Common questions

When the brake pedal goes to the floor?

When the brake pedal goes to the floor? A brake pedal that sinks all the way to the floor could indicate a problem with the brake master cylinder or it could be due to a brake fluid leak. In either case, a careful assessment is required – once the issue is accurately diagnosed, you can then go ahead and fix the issue. How do you calculate brake pedal force? How is it calculated?Measure the distance from the pedal's pivot point to the center of the pedal pad. This is measurement “A” in the diagram.Measure the distance from the pedal's pivot...
Common questions

What kind of tuner do I need for 6.6L LBZ engine?

What kind of tuner do I need for 6.6L LBZ engine? You will be able to find 6.6L LBZ engines on GM Duramax models, and for this article, we will be focusing on tuners that are compatible with those engines (although many of the tuners on our list are also compatible with other engine types, so if you happen to be a truck aficionado, you are in the right place). Is the 6.6L GM Duramax a diesel tuner? We've said it before and we'll say it again, "The best bang-for-the buck for increasing fuel economy and torque in your 6.6L...
Other

Can a faulty spark plug cause white smoke?

Can a faulty spark plug cause white smoke? Yes, they can.. Craig Nicol has it right.. Unburned fuel entering the exhaust can light off in the catalytic converter resulting in white, extremely acrid smoke.. Your engine will misfire, and if it’s not corrected it will destroy the catalytic converter.. Why do I have white smoke coming out of my injector? Other causes of white smoke include lack of compression, or water/coolant entering the combustion chamber. BLACK SMOKE. Black smoke indicates excess fuel is being injected into the combustion chamber and/or not enough air is present. This can be caused by...
Most popular

Where does the pinion seal go on a car differential?

Where does the pinion seal go on a car differential? The driveshaft connects to the differential via the pinion shaft – a short shaft that extends from the front of the differential. Your vehicle’s differential is filled with fluid – like engine oil but thicker. What to do if front diff pinion seal leaks? If you only replace the seal, lightly lube the pre-installed seal, then try to equally (push) install that seal into the pinion opening as not to warp the seal. After that's done, clean down the whole oil saturated area. Then top off with the same synthetic...
Easy tips

What is the torque spec on a 5.3 oil pan?

What is the torque spec on a 5.3 oil pan? The rear of the cover is 106 in-lbs, to engine and front cover is 18 ft-lbs and the bolts to the bell housing, bolts to the transmission and converter cover are 37 ft-lbs. Thanks. So I think I got it. I looked at it today. What are the torque specs for a Chevy big block? Bolt Torque Spec Chart for Chevy Big Block Chevy Fastener Type Torque Specs Main cap bolt, 396-427 2-bolt 95 ft.-lbs. Main cap bolt, 396-454 4-bolt (inner/outer) 110 ft.-lbs. 3/8 in. connecting rod bolt 50 ft.-lbs....
Most popular

Should a PCV valve be loose?

Should a PCV valve be loose? As long as the valve has a snug fit to the hose there will be no leak. Well any more than is supposed to be there as the pcv valve is really a controlled leak sucking nasty fumes from the crankcase. The loose fit into the grommet reduces the polluted air pulled from the crankcase. Is a rattling PCV valve bad? Most PCV valves contain a spring-loaded device. Once you remove the valve, shake it with your hand. You'll hear a rattle. Even if the valve rattles, if your engine is experiencing one or...
Easy lifehacks

What does the open circle on the AWD symbol mean?

What does the open circle on the AWD symbol mean? The open circles indicate that the AWD system has been disconnected. Note that the first symbol is used in New Zealand and Australia to indicate only that the 4-wheel Drive system has been engaged, not that there is a problem. Click here for more. Before going on, is one of these truly your symbol?? If yes, continue on below. How do you get into the back of an Oldsmobile Alero? 1. Fold the right front seatback forward after lifting the seatback latch fully. 2. Slide the seat forward to allow...
Other

What can ruin a catalytic converter?

What can ruin a catalytic converter? When an engine is operating outside of the proper specifications, wear and damage may be caused to the catalytic converter as well as the engine itself. Incorrect air/fuel mixture, incorrect timing, or misfiring spark plugs could lead to a catalytic converter failure or worse. Can I repair a hole in my catalytic converter? You can use steel putty to seal any hole or crack in the catalytic converter. This will form a permanent seal that will last a long time. You can buy the putty at any auto store. For most vehicles, the average...
Easy lifehacks

What makes a car not accelerate but RPMs go up?

What makes a car not accelerate but RPMs go up? 1 Fuel Filter. If the gasoline in your car isn’t pure and clean, there is no way your engine will work effectively. 2 Exhaust Filters. If any of your exhaust filters is clogged or blocked, you may experience a problem while driving. 3 Cylinder Compression. 4 Air Filter. 5 Camshaft Sensor. ... Why does my car not accelerate uphill? We also showed you the main reason why car won’t accelerate past 40 and also why car wont accelerate past 20 and finally, we discussed the reason your car wont accelerate...
Easy lifehacks

What happens if the distributor on a Chevy Silverado fails?

What happens if the distributor on a Chevy Silverado fails? The distributor on the V6 engine installed in some 2002 Chevrolet Silverados is responsible for controlling sending spark to each spark plug through the ignition wires. If the distributor fails, then the cylinders won't receive the spark necessary for the internal combustion process, and the truck won't run. Are there any electrical problems with my Silverado? I have a 2007 4.3 V6 new body style silverado. It does what I call 'glitching'. The lights for airbag, check engine, tire pressure, etc will flash on and off. The gaug Ok so...