Other

Are there any changes to the Lincoln MKX?

Are there any changes to the Lincoln MKX? For 2015, Lincoln has made no changes to the MKX, which was last redesigned for 2011, bringing new sheetmetal, a much-improved interior, and the love-it-or-hate-it MyLincoln Touch infotainment interface. It's still a handsome model among its crossover contemporaries, avoiding flashiness with just the right amount of flair. Where are the Lincoln Nautilus and MKX made? As Lincoln is phasing out its use of "MK" model names, as part of a mid-cycle update for the 2019 model year, the MKX adopted the Lincoln Nautilus nameplate. Both generations of the MKX (and Nautilus) were...
Common questions

Where are the hazard lights on a Lincoln MKZ?

Where are the hazard lights on a Lincoln MKZ? The hazard flasher is located between the center air registers above the radio. The hazard flashers will operate whether the ignition is off or on. Press the flasher control and all front and rear direction signals will flash. What causes a Lincoln MKX to stop working? The top electrical concerns focus on the computer failure and the door ajar light staying on even after the door has been closed. Owners report that the computer failure causes the electrical screen to stop working, resulting in the radio, navigation, and phone not working....
Easy tips

What causes the tachometer needle to bounce while driving?

What causes the tachometer needle to bounce while driving? The bounce of the tachometer needle happens when speed is constant under little to no torque, anywhere between 30-58 km/h, the RPM ranges 1300-1800-ish {if I press or release the accelerator slightly the RPMs stay steady, and the bouncing tach needle stays steady}. Why does my car shake at 55 mph? This procedure involves adding small amounts of weights to each wheel and it is done using a machine. You would notice a problem with the tire balance when driving at a speed between 55 and 65 mph. However, at a...
Most popular

What to do when your air suspension is not working?

What to do when your air suspension is not working? Test the compressor for power if the pressure switch is working but the tank is not filling up with air. Place the test light on the power lead to the compressor (s). If it doesn't get power, check the relay running power to the compressor or the fuse running to the compressor. If the fuse is bad, replace it and test again. What causes a Mercedes Benz air suspension to fail? Faulty relay or Blown Fuse The air suspension compressor relay is known to fail. It could either not engage...
Other

Why does my car make a clicking noise when its cold?

Why does my car make a clicking noise when its cold? This cold start noise is caused by a carbon buildup on the crown of the piston and roof of the combustion chamber, causing physical contact and a relatively sharp click at the very top of the piston travel. Both noises tend to abate as the engine warms up. What causes the clicking sound on a cold start engine? Piston slap occurs on a cold engine when clearance between the piston's lower skirt and cylinder wall allow the piston to rock or cock slightly on the downward power stroke and...
Other

Is there a problem with my headlight plugs?

Is there a problem with my headlight plugs? Hello GMTnation I have had an issue with my Headlight Plugs burning up inside the Headlight assembly, I purchased new Headlight assemblies in december and noticed today that the headlight was out on one side again.. took the bulb out and What do you know Light and Pigtail Melted.. Not sure what to do here .. What to do if your headlight plug melts? So I ordered a new set of headlights from ebay and once again the Plastic Plug that goes into the headlight bulb melted along with the wires themselves,...
Easy lifehacks

Where is the temperature sensor on an AC evaporator?

Where is the temperature sensor on an AC evaporator? Typically this component is installed directly on the AC evaporator, as it accomplishes its job by monitoring the temperature found in this component. The AC evaporator is typically located behind the firewall of the engine compartment, tucked in tightly behind the dashboard as well. Where is the temperature sensor on my car? Average rating from 54 customers who received a Heating AC Inspection. The evaporator temperature sensor or switch is a component commonly found on many road going vehicles. It is a part of the vehicle’s AC system, and as its...
Other

What kind of engine does a 2003 Lincoln LS have?

What kind of engine does a 2003 Lincoln LS have? Appearance and technological modifications are plentiful in the least-expensive Lincoln sedan for the 2003 model year. A new grille surround, fascia, mirrors, deck lid, taillights and wheels are installed in the new LS. New variable valve timing is intended to improve power and the smooth operation of the 3.0-liter V-6 and 3.9-liter V-8 engines. What was the original name of the Lincoln LS? The Lincoln LS was originally available with two models: the LS6 and the LS8 (the names had reflected the vehicle's engine sizes). Toyota's Lexus division became concerned...
Easy tips

What should I Sell my 2000 Lincoln LS for?

What should I Sell my 2000 Lincoln LS for? POWER STEERING UNIT, SPARK PLUGS & IGNITION COIL, AIR CONDITION UNIT,NEW TIRES AND L.F. WINDOW BROKEN AND R.F. WINDOW MOTOR that I took care of it myself and not mention the rest of repairs UPPER TONE ARMS BOTH SIDES. Now I decided to sell it knowing that needed a BREAKS AND A TRANSMISSION so I can get revealed from this. Is the 2002 Lincoln LS a good car? If every car were built like a Lincoln 2002 LS, the car business would go broke. This LS is capable of another 10...
Common questions

Do you have to replace intake manifold?

Do you have to replace intake manifold? In some engines, an intake manifold can corrode or crack causing either vacuum or coolant leaks. A cracked manifold must be replaced if it cannot be safely repaired. Coolant leaks: In some cars, there are coolant passages inside the intake manifold that can leak, often because of bad gaskets or other damage. Why do I need to remove the intake manifold? I will be removing the intake manifold to clean the intake ports of carbon. In the process, the fuel rail needs to be removed. The injectors aren't screwed down, so some may...