Common questions

What happens when you change the pulley on an alternator?

What happens when you change the pulley on an alternator? Altering pulley sizes can cause the ratio of the crank and pulley bearing to become out of sync, drawing too much power from the alternator or not enough. Be sure that the alternator doesn't call for an overrunning alternator decoupler (OAD) pulley. If so, replace it with one. What are the symptoms of a bad throttle temp sensor? Symptoms of a Bad or Failing Throttle Body Temp Sensor Common signs include poor engine performance, stalling, and broken electrical connections. A common problem that car owners experience is high or low...
Easy tips

What causes a Lincoln check engine light to go off?

What causes a Lincoln check engine light to go off? PCV Valve: Older Lincolns that have V8 Modular engine can suffer from an engine running extremely rough on idle and low speeds, or even stalling. If this is combined with code-combo P2195, P2197, P0171, and P0174 combo, it is almost certainly caused by a large vacuum leak. What happens if a fuel pump is faulty? A fuel pump has the responsibility to supply the engine with the correct amount of fuel. If the fuel pump is not providing the right amount of fuel to the engine, then the engine will...
Common questions

How often should the antifreeze be changed?

How often should the antifreeze be changed? HOW OFTEN SHOULD YOU FLUSH THE COOLANT? Depending on the vehicle and the coolant, the average time between flushes is two years or 30,000 miles for silicated coolants and up to five years or 100,000 miles for an extended drain coolant. How to change the antifreeze in your car? If the water looks dirty you may need to flush your system additionally by removing the upper radiator hose and heater hoses and forcing water through them using a garden hose. Drain the system completely using both the radiator drain and the block drain...
Easy tips

How can I get rid of the engine lifter noise?

How can I get rid of the engine lifter noise? This will continuously pressurize and de-pressurize the lifters, sending the solvent through and breaking lifter plungers loose. Drain the oil into your oil drain pan, but leave the old oil filter in place. Refill the engine with very lightweight engine-flushing oil. How to fix a noisy valve lifter tick can? 1 Flush out the old oil. Unscrew the cap under the car and place a container or bowl under the cap. 2 Rinse your valve lifter with an engine flushing agent like Liqui Moly Engine Flush after the leaking of...
Other

How do you reinstall throttle cable on lawn mower?

How do you reinstall throttle cable on lawn mower? Step #1: Disconnect And Observe The Throttle Cable. Disconnect the throttle cable both ends from your lawnmower. Carefully observe both ends of the throttle cable or take a photo for the reinstallation convenience. Step #2: Attach The Funnel. Now, loosen the bracket that holds the throttle cable in the mower engine. What happens when the throttle cable on a push mower breaks? In most modern push mowers, a throttle cable is connected to the carburetor’s intake valve. When the throttle cable breaks, the intake valve will stay put, and it is...
Other

When did the Mercury Sable come out in Mexico?

When did the Mercury Sable come out in Mexico? As the Mercury brand was not sold in Mexico, Ford of Mexico marketed the Sable as the Ford Taurus. The Sable was on Car and Driver magazine's Ten Best list on its release in 1986 and again in 1990 and 1991. The first-generation Sable used the front-wheel drive Ford DN5 platform, sharing its 106 in (2,692 mm) wheelbase with the Ford Taurus. When was the Mercury Sable front wheel drive introduced? Introduced on December 26, 1985 as the replacement for the Mercury Marquis, the Sable marked the transition of the mid-size...
Easy tips

Why does oil need to be diluted with fuel?

Why does oil need to be diluted with fuel? In short, when fuel mixes with the lubricant, it reduces the viscosity of the oil, meaning that the viscosity may be too low to create an oil film capable of withstanding heavy loads and speeds in some parts of the engine. This results in friction between the metal surfaces and wear of the parts. Why is diesel oil bad? Diesel oils have to put up with much higher engine temperatures, higher oxidation rates, sulfur deposits, fuel soot, acids and other deposits and conditions not usually found in automobile engines. It's because...
Common questions

How much does a rebuilt caliper cost?

How much does a rebuilt caliper cost? The Best in Auto Repair The average cost for brake caliper replacement is between $861 and $896. Labor costs are estimated between $132 and $167 while parts are priced at $729. When to replace brake calipers on Ford F-150? Here is how to replace your brake calipers. This article applies to the Ford F-150 (2004-2014) and the F-250, F-350 Super Duty (2005-2014). Some of the hardest-working parts on your Ford F-150 or Super Duty are the brake calipers – the clamp-like devices that saddle the brake rotors. Why do I need to replace...
Other

How big is a Ford marine diesel engine?

How big is a Ford marine diesel engine? Ford engine complete used dont know the hours it has done was running when it came out of boat can be posted at buyers cost. ford 1.8xld marine diesel engine. Turns over & runs very badly on 3 cylinders. brought the engine to go in my boat and is a lot bigger than anticipated. Used ford marine diesel engines . Where can I buy a motor boat in the UK? Why not browse through our full selection of Motor Boats, Motor Yachts and Motor Cruisers for Sale and see if you can...
Common questions

What happens when you remove wire from alternator?

What happens when you remove wire from alternator? This permits power to begin flowing through the alternator as well as the other components of the car. Always mark each wire that you remove from an old alternator, if necessary, to ensure you can easily replace the wires in the correct connectors when you install the replacement alternator. Why does my alternator not charge my battery? There are lots of wires in the vehicle which deliver power to the alternator. If one of these wires were to become damaged or worn out, then it could cause the alternator to fail at...