Easy lifehacks

Can you put gas in a Chevy Impala?

Can you put gas in a Chevy Impala? I have 2004 Chevy impala check engine,change oil light, low fuel light stays on,my gas needle doesn't work and it hard to put gas in the tank or where. I am at on gas,it a pain at the pump to put gas in my car. Any solution to this problems anyone. I looking for answers too 12 people found this helpful. Is there a problem with my Chevy Impala? Share it! The 2006-2011 Chevrolet Impala has known issues with the EVAP system, a part of your emission control system. The EVAP canister...
Most popular

How many miles does a 2002 Chevy Silverado drive?

How many miles does a 2002 Chevy Silverado drive? 1st owner drove an estimated 0 miles/year • 2nd owner drove an estimated 0 miles/year • 3rd owner drove an estimated 3,549 miles/year • 4th owner drove an estimated 6,741 miles/year. Where did the 2002 Chevy Silverado 1500 come from? 1st owner purchased on 02/15/02 and owned in PA until 03/20/16 • 2nd owner purchased on 04/02/16 and owned in PA until 07/20/20 • 3rd owner purchased on 10/14/20 and owned in OH until 04/16/21. 1st owner drove an estimated 7,018 miles/year • 2nd owner drove an estimated 6,120 miles/year •...
Common questions

How long does it take for an evaporation sensor to reset?

How long does it take for an evaporation sensor to reset? The test has been rejected once. I have an Autotap and have been reading the emmission status through the ODB port. It says the EVAP & Seconday AIr System monitors are not ready. A complete driving cycle will perform diagnostics on all monitored systems and can usually be completed in less than fifteen minutes. How do you troubleshoot a P0420? What repairs can fix the P0420 code?Replace muffler or repair leaks in the muffler.Replace exhaust manifold or repair leaks in the exhaust manifold.Replace exhaust pipe or repair exhaust pipe...
Other

What are the tail lights for a Chevy Tahoe?

What are the tail lights for a Chevy Tahoe? YUANZHENG Full LED Tail Lights Assembly for [GMC Yukon, Chevrolet Tahoe Suburban 3rd Gen SUV 2007-2014 (NO Need Bulbs)] Rear Tail Lamps with Amber Turn Signal, YAB-KLD-0156B (Smoked) 4.6 out of 5 stars92 $439.99$439.99 Get it as soon as Fri, Jun 18 FREE Shipping by Amazon Can a burnt out tail light be a safety issue? With a powerful V8 engine and 8,600 pounds of towing capacity, your Chevrolet Tahoe tackles the big jobs and comes back for more. But when you're hauling a lot of cargo, a burnt-out tail light...
Easy tips

How do you make my lifters stop ticking?

How do you make my lifters stop ticking? Lifter tick can happen due to dirt in your engine oil, low engine oil levels, improper lifter spacing, or overall faulty lifters. You can get rid of the lifter ticking sound by changing the engine oil, clean the lifter with oil additives, adjust the lifter spacing, and in rare cases replace the entire lifter. Why does my lifter make a clicking sound? A clogged engine oil filter can cause an engine clicking sound. Therefore, to keep your engine and lifter live longer, consider changing the engine oil filter regularly. In some cases,...
Easy lifehacks

What do I need to do to replace my fuel pump?

What do I need to do to replace my fuel pump? Disconnect the negative battery cable. Disconnect the fuel tank hose at the fuel pump and plug the hose with a bolt or wooden dowel to keep any fuel from flowing out. Also, disconnect the vapor-return hose if the vehicle is equipped with one. Be sure to wipe up any gas that spills. How to install a new fuel pump relay? 1 Install relay. Install the relay into the fuse box the same way the old relay was removed. 2 Put on the fuse box cover. Snap it into place....
Easy lifehacks

How is ignition timing set on a 94 Chevy Silverado?

How is ignition timing set on a 94 Chevy Silverado? There is no spout connector to unplug on a 94 Silverado with the 350 to set the ignition timing. The timing is set the conventional way. It wasn’t until the model year 95 Silverado where a spout connector had to be unplugged in order to set the ignition timing. This truck should have the tan wire. How to set Vortec timing on a GM Truck? You need a live data scan tool that can read timing, and you have to rev the engine to 1000RPS I think, then set the...
Most popular

How do you put compressor oil in a compressor?

How do you put compressor oil in a compressor? Pour the oil very slowly into the intake port or low side of the compressor. This is where the large line entered. While pouring in the refrigerant oil, rotate the hub and clutch slowly to let the oil enter the compressor. Does the suction line go to the compressor? The suction hose is the low pressure line. When it enters the evaporator, the refrigerant goes from a high pressure liquid to a low pressure vapor. This condition continues until it returns to the suction side of the compressor. Hence the name,...
Easy lifehacks

What is VSS low signal?

What is VSS low signal? OBD II fault code P0502 is a generic code that is defined as “Vehicle speed sensor (VSS) -low input”, and is set when the PCM (Powertrain Control Module) detects a lower than expected input signal from the Vehicle Speed Sensor (VVS). What is a VSS input? After registering data, the two transmission speed sensors, also commonly referred to as vehicle speed sensors (VSS), send data to the powertrain control module (PCM), which compares these two inputs and calculates which gear the transmission should engage for efficient driving. What does the OBD II fault code p0502...
Easy tips

When does a neutral safety switch need to be replaced?

When does a neutral safety switch need to be replaced? If the neutral safety switch isn’t able to disconnect the electric current to the starter and ignition, it will need to be replaced and poses a danger if it isn’t as soon as possible. When do you know you need to replace Your starter? If there is no cranking coming from the engine and you start to hear a whining noise coming from the starter, this is a symptom known as freewheeling. This indicates that your flywheel cannot make contact with the starter gear. As a result, you need to...