How to replace the rear brakes and parking brake shoes? In order to remove the parking brake shoes, you have to pull those spring out, then remove the little plate. The lower spring and the adjuster, notice its direction. Remove the spring and put it and the starwheel (adjuster) in a safe place. On each show you can see a pin and spring that holds it in centered in place. How do you change the brake pads on a truck? With your car or truck safely supported on jack stands, remove the rear wheels. Loosen the bolts that hold the...

Why does my gas engine not start properly? Your fuel needs to be stored in a suitable container and treated with fuel stabilizer to be sure it doesn’t go stale. Stale fuel, dirt, and debris are the most common cause of outdoor power equipment not starting or running properly. If you store equipment with untreated gas in the tank, it can lead to engine damage. Is your oil fresh? What to do if your gas won't start? Fill the gas tank with new gas. Find a small drain bolt located on the very bottom middle of the carburetor. Place a...

Are there any problems with the Dodge Ram air conditioner? Finally, Dodge Ram air conditioning vent problems may include but are not limited to vibration and lack of air. Vibration and noise are two common problems found on the Dodge Ram. And most of the time, swapping out the blower motor solves the issue. Why is the clutch not engaging on my Dodge Ram? The thing is that my AC clutch will always engage when engine is cold but will shut off about 15-20 after. I can turn it back on by either turning the engine off and let it...

Can you put r134 in a R12 system? To be able to use R134a in an R12 system, the R12 system needs to undergo a retrofitting so that it's able to handle and process R134a refrigerant. This also means that some refrigerant conversion needs to be done in order to drop R134a into a R12 system. What are the modifications required for an existing R12 refrigeration system to be retrofitted to R-134a refrigerant? On many 1989 through 1993 vintage vehicles, R-12 A/C systems can be converted by simply recovering any refrigerant that is still in the system, adding POE oil...

What causes ignition switch to fail on Dodge Intrepid? However, if the internal contacts wear out or burn, the switch may fail to transfer battery power to the starter solenoid, which prevents your car from starting, or may cause a short and fail to cut power to the starter system, making your motor run until you disconnect battery power. Detach the black battery cable (the ground) using a wrench. How to disable the air bag system on a Dodge Intrepid? Disconnecting the ground cable will disable the air bag system on your Dodge Intrepid. Remove the tilt lever from the...