Common questions

Why does my Ford truck make a squeaking noise?

Why does my Ford truck make a squeaking noise? Ford trucks producing a high pitched whine or squeak could signify a problem with pulleys. The bearings in the idler and accessory pulleys will whine when they go bad. However, because of their size and position at the front of the engine, it can be difficult to tell which pulley is bad (if any pulley is). What causes the frame on a Ford F-150 to squeak? Your Ford F-150 has many components that can cause your frame to squeak, including the suspension you drive on, the truck's bed, or simply anything...
Easy lifehacks

What makes a car start?

What makes a car start? A car engine starts thanks to the ignition system. This is the unit that supplies the energy to get the motor going. The ignition system begins with a key, which you insert and turn, and ends with a spark that ignites combustion in the cylinders. This combustion is what starts the engine. How does a car engine come to life? First the starter motor comes to life, then the engine begins to turn and the spark plugs fire. When the key is turned, the starter motor "turns the engine over," which means it turns the...
Easy lifehacks

When did the Morris Minor car come out?

When did the Morris Minor car come out? The Morris Minor is a British economy car that debuted at the Earls Court Motor Show, London, on 20 September 1948. Designed under the leadership of Alec Issigonis, more than 1.3 million were manufactured between 1948 and 1972. Is there a 1955 Morris pick up for sale? We have in our showrooms a very early 1955 Morris Minor Pick Up. It has been fully restored by Minor Medics of Milton Keynes between 2001 and 2002, the bills and receipts are substantial to say the least. It has been an excellent job. What...
Easy tips

Can a misfire light up the Check Engine light?

Can a misfire light up the Check Engine light? Although a misfire will usually light up the check engine light, on your OBD II equipped Ford vehicle, this is not an absolute truth, and this is what makes finding the root cause of the misfire difficult. Well, in this article, I'm gonna' offer you my take on how to diagnose this type of problem. What is the diagnostic code for Ford check engine light? Refer to our Generic OBD II code list for definitions on all other Ford diagnostic trouble codes. P1000 OBD System Readiness Test Not Complete P1001 KOER...
Easy lifehacks

How long does it take to stop when driving 35 mph?

How long does it take to stop when driving 35 mph? Because of this human factor, as speeds increase, the stopping distance increases dramatically. At 30mph the stopping distance is much greater—109 feet. At 35 mph it goes up to 136 feet, and you're not really speeding yet. Switch up the numbers to freeway speeds—60 mph has a stopping distance of around 305 feet. What is the following distance for 35 mph? The Three-Second Rule ChartThree-Second RuleSafe Interval Should BeSpeedDistance TraveledFor These Conditions25 m.p.h.37 ft. per second35 m.p.h.52 ft. per second45 m.p.h.66 ft. per second What's the safest speed to...
Other

Will leaving my trunk open drain battery?

Will leaving my trunk open drain battery? Failing to fully close a car door or the trunk lid also can drain some of the energy from a car battery after the vehicle's engine shuts down. Even a simple dome light left on by accident will draw enough power from the battery to drain it in a day or two, leaving the battery incapable of starting the car. How do I get interior lights to turn off with the hatch open? My Ford Explorer rear interior lights would not turn off when the car was on to play music at the...
Most popular

When did Ford stop using Dana 44 spindles?

When did Ford stop using Dana 44 spindles? As shown in this article on a 1994, from 1980 to 1997, Ford’s F-150 Dana 44 spindles used one needle bearing to support the outer axle shaft, and two different spindle seal types for the front axles. During this same time period, Ford also used four different spindle nut configurations. How is the Dana 44 TTB attached to the frame? The inboard ends of the beams are attached to a frame-mounted crossmember by a bushing, while the outboard ends support the steering knuckles and are attached to the frame through the springs...
Easy lifehacks

What should I know about Ford 6.0 PowerStroke diesel?

What should I know about Ford 6.0 PowerStroke diesel? If you are thinking about purchasing, or already own a 6.0 Powerstroke Diesel you need this report to... REV-X OIL ADDITIVE FOR 6.0 DIESEL PICKUP TRUCKS (4 bottles)Never before has the proper oil additive package been so instrumental in protecting todays high performance diesel engines. What kind of exhaust manifold do I need for Ford 6.0L Powerstroke? Don't risk using old hardware when installing a new exhaust manifold on your 2003-2007 Ford 6.0L Powerstroke, replace it with the Dorman 03419 Exhaust Manifold Hardware Kit. Dorman manufactures their products to strict engineering...
Most popular

Can you turn a steering wheel too far?

Can you turn a steering wheel too far? Generally no. You will often hear the power steering pump squeal as it tries to move the wheels beyond where they will go. In most modern cars, there are limit switches to avoid the issue. What was the steering problem on a 2008 Ford Escape? The Contact Owns A 2008 ford escape. The Power Steering Continued To Fail Intermittently While Driving 35 Mph Causing The Steering Wheel To Be Disabled. The Vehicle Was Taken To The Dealer Who Stated That The Steering Column Needed To Be Replaced At A Cost Of $1100....
Most popular

What is OD on Ford f150?

What is OD on Ford f150? When your transmission is in “overdrive” mode, the engine turns over more slowly, and as a result it saves gas and reduces engine wear. However, it also reduces your available torque when you accelerate, unless you push the gas pedal hard enough to “kick down” to a lower gear. What does it mean when Overdrive light flashes on Ford F150? Re: Ford f150 overdrive light flashes. This usually means there is a transmission related fault. There is probably a error code stored, and your transmission may be in limp mode; usually 2nd gear only....