Other

How do I turn off MyKey on 2015 Ford Fusion?

How do I turn off MyKey on 2015 Ford Fusion? Ford MyKey Disable InstructionsAfter starting the car, wait for the onboard computer to load.Locate the main menu on the screen using your steering-wheel-mounted controls.Select "Settings" by pressing "OK."Scroll to the "MyKey" option and press "OK."Search for the option that says "Clear MyKey." Is the Ford Fusion the same car as the 2014 model? Switching to a global chassis for that redesign made the Fusion a completely different car, so it hasn’t been updated all that much for the 2015 model year (compare 2014 and 2015 models here ). But that’s...
Easy tips

How many miles does a 1996 Ford truck have?

How many miles does a 1996 Ford truck have? I set out to "shotgun" the sumbitch until I found/fixed it. project since daily trips to the new dealership now possible). (Truck is a 96 4x4 auto, short box, w/ 150K miles on it.) EGR test, retest, and tripple test, vacuum leak test, yada.. How many Ford 5.4 Triton engines are there? The Ford 5.4 Triton engine has been produced in millions of units and has successfully propelled at least a dozen different car, van, and truck models. What makes a Ford 4.9L engine not start? Without spark, the engine will...
Easy lifehacks

How do you adjust the idle on a Polaris RZR 1000?

How do you adjust the idle on a Polaris RZR 1000? To raise the idle, slide the black cover off the hex, hold the hex with an end wrench, loosen the lock nut and then begin backing the cable threaded end out. When you get the idle you want, about 1120 RPM retighten the lock nut, slide the black plastic cover back in place and complete the reassembly. What's the idle RPM on a Ford Ranger? Engine infrequently races in idle, sometimes up to 3,000 rpm. So many Ford Ranger owners complain of this exact issue, Ford should have done...
Easy tips

What does the p0304 diagnostic trouble code mean?

What does the p0304 diagnostic trouble code mean? The P0304 engine code can compromise your driving experience, so resolve the underlying cause (or causes) immediately. If your check engine light is on and the OBD-II scanner reads a P0304 code, use the guide below to address it. What Does the P0304 Code Mean? Diagnostic trouble code (DTC) P0304 stands for “Cylinder 4 Misfire Detected.” What does the p0316 code stand for? All our repairs are backed by our 12-month / 12,000-mile warranty. The P0316 code is a generic powertrain code related to the ignition system or misfire. When this code...
Most popular

How do you reset the oil life on a 2013 Ford Taurus?

How do you reset the oil life on a 2013 Ford Taurus? Oil Change Light Reset Ford Taurus 2013 2014 2015Turn the ignition to the “RUN” position.Use the up and down arrows to scroll through the menu and select “SETTINGS”, then “VEHICLE”, then “OIL LIFE RESET %”, and finally “RESET”. Do you have to change odometer to read miles instead of KMS? You are correct, that's not going to help. Having just imported an EU spec car into the UK I can confirm that you do NOT have to change the Odometer to read miles instead of KM. You DO...
Easy lifehacks

What to do with an Explorer 5.0 serpentine belt?

What to do with an Explorer 5.0 serpentine belt? Access holes in the inner fender, filled with rubber plugs would be nice so you can remove it later if need be.) Finally, all six of the authors have contributed solutions for a wide range of the installation questions that come up for stock 302, 5.0, and 351, using various radiators and other commonly differing components used in early Broncos. What kind of belt system does Explorer use? The Explorer 5.0 serpentine belt system is one of two most common ways to add a factory serpentine set-up to the small block...
Other

Why is my boost gauge reading negative?

Why is my boost gauge reading negative? If the turbo is not forcing air into the engine, the engine is sucking air which is what causes vaccuum. A negative reading on a boost gauge is meerely telling you how much vaccuum your engine is pulling. Where does the boost gauge go on a car? Basically you can hook your boost gauge up to anything that's plumbed in AFTER the throttle body, except the fuel reg hose, but that's at the front of the engine anyway. thanks for that, does anyone have a photo of the location i can T into?...
Easy lifehacks

Why does Ford f350 diesel have 2 batteries?

Why does Ford f350 diesel have 2 batteries? The two batteries are for higher cranking amps, which are needed for the high resistance load that a diesel engine requires during starting. ... What makes Ford 7.3L PowerStroke diesel-diesel special? It’s an oddball design which actually works quite well, and its advantage over mechanical injection pumps like the P7100 is its ability to vary injection timing for a broader power curve. Inside the engine is a conventional oil pump which lubricates all the critical moving parts, but there is also a second oil pump. When did the Ford 7.3L PowerStroke change...
Common questions

How do you fix a leaking flared fitting?

How do you fix a leaking flared fitting? A leak will occur where the cone enters the flare. Loosen and tighten the flare nut several times to the torque specifications. This action will positively seat the cone into the flare. If the joint still leaks, dissemble the connection and wipe off the flare and the cone with a rag. How to stop brake fluid from leaking out of wheel? 1 Prepare a vacuum hose to prevent brake fluid from leaking out of the steel brake line. Place a screw or bolt in one end. 2 Locate the steel brake line...
Easy lifehacks

Can you put a Ford F-150 in Park?

Can you put a Ford F-150 in Park? Nope, not it. Then my father in law (gotta love the phone a friend to my wife's dad) suggested that I shift the car into neutral and back into park. Apparently there is some safety device that doesn't allow the car to start if it doesn't think it is in park. On older vehicles this isn't as accurate as it might be. That did it. Is the Ford F150 5.4 no start? This vehicle, 05' Ford F150 5.4, came into the shop with a customer concern of a no crank/no start condition....