Easy tips

What should I look for in a 2011 F150?

What should I look for in a 2011 F150? Unless you're jumping into something crazy right off the bat, more horsepower and more torque for the 2011 F150 5.0Ls and 6.2Ls comes in ebbs and waves, and to start off your build, you should start with the basics. Most folks tend to go for an 5.0L F150 Cold Air Intake or a 6.2L F150 Cold Air Intake as their first upgrade. How much can a 2010 Ford F-150 tow? The 2010 F-150 was rated to tow nearly six tons, but the engine felt like it could barely handle the truck’s...
Most popular

What is the bore and Stoke on a Ford Thunderbird?

What is the bore and Stoke on a Ford Thunderbird? The bore is 3.39" and the stoke is 3.35" (if my ford supplied information is correct). How big is the engine in a Ford Thunderbird? Therefore the car has a 241.893429460 cubic inch engine (Motor Trend Car of the Year reported 241.9 which more than close enough, I call is 242 cubic inches) All that said the liter displacement is 3.96392310974 or using rounding 4.0 Liters per the lession taught to all of us in grade school. What did Cluett Peabody use the Ford Thunderbird for? Cluett-Peabody used the Thunderbird...
Other

Is 2010 F-150 a good truck?

Is 2010 F-150 a good truck? Most reliable truck I have ever owned It also is very comfortable to ride in and is roomy for the back seat passengers. Rating breakdown (out of 5): Comfort 5.0. Interior design 5.0. Is the 2010 Ford F-150 a good truck? Most reviews are positive about the 2010 Ford F-150's performance, though a few note that competitors offer bigger engines. However, most reviewers say the available engines are powerful, while tweaks to the trucks frame, steering and suspension have made it drive and ride better. Why did my 2010 Ford F-150 engine stall? The...
Other

How do I find the top dead center tool?

How do I find the top dead center tool? Once the top dead center timing mark is lined up with the marker on the engine, the motor should now be at top dead center. To verify, shine the flashlight down into the spark plug hole. You should be able to see the top of the piston clearly near the top of the cylinder. How do you find the top dead center of an engine? Step 5: Verify that the engine is in top dead center position. Once the top dead center timing mark is lined up with the marker on...
Easy lifehacks

Why does my car buck in first gear?

Why does my car buck in first gear? Re: Car buck/jerk near idle speed while in first gear. this is pretty normal. just get off gas, and then very gradually apply gas again. if u just feather the gas at idle speed it will buck. Why does my car not shift into first gear? The signs that the car will show at this time are: The transmission won’t shift and the car makes a grinding sound when the engine is running. Besides, pulling out of first gear will feel harder than normal. The transmission will shift in and out of...
Most popular

How do you bypass the anti-theft on a Ford Escape?

How do you bypass the anti-theft on a Ford Escape? Turn the car off. Remove the negative and then the positive cable from your car battery. With the battery disconnected, switch the car to “on” and press the horn or run the headlights to burn through any lingering energy. Wait a minute or two, and reconnect the battery, positive cable first. What to do if your Ford Escape lock actuator is broken? Fixing the broken rear door lock actuator on the 01-04 Ford Escape. Newer Escapes are similar. How to manually unlock the door and then replace the actuator. Fairly...
Easy lifehacks

What causes fuel injectors?

What causes fuel injectors? Whenever an internal-combustion engine is powered down, the combustion chambers have leftover fuel/exhaust hanging around. While the engine cools, the vaporized gases settle on every surface in the combustion chamber, including the fuel injector nozzle. How does a fuel injector work in an engine? Fuel injectors are a particular type of solenoid that are made to actuate their pistons very quickly. This allows the injector to deliver precise amounts of fuel into the cylinder, even while the engine is spinning at higher RPMs. What should I do if my fuel injector is not working? Hopefully, these...
Common questions

Can you connect the choke to the throttle?

Can you connect the choke to the throttle? I took it back and after one month, they called and said that they were unable to figure out the linkage for the choke. They did switch the cables and the throttle lever now does actually activate the throttle (see red circle). The second cable simply is disconnected. Can anyone tell me how to connect the second cable to the choke? Thank you. How do you install choke control on a car? 2. Place the choke control cable under the intake manifold from the front of engine (front pull choke). Insert the...
Easy lifehacks

Are power strokes good?

Are power strokes good? Take out the emissions systems and the 6.7 Powerstroke is a very reliable engine. Even with the few common problems the 6.7L Power Stroke should be good for 250,000+ miles. Maintain your Ford 6.7L engine well and chances are it will reward you with a great overall experience. Are there any problems with a power stroke engine? [&3L&] Power Stroke is known as a legendary engine for good reason. We believe it’s one of the best [&diesel&] truck engines around. However, the [&7&].[&3&] Power Stroke is prone to its fair share of problems and failures. The...
Common questions

What kind of automatic transmission does Ford have?

What kind of automatic transmission does Ford have? Many automatic transmissions have been used by the Ford Motor Company throughout the years, from early Ford and Cruise-O-Matic's to automatic overdrive four-speeds transmissions.The C-series' are Ford's primary automatic transmissions and are evolutionary, with the C3, C4 and C6 models each having an improvement on the last. How can you tell the year of a Ford transmission? All are visually identifiable, with other methods reserved for in-depth identification, such as year of production. The prime identification source is the pan located on the bottom of the transmission; its shape and bolt count...