Easy tips

How to wire a backup camera to a reverse light?

How to wire a backup camera to a reverse light? Just wanted to make a quick video how to wire a backup camera to a reverse light. I used the Mercedes C300 for this, BUT the principle is the same in other cars. This is the method that is required for cameras that have : LED'S, IR, SONAR, RADAR, or other add on's. https://www.amazon.com/Voltage-Contin... https://www.amazon.com/dp/B01EYWUWJ8/... What is backup camera is your RV or trailer pre wired for? If your RV/camper has a Voyager mounting bracket, this is the camera it’s prewired for (click to view on Amazon). If you don’t...
Easy tips

How do you troubleshoot a BCM?

How do you troubleshoot a BCM? How to Troubleshoot a Body Control ModulePay attention to your vehicle. Check to make sure all the electronic devices are working properly. Turn the radio and CD player on. Check the fuse box if you suspect that your vehicle's BCM is on the blink. What is a BCM issue? A malfunctioning BCM will activate dashboard instrumentation cluster error and warning lights. These lights may flash off and on if the BCM is not able to read the sensors correctly. Your vehicle performance may also be affected as the BCM communicates with other control modules...
Other

Is 15V to high for an alternator?

Is 15V to high for an alternator? So, to answer your question, Yes, 15 volts is too high. Most car alternators, that normally recharge your battery after every start, and provide power while the engine is running, are normally voltage regulated to about 13.8 to 14.0 volts. What does a 5 Volt voltage drop mean? But, before you condemn it, run a voltage drop test between the alternator and battery. GM typically runs a fusible link wire between them for overload protection and they can go bad, mimicking a bad alternator. A voltage drop of .25 volts or less is...
Common questions

Where is the power steering reservoir on a 2010 Malibu?

Where is the power steering reservoir on a 2010 Malibu? The reservoir that holds your power steering fluid can be found under the hood. It is usually located at the passenger's side of the vehicle, where the belts in a smaller or transverse-mount engine are located, but you will also sometimes find the reservoir on the driver's side. What kind of steering does a Chevy Malibu have? I have a 2010 Chevy Malibu with electronic steering. A few weeks back the power steering went out and the message center Chevy Malibu: I have a 2010 Chevy Malibu with electronic steering....
Easy lifehacks

Why do trailer lights go out when the brakes are applied?

Why do trailer lights go out when the brakes are applied? It sounds like you have a ground issue. When trailer lighting does not have a sufficient ground many different scenarios can show up, but the most prevalent is when the most amperage is applied, like tail lights on and brake pedal pressed, the lights go out. All lights must be properly grounded for proper function. Why do my tail lights stay on even after I Turn Off the car? Thank Kevin. If the tail lights are illuminated even after you have used the on-off switch to command them off,...
Easy tips

Is it good to turn key and no start / crank?

Is it good to turn key and no start / crank? Automotive Forums .com Car Chat > Chevrolet > Avalanche | C&K | Silverado | Suburban | Tahoe > Silverado > Turn key and no start/crank...bat is good! Turn key and no start/crank...bat is good! Hi guys, Thanks in advance for any help, I have a 01 2500HD Crew cab with the 6.0. Tonight I stopped at the gas station to grab some milk. Why does my car not start when I turn the key? A low or bad battery can be easily tested with a standard ohm meter or...
Other

How do you remove oil pan from Chevy Silverado?

How do you remove oil pan from Chevy Silverado? Support the oil pan with one hand while you loosen and remove the oil pan bolts, located on all four corners of the pan. Use a wrench to loosen and then remove the oil pan. The pan will drop at this point into your hands. Raise the Silverado using the proper equipment. How do you get the oil pan out of a car? Disconnect each of the bolts that line the edge of the oil pan. These bolts hold the oil pan in place so as you remove them, support the...
Easy tips

Why is my cooling fan not working on my Trailblazer?

Why is my cooling fan not working on my Trailblazer? Everytime my 2006 Trailblazer would be driven in the rain the check engine light would come on. The last time it would not go off so I took it in and they told me it was the cooling fan motor. While finding someone to work on it I discovered this is very common on this vehicle and it was 700. 00 to repair. Are there any problems with the Chevy Trailblazer fan clutch? After a few minutes of searching on the internet it is apparent that my problem is the...
Other

What does p0449 stand for in automotive category?

What does p0449 stand for in automotive category? Evaporative System (EVAP) Vent Control Circuit Malfunction Code P0449 Meaning The Evaporative Emission Control (EVAP) System seals the fuel system of the vehicle in order to prevent fuel vapors from the fuel tank and fuel system from escaping into the atmosphere. This is important because fuel vapors contain a variety of hydrocarbons. What happens when the solenoid of a fuel injector fails? Typically, the solenoids often short internally when injectors fail, which causes a drop in resistance. If the specification calls for 3 ohms, for example, and an injector measures only 1...
Easy lifehacks

Do you have to reprogram tire sensors?

Do you have to reprogram tire sensors? These sensors must be programmed with the proper protocol/application information for the vehicle before they can be installed in the tire, and then must be relearned to the vehicle. Unfortunately, some shops overlook the necessary relearn step mistakenly believing the sensor programming did the trick. How to reset tire pressure sensor TPMS light on Chevrolet? If you have a 2010 2011 Camaro, you can reset the TPMS by increasing or decreasing the tire pressure without using tools. Follow these instructions to get started: If your vehicle has an ignition button, press the Engine...