Most popular

What is PCV hose on car?

What is PCV hose on car? The Positive Crankcase Ventilation (PCV) valve hose is a hose running from the valve cover on the engine to either the intake air box or the intake manifold. The engine reburns these gases, which reduces emissions and keeps the engine running cleaner. How do you fix a valve on a Crown Vic? Align the holes on the valve with the holes on the mount to ensure the bolts fit properly. Tighten the four bolts using the socket wrench. Reconnect the hoses to the top of the valve by pushing them into place. Close the...
Other

What did the 8.8 rear end come in?

What did the 8.8 rear end come in? First appearing in 1977, the 8.8 is found in almost all Ford V8 cars from '86 on, and in V6 Rangers and Explorers. There are 24 different Fords that offered the 8.8 rear axle. The weakest points of the 8.8 are the 28-spline axles (1.18 inches in diameter). What axles are in a Bronco 2? Axles: Your Bronco II came with a Dana 28 front and Ford 7.5-Inch rear axle. Does the Bronco have a solid rear axle? Riding on a high-strength-steel platform that will gird the next generation Ranger, the 2021...
Easy tips

Is the 2010 Mazda 3 all-wheel drive?

Is the 2010 Mazda 3 all-wheel drive? Its turbocharged 2.3-liter 4-cylinder pumps 263 hp and 280 lb-ft of torque, working solely through a 6-speed manual transmission. The Mazdaspeed3 is EPA-rated at 18 mpg city/25 mpg hwy. It runs on premium unleaded fuel. All-wheel drive is not available. Is the Mazda 3 a front wheel drive or all wheel drive? This continues a tradition from the prior 323 model, dating back to the early 1980s. Some people have been confused by the Mazda CX-3 and larger CX-5 SUVs, which are based off the Mazda2's sub-compact platform, and Mazda6 family car platform,...
Most popular

How do you replace a headlight bulb on a Ford Fiesta?

How do you replace a headlight bulb on a Ford Fiesta? Once the screws are removed you will then be able to continue with the below steps on how to replace a ford fiesta headlight bulb. Gently lift the headlight cluster forward. You will need to lift the front section up slightly over the fascia, simultaneously, you need to gently unclick a holding bracket (see the linked video). Can a headlight be removed without a buld change? Buld change done without removing the headlight assembly. Bulb holder was probably just too cold, because after a drive it came loose and...
Easy lifehacks

What kind of car is the Bentley Flying Spur?

What kind of car is the Bentley Flying Spur? The Bentley Flying Spur (formerly the Bentley Continental Flying Spur) is a luxury saloon produced by Bentley Motors Limited since 2005. It is the four-door variant of the Bentley Continental GT coupé. What kind of car was the Bentley Continental? The R-Type Continental's chassis was custom built incorporating special components, including a high performance engine, and fitted with a very special light weight body designed and built under the close supervision of Rolls-Royce. One of the world's most expensive automobiles, only about 208 R-Type Continentals were built in total. Why did...
Common questions

How can I tighten the clutch on my Caterpillar D4?

How can I tighten the clutch on my Caterpillar D4? Tighten the spider bolt with a wrench, a quarter turn at a time. Test the pressure on the clutch lever with the torque wrench after each quarter turn of the spider bolt, until the torque wrench breaks at the 30 foot-pound setting. Tighten the spider bolt locking nut and reattach the clutch housing cover with the wrenches. Can a 1947 caterpillar be fitted with an oil clutch? Some of the older cats could be Retro fitted with oil clutches.We have a 1947 Cat d6-8U fitted with an oil Clutch ,So...
Other

How do you fit an idler pulley?

How do you fit an idler pulley? Part 1 of 1: Replacing an idler pulleyMaterials Needed. Replacement idler pulley. Step 1: Disconnect the battery. Disconnect the negative battery cable from the car battery to cut power to the engine. Step 2: Remove the drive belt. Step 3: Remove the old pulley. Step 4: Install the new pulley. Step 5: Torque the pulley. What do bogie wheels do? Found commonly in tracked vehicles such as crawler-type tractors and excavators as well as military tanks, the bogie wheels support the tracks by allowing the tracks to ride on them. Early snowmobile tracks...
Common questions

What should I do if my hydraulic hose is twisted?

What should I do if my hydraulic hose is twisted? The labeling or writing on the side of a hydraulic hose can be used as a guide which helps ensure that the hose is not twisted. If you do end up with a twisted hose, then hold the ends and tighten the connections again using a pair of wrenches. What's the proper way to install a hydraulic hose? One wrench is used to keep the hose from twisting while the other is used to tighten the connection. This is referred to as “double wrenching.” For proper hydraulic hose installation, never...
Other

What does the Check Engine dashboard warning light mean?

What does the Check Engine dashboard warning light mean? The check engine dashboard warning light looks serious but is usually nothing too urgent. You should still have the fault looked into though as in some cases, there is the potential for component damage. The light will come on constantly or flash. Constantly on: Often associated with an emissions fault and an incorrect fuel mixture. Is it possible to reset the warning lights on the dash? This will result in a warning light appearing on your vehicle's dashboard. After the repair is complete, however, it may still be necessary to reset...
Easy tips

What makes the case sr240 skid steer so good?

What makes the case sr240 skid steer so good? The SR240 also offers industry-exclusive detents in the control handles to provide the responsiveness and “feel” of pilot controls with the convenience of electro-hydraulics. The SR240’s radial lift pattern provides maximum strength when digging or pushing. How big is a case skid steer loader? The SR240B is the result of matching large-frame power and performance with the efficiency of a medium-frame machine. An excellent all-purpose skid steer that offers a rated operating capacity of 2,400 pounds on an extremely stable wheelbase, the SR240B is perfect for digging, grading, loading or operating...