owners are having trouble identifying their engines. When troubleshooting problems and shopping for aftermarket parts,...
Easy lifehacks

How do you change a power steering pump on a 2002 Ford Explorer?

How do you change a power steering pump on a 2002 Ford Explorer? Installing the New PumpPosition the new power steering pump in the engine. Install a new O-ring seal on the pressure line, using the O-ring tool.Reconnect the pressure line to the pump. Reattach the clamp and the return hose to the pump.Reinstall the pulley and the engine drive belt and tighten the bolts. How do you remove a power steering pump on a Ford truck? Pulley removal tool assembly. Using a long open end or adjustable wrench, fit it on the base of the pulley removal tool, with...
Common questions

What kind of reservoir does a hydraulic pump use?

What kind of reservoir does a hydraulic pump use? The L-shaped reservoir configuration incorporates many of the same features as the overhead style. The L-shaped reservoir is a tall, narrow rectangular tank with the pump/motor assembly mounted beside the tank on a common base frame. This arrangement provides full access to the hydraulic pump and electric motor for service. Where is the hydraulic pump located in a tank? The electric motor is mounted above the tank cover and the hydraulic pump is mounted below the cover, inside the reservoir. This arrangement allows for the overall space requirements to be reduced....