Common questions

Is the 2009 f150 reliable?

Is the 2009 f150 reliable? On the plus side, Consumer Reports indicated that overall predicted reliability for the 2009 F-150 was reasonably good, with a rating of three out of five. Major engine trouble spots were predicted to be better than other vehicles, as were engine cooling and major transmission problems. Is the Ford F-150 STX a good truck? 2009 Ford F-150 STX The truck handles very well except in wet conditions. If you put weight in the bed of the truck, it helps with the handling. The paint on the exterior is dusting off but that is the only...
Other

How hot is too hot for oil temperature?

How hot is too hot for oil temperature? The upper limit for most mineral-based oils is about 250 to 300 degrees F. Synthetics can take up to 450 degrees F. or higher (some as much as 700 degrees F). What should the oil temperature be for a new engine? If one runs a cruise oil temperature in a new engine, there will be additional friction in the ring belt area until the rings seat. This is normal, so an oil temperature of 245° will not hurt — and may aid — the seating process. How many miles before you need...
Easy lifehacks

Where is the starter located on a 2006 Ford Fusion?

Where is the starter located on a 2006 Ford Fusion? The starter in a 2006 Ford Fusion is at the top rear point of the engine. You'll need to remove the battery to be able to see it. The starter is a small motor, powered by a battery. Why are the headlights on my Ford Fusion not working? The contact owns a 2013 Ford Fusion. While driving approximately 40 mph, the headlights failed to illuminate properly causing the contact to use the high beams to drive. The vehicle was not diagnosed or repaired. What to do if your headlight won't...
Common questions

What does the p0441 Toyota engine code mean?

What does the p0441 Toyota engine code mean? Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins. What does this mean? The cost to diagnose the P0441 TOYOTA code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. What does the OBDII code on a Toyota Tacoma mean? P0441 is one of the more common OBD-II trouble codes with the Toyota Tacoma. It’s a generic powertrain code, which means regardless of what auto manufacturer built the vehicle, it’ll...
Other

How do you turn off anti-theft on a 2008 Ford Taurus?

How do you turn off anti-theft on a 2008 Ford Taurus? All You need to do is press the lock button on the key fob, followed by the unlock button on the fob. Next put Your key in the vehicle's ignition and put it in the on position without the engine running. Wait until the anti theft light turns off then remove the key. How does the Ford Pats passive antitheft system work? Ford PATS Passive Antitheft System uses a key with a transponder in the head of the key. Each transponder is coded with a unique identifying code made...
Common questions

How do you clean a varnished gas tank?

How do you clean a varnished gas tank? Put safety goggles on and rubber gloves to protect yourself. Fill the gas tank with a couple inches of water to clean out varnish. Pour a cup of muriatic acid into the tank. Move the tank around for a few minutes so the solution covers the inside completely. How do you dissolve gasoline? You can make a baking soda paste of two parts baking soda and one part water and rub it directly onto the stain. Allow it to air dry and then brush the baking soda off of the clothing. This...
Common questions

How do you turn off the high beams on a 2003 Ford Explorer?

How do you turn off the high beams on a 2003 Ford Explorer? Locate the turn signal switch on the side of the steering column. Push the turn signal switch forward to change from low beams to high beams. Pull the switch back toward you to change from high beams to low beams. How do you turn off the high beams on a 2005 Ford Explorer? On the Explorers, the turn signal stalk (multi-function switch) is really a two way for our high beams. Pushing the stalk towards the gauges illuminates the high beams and will leave them on. Pulling...
Easy tips

What kind of coolant does a 2006 Ford Escape take?

What kind of coolant does a 2006 Ford Escape take? The 2006 Ford Escape uses Motorcraft Green antifreeze engine coolant. How much oil does a 2006 Ford Escape hold? Capacity: 6 quarts (with filter)When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase. After refill, check oil level. Is there an engine failure in a 2006 Ford Escape? On 5/5/2016 was driving my 2006 Ford Escape the engine light came on I pulled over had it towed. One person said my engine blew, another said it did not but can figure it out. Where is...
Other

How do you remove a rotor from a car?

How do you remove a rotor from a car? Remove the pads and set the caliper onto a control arm, or tie it up so that the brake lines do not support the full weight of the caliper. Remove the rotor by turning the spindle nut counterclockwise with the adjustable wrench. Then pull the rotor from the hub assembly. How do you remove the brakes from a Ford? Lift the Ford with a floor jack and place the front frame rail on one or more jack stands; the brakes can be removed one at a time, or both at the...
Common questions

How do you replace a spark plug on a 2002 Ford Ranger?

How do you replace a spark plug on a 2002 Ford Ranger? Connect a torque wrench to the extension and spark plug socket, and tighten the spark plug to 9 foot-pounds. Inspect the removed wire for defects, including burns, cracks, splits or excessive age. Replace all four spark plug wires one by one if any defects exist. How do you replace a spark plug in a car? Trace one spark plug wire toward the side of the engine until you reach the thick rubber boot on the end. Pull upward on the rubber boot with a slight twisting motion to...