Common questions

What motor is in a GMC TopKick?

What motor is in a GMC TopKick? The standard engine on the GMC TopKick lineup is the Vortec 8100 8.1L gasoline V-8. It delivers 325 horsepower (242 kw) at 4000 rpm and 450 lb. -ft. (610 Nm) of torque at 2800 rpm. What is TopKick truck? The Chevrolet Kodiak and GMC TopKick are a range of medium duty trucks that were produced by the Chevrolet and GMC divisions of General Motors from 1980 to 2009. Introduced as a variant of the medium-duty C/K truck line, three generations were produced. What kind of engine does a GMC TopKick dump truck have?...
Easy lifehacks

Why do I hear a loud pop under my car?

Why do I hear a loud pop under my car? If you suddenly hear a loud pop or bang in the engine area, pull over to the side of the road and check it out. Be on the lookout for smoke or fire, two things you should never see under the hood. Occasionally, especially in older vehicles, an engine backfire can actually reverberate through the air intake and blow a hole in your plastic air box. How to find out why my engine is making popping noises? 1 Check for engine codes that may indicate the problem. 2 Run a...
Common questions

What causes a car to get stuck in Park?

What causes a car to get stuck in Park? 4) Malfunctioning Ignition Switch. A less common cause for a shifter being stuck in park is a badly worn or faulty ignition switch. What happens here is that the ignition switch, (even after being turned to the “ON” position), does not send a signal to the shift interlock solenoid indicating that the ignition is ON. What do you do when your shifter is stuck in Park? By law, all 2010 and newer vehicles are equipped with brake-shift interlock. 1) Set the emergency brake. 2) Insert key into the ignition and turn...
Common questions

Where is the drain line for the evaporator located?

Where is the drain line for the evaporator located? The drain plug for the evaporator is clogged! You need to flush out the drain plug. It comes out of the firewall opposite the AC system. It you get under the truck on the passenger side and look up at the firewall you will see a black rubber tube about 6 -8 inches long comeing out of the bottom of the firewall near the passenger side frame. Where is the AC drain line located in a truck? It you get under the truck on the passenger side and look up at...
Easy lifehacks

When to turn off StabiliTrak and traction control?

When to turn off StabiliTrak and traction control? Stabilitrak and traction control needs Servicing with the message of reduced engine power have to turn off and restart engine to get it to full power but message reappears after a few minutes & engine light is on What does the Service StabiliTrak warning light mean? There's an issue in many GM vehicles where the Service StabiliTrak warning light will turn on and off. Not only does this mean the stability control system isn't working, but some owners say it comes along with reduced engine power and a jerky transmission. Dece What...
Other

Is the Chevy Colorado 5 cylinder a good truck?

Is the Chevy Colorado 5 cylinder a good truck? All trucks willl have their good and bad points. The 5 cyl got about 28 mpg around town and over 30 on the highway. It was quick when I needed it to be. I wasn't real crazy about the drive by wire system. I traded the 5 cyl Colorado at 20K for a used 2001 Dakota with a V6 and 5 speed. What are the problems with a 2007 Colorado? 1 Engine Turns Over, Won't Start 2007 Colorado Average Cost to Fix: $400 Average Mileage: 63,000 mi 2 Blower Motor Not...
Easy lifehacks

What are the signs of a bad Shift Solenoid?

What are the signs of a bad Shift Solenoid? One of the first symptoms of a bad or failing downshift solenoid is erratic shifting. If the downshift solenoid has any issues, it may cause the vehicle to behave erratically when downshifting. A bad or failing solenoid may cause the vehicle to experience hard or erratic shifting when slowing down or coming to a stop. Can a car shift gears without a downshift solenoid? Downshift solenoids are an important transmission component, and without them, the vehicle will not be able to shift gears properly, sometimes even to the point of rendering...
Most popular

How do I program a new key for my truck?

How do I program a new key for my truck? Programming a Single KeyInsert the key into the ignition, and turn it to the on position. Leave the key in this position for 10 minutes and 30 seconds, and then turn it off.Turn the key back on, and wait for additional 10 minutes and 30 seconds before turning it off again.Repeat the process for a third time. Can a car lock and unlock but not start? Remote Locks and Unlocks Doors but WILL NOT START?! Hey guys, my car will lock and unlock the doors and the trunk but for...
Easy tips

Why does my car not run when I press the gas pedal?

Why does my car not run when I press the gas pedal? As the throttle is applied and more fuel is requested, the fuel pump increases its pressure to keep up with the demands of the engine. Due to these facts, problems with the fuel pump can cause the engine to not run or to stumble as the gas pedal is applied. What causes a car to stumble when applying the gas? Due to these facts, problems with the fuel pump can cause the engine to not run or to stumble as the gas pedal is applied. Typically hesitation or...
Other

What kind of engine does a 1988 GMC Jimmie have?

What kind of engine does a 1988 GMC Jimmie have? For Sale by owner! 1988 GMC Jimmy K5 "Blazer" Rare find 52,000 original miles~ Fuel injected 350 V-8 with overdrive automatic t... Brand new 350 engine, new 208 transfer case, 700 r4 transmission, runs and drives great, new steel cowl induction hood. Over al… more How to repair a 1988 GM full size truck? Access our free Vacuum Diagrams Repair Guide for GM Full-Size Trucks 1988-1998 through AutoZone Rewards. These diagrams include: Fig. 1: 1988-89 (VIN Z) C/K series with 4.3L Is there a GMC Jimmy 350 Trans for sale?...