Most popular

Are there transmission problems with the Dodge Ram?

Are there transmission problems with the Dodge Ram? The 2007 model year of the Dodge Ram was also known for having some transmission problems. In particular these resided with shifting difficulties like we've seen in other models, as well as total transmission failure requiring replacements. As with others, this problem for some drivers ended up with more than one replacement of a transmission. Is the transmission on a Dodge A604 reliable? Contrary to what a few people believe, Dodge and Chrysler's transmission are reliable, with the exception of the A604 transmission. A Dodge / Chrysler transmission that is serviced regularly...
Most popular

Is the steering column shifter ugly or classy?

Is the steering column shifter ugly or classy? The steering column shifter on the column is ugly to me and not classy. I have an older S class and was completely disgusted when looking at the new S class when it came to the shifter. To me it is much more luxurious to have the nice leather coated shifter in your right hand in the center console than a plastic piece on the column. Where can I buy new steering column parts? With our full "STEERING COLUMN PARTS" inventory of the most commonly needed items on domestic vehicles, we make...
Most popular

What to do when your transmission goes into limp mode?

What to do when your transmission goes into limp mode? If you are still having issues with the car going into limp mode and the scanner pointed you in the direction of the valve body then you may want to consider replacing it. The valve body is inside the transmission. The transmission does not need to be removed. Replacing the valve body can per perform with the transmission in place. What to do when your Mercedes goes into limp mode? You may also get a check engine light if your transmission goes into limp mode. When a Mercedes-Benz goes into...
Other

What causes uneven tire wear on the outside of tires?

What causes uneven tire wear on the outside of tires? Front tires wear on outside edge due to wheel misalignment. It may be caused by the suspension moving out of its proper position, however, other car parts may be the reason. These are the potentially damaged mechanical parts: Worn ball joints. What causes a tire to be bald on the edge? In some cases it can be caused by excessive toe out. Rotating from side to side will cure nothing and unless the cause is resolved any tire placed there will wear in a similar fashion. July 6, 2016, 2:55am...
Common questions

Does 2012 Chrysler 300 Limited have Sport mode?

Does 2012 Chrysler 300 Limited have Sport mode? Quicker shifts are possible on the new Chrysler 300S V-6 and 300 Luxury Series models as a result of a “Sport” shift mode that requires simple driver input. What kind of engine is in a 2012 Chrysler 300? When the 2012 Chrysler 300 is equipped with the 292-hp and 260 lb-ft of torque 3.6-liter Pentastar V-6 and the all-new eight-speed automatic transmission, the 300 is capable of a 6.6-second 0-60 mph time, while returning an EPA-estimated 19/31 mpg city/highway with the eight-speed automatic. How do you activate Sport mode on a Chrysler...
Other

Is the shift briefing Bulletin applicable to US citizens?

Is the shift briefing Bulletin applicable to US citizens? This shift briefing bulletin only applies to foreign nationals (including United States [U.S.] citizens) and must be read in conjunction with operational bulletin OBO-2020-021, Regulatory Amendments to Implement Travel Prohibitions in Response to the COVID-19 Pandemic. Which is the state subject of the Constitution? State subject, state answers! Agriculture is a state subject, i.e. it forms a part of the state list of our Constitution, which essentially means that states are supposed to address all the issues related to agriculture. Over the years, agriculture, being a state subject, has been viewed...
Other

How do you change the cable on a shifter?

How do you change the cable on a shifter? Unwrap your bar tape in order to access the shifters. Clip off the end cap and remove the cable from the old housing. Fully remove the old cable from the shifter. Use the old housing as a guide measure, and cut the new lengths of cable housing. What happens when the shifters on a bike wear out? Like every other component on your bike, your shifter cables will eventually wear out. And when they do, you’ll know it: Corroded and frayed shifter cables are more likely to get stuck in the...
Easy lifehacks

What should my crankshaft position sensor reading be?

What should my crankshaft position sensor reading be? Typically, this reading is around 200 millivolts, but this can vary from vehicle to vehicle. Check the manufacturer’s specifications. If there is no output voltage, then, obviously, your sensor is not working. So, If your test results are within specifications, check the sensor electrical connector and wiring harness. What should the camshaft position sensor be set to? Disengage the wiring harness connector from the CMP sensor. NOTE: Prior to removing the camshaft position sensor, set the No. 1 cylinder to 10°After Top Dead Center (ATDC) of the compression stroke. Note the position...
Common questions

Can an unchanged air filter make you sick?

Can an unchanged air filter make you sick? Sealed buildings that are using old filters allow poor quality air to recirculate indoors. We inhale these particles, and depending on your sensitivity, they can cause minor problems like watery eyes, coughing, sneezing, or trigger asthma-related symptoms and other long-term respiratory complications. What are the consequences if air filter is not working? Decreased indoor air quality And a clogged filter isn't doing its job. Instead of improving the quality of your air, it does more damage than good. By letting your indoor air quality suffer, you could be harming your health. You...
Easy lifehacks

Why are my vents making a popping noise?

Why are my vents making a popping noise? Popping and banging sounds are caused by the movement of duct walls due to pressure changes. Hot air makes your ductwork expand; cold air makes it contract. How much popping noise you hear depends on 1 or more of these 4 factors: The shape of your ducts. Why is my wall heater clicking? Clicking – A clicking noise coming from your furnace is typically an indication of a faulty flame sensor or possibly a problem between the ignition and the gas. This will also require immediate attention. Why do I hear a...