Easy lifehacks

What to do if your Dodge truck does not shift?

What to do if your Dodge truck does not shift? If you are in doubt if it shifted or not, pull the shifter back down to Low. If your Transmission does not shift, proceed to the next step after the transmission cools down. Hot ATF is no fun so be careful. Once the ATF has cooled down so that you don't get burnt. Drop the transmission pan for a closer inspection of the problem. Can a truck shift out of first gear? My truck won't shift out of first gear. chevrolet transmi... Q: My truck won't shift out of first...
Easy tips

How do you replace the engine belt on a Chevy Colorado?

How do you replace the engine belt on a Chevy Colorado? Pull the belt out of the Colorado's engine bay. Measure the Colorado's old belt against the replacement belt to ensure you have a proper replacement before installing the new one. The old belt may have stretched up to 1 inch during its lifetime. What does the serpentine belt on a Chevy Colorado do? The Chevrolet Colorado has a serpentine drive belt system to provide operational torque to the engine accessories, such as the water pump, alternator and power steering pump. The long, continuous belt winds its way through the...
Common questions

Is a drive shaft a CV axle?

Is a drive shaft a CV axle? All front-wheel drive cars have Constant Velocity joints or CV joints on both ends of the drive shafts (half shafts). Inner CV joints connect the drive shafts to the transmission, while the outer CV joints connect the drive shafts to the wheels. Can you run a truck without CV axle? Yes you can drive your truck with out cv joints. But you do need part of the cv joint . If that makes any sence. If you break a cv joint pull it apart and remove the joint of the cv closes to...
Easy lifehacks

How much does a LS1 engine swap cost?

How much does a LS1 engine swap cost? A more realistic starting budget is around $1500 to $2000 for a basic swap using a common truck engine, factory exhaust manifolds, and your existing front crossmember and rear axle. Swaps that require fabricated oil pans, aftermarket crossmembers, or rear suspension overhauls can set you back considerably more. What do I need for a LS1 conversion? 10 Parts You'll Need for Any LS Engine SwapMotor Mounts. See all 11 photos.Accessory Drive. See all 11 photos. Intake Manifold. See all 11 photos.Headers/Exhaust. See all 11 photos. Dress Items. See all 11 photos. Power...
Other

How can I tell if my car starter is bad?

How can I tell if my car starter is bad? Visually inspect the battery terminals. Pop the hood of your car and check the positive and negative terminals of the battery. If there is any dirt or corrosion, it can cause a bad connection and a lack of power to the starter. What to do if your car battery won't start? Therefore, you can always give your battery a jump start and see if it can start the engine or not. If your battery fails to start the engine, you need to replace your car’s battery assuming all connections are...
Easy tips

What transmission is in a 1982 Camaro?

What transmission is in a 1982 Camaro? Chevrolet Camaro (third generation)Transmission4-speed manual 5-speed manual 3-speed automatic 4-speed automaticDimensionsWheelbase2,565 mm (101.0 in)Length1982–1987: 4,877 mm (192.0 in) 1988–1992: 4,890 mm (192.5 in) What kind of exhaust did a 1982 Camaro have? A dual pointer speedometer was also included. A 1982 Z28 can be distinguished from a 1983 and 1984 Z28 by its lack of a bowtie emblem connected to the Z28 emblem on the rear bumper. The CFI cars in 82 and 83 had an exhaust that had two mufflers connected by a pipe instead of a regular cross-flow dual outlet muffler...
Most popular

Is there a spark in my GM Truck?

Is there a spark in my GM Truck? Yes, that too would be an issue. However, you would get nothing when trying to start, let alone a spark issue. So I am having the same problem, and thought maybe I had a ground issue. Why does my C / K 1500 have no power? I have a '97 k1500 with a 350 and 4l60e automatic. Assuming all things are OK with the truck, would a bad fuel pressure regulator cause it to have no power at low rpm's? Why does my Chevy C / K 1500 bog out under acceleration?...
Easy tips

Where is the fuel pump located on a car?

Where is the fuel pump located on a car? On most modern vehicles, an electronic pump located in the tank pumps the fuel directly from the tank through the rest of the system. It is activated as soon as you turn the key to create fuel pressure for startup. If you try to start your car and it won't fire, listen near your fuel tank when you turn the key on. How does the O'Reilly fuel pump work? Touch device users, explore by touch or with swipe gestures. When autocomplete results are available use up and down arrows to review...
Common questions

Why does my turn signal stop when I apply the brakes?

Why does my turn signal stop when I apply the brakes? The brake and turn signals are "switched" in the trailer light adapter box with diodes. If one of the diodes is shorted, it will cause this problem. BINGO! the turn signals and brake lights are normally independent circuits on the car. Why is the left side of the turn signal not working? This time, though, the left or right side of the signals doesn't work. You may see the dash indicator lamps illuminating brightly, but the turn lights won't flash. You may be dealing with bad bulbs or a...
Other

What will a Bad distributor cap cause?

What will a Bad distributor cap cause? A faulty distributor cap can cause your engine to stall. Voltage must be produced by the spinning distributor rotor for the engine to keep running. If the rotor does not rotate properly, the engine loses power and stalls out as you're trying to drive. The longer you let this go on, the worse it will get. How can you tell if you have a Bad distributor cap? Look for any cracks or carbon trace in the cap. Inspect the condenser; the engine will not function if it is broken. The current will short...