Most popular

How can I Stop my serpentine belt from squealing?

How can I Stop my serpentine belt from squealing? How to Make a Serpentine Belt Stop Squeaking Apply Belt Squeal Spray (Dressing) Different spray-on compounds claim to quiet belt noise. Fix a Squeaky Belt With Bar Soap. A squeaky belt may be a loose belt, or there may be dirt, oil, or grease on a pulley causing the belt Tighten or Aligning the Belt. Replace the Belt. Repair or Replace Defective Bearing. ... What causes a squeaky serpentine belt? A squeak can be caused by a worn belt or a loose tensioner. Valvoline Instant Oil Change can inspect your serpentine...
Most popular

What does the p1639 code on a Ford mean?

What does the p1639 code on a Ford mean? Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins. What does this mean? After a new Powertrain Control Module (PCM) has been installed, the Vehicle Identification (VID) block has to be reprogrammed to the PCM. The cost to diagnose the P1639 FORD code is 1.0 hour of labor. How much does it cost to repair a p1639 Chevy? Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins. The cost of diagnosing the P1639 CHEVROLET code is 1.0 hour of...
Most popular

Does the Ford F-150 have a built-in generator?

Does the Ford F-150 have a built-in generator? The new 2021 Ford F150 has a lot of good things going for it. Along with offering a full hybrid V6 model, the series has a built-in generator. This is great news for RVers. For many, taking a travel trailer or a truck camper outside of RV parks means you also have to carry around a generator. How can I use Ford as built data? Last month, we outlined how to install and program a powertrain control module (PCM) on a Ford vehicle where the original PCM did not communicate using the...
Easy tips

How do you reset the check engine light on a 2009 Ford F150?

How do you reset the check engine light on a 2009 Ford F150? Drive the car for at least 15-20 minutes above 25 mph. If You've been starting and stopping excessively, the catalytic converter may be stressed and driving at highway speeds should clear the CEL. Disconnect the positive battery cable for 15-20 minutes. What is the brake light on a 2009 F150? On 2009 f150 my e brake light, abs light, and my traction control indactor are on. it is also saying check brake system. - Answered by a verified Ford Mechanic What do the warning lights on a...
Easy lifehacks

What would happen if you wire an outlet backwards?

What would happen if you wire an outlet backwards? This happens when the hot and neutral wires get flipped around at an outlet, or upstream from an outlet. Reversed polarity creates a potential shock hazard, but it's usually an easy repair. One of these wires is connected to the earth, or 'grounded', so this wire is called the grounded conductor. How is the hot wire in a two prong plug determined? Determining the hot wire in a two-prong plug can be done using one of two methods. A two-wire plug uses a type A outlet. These outlets are the older...
Most popular

How far can a Ford Escape drive on empty?

How far can a Ford Escape drive on empty? The Low Fuel Level light turns on when your Escape's fuel level dips to approximately 1/16 of a tank. On average, Ford Escape owners report getting about 35 miles more drive time once the Low Fuel Light turns on. Under the right conditions many drivers have reported getting as much as 50 miles on empty. When does a Ford Escape go to 4 wheel drive? According to the manual, it automatically shifts into 4-wheel drive when slippery conditions are Present. Am I reading that correctly? Yes the ECM picks up the...
Easy lifehacks

How to remove fuel injection control module ( FICM )?

How to remove fuel injection control module ( FICM )? Remove FICM from truck. It was easier if ~ 2 gallons of coolant was removed and coolant reservoir removed. Remove the four screws (Torx bit T-10) below small cover. Remove eight screws (Torx bit T-20) holding both halves of case together and split case. Set the half with the three connectors aside ( Figure 2 How does the FICM work with the ignition switch? It uses engine speed and position signals (*CKPO, *CMPO) to determine when the injectors need to be activated. The ignition switch provides *KEYPWR to the FICM....
Common questions

What kind of engine does a 1990 Ford Mustang have?

What kind of engine does a 1990 Ford Mustang have? 1990 Ford Mustang Steeda. Vin: 1FACP41E3LF187333. #19 of Less Than 200 Built. Very Nice Vermillion Red Paint. Original 5.0 V8 Engine. SVO heads. GT-40 Intake.Anderson N-41 Camshaft. 5 Speed Manual More Info › Gateway Classic Cars of Atlanta is proud to offer a 1990 Ford Mustang LX. How big is a 1990 Ford Mustang LX? Fully restored and freshly painted 1990 Ford Mustang LX, 5.0 Liter. It’s the one of a kind “7 up special!” Garage kept and covered the last four years. Completely new interior, a/c and heat work...
Most popular

How to find vehicle recalls?

How to find vehicle recalls? How to find out if your vehicle has a recall If there's a recall on your make and model of car, you will be notified by mail You can also use a car's VIN to look up any open, unrepaired recalls on that vehicle A recall issue should be free to fix, because the manufacturer will foot the bill. All you have to do is take the car in to a local dealership How do you check the VIN on a car? Look for the VIN on the dashboard of a car or truck on...
Most popular

Why is my MAF sensor sending out a p0171 code?

Why is my MAF sensor sending out a p0171 code? How to Fix P0171 and P0174 While inspecting the intake boot thoroughly, another option is to stop at the MAF sensor itself. MAF sensors can get dirty or oiled and send out a false signal, but usually this is also indicated by a MAF trouble code as well. Why is my oxygen sensor sending two codes? Depending on the problem, it may send both codes if the issue is causing a lean condition on both engine banks. It’s important to note here, the very nature of the oxygen sensor sending...