Other

What causes a motor to be down to earth?

What causes a motor to be down to earth? The most common cause of motor failure, and arguably the most difficult to overcome, is low resistance. Low resistance is caused by the degradation of the insulation of the windings due to conditions such as overheating, corrosion, or physical damage. What causes the motor to overheat? Engines can overheat for many reasons. In general, it's because something's wrong within the cooling system and heat isn't able to escape the engine compartment. The source of the issue could include a cooling system leak, faulty radiator fan, broken water pump, or clogged coolant...
Common questions

Can a loose gas cap cause car not to start?

Can a loose gas cap cause car not to start? Hi There, A faulty gas cap can certainly case the check engine light to come on, but will usually not cause performance issues. What are the symptoms of a bad fuel cap? Another symptom of an issue with the fuel cap is a fuel smell from the vehicle. If the gas cap leaks, or fails to provide a proper seal it can cause fuel vapors to escape from the fuel tank, which may cause the vehicle to give off a fuel smell. Why does my check engine light come on...
Other

What does it mean when check engine light blinks?

What does it mean when check engine light blinks? If check engine light blinks that means its serious and you should pull over immediately. CEL on means there is a problem that you need to check on this week. Light flashing, means you should pull over to the side of the road and get your cell phone out. What happens if you have a flashing engine light? Driving with a flashing engine light can result in more expensive problems with your engine. One example is if the car is misfiring/not running at all on one cylinder, and you keep driving...
Most popular

Why does my shifter keep locking?

Why does my shifter keep locking? The main components that control the locking and unlocking of the shifter are the vehicle ignition switch, the brake light/stoplight switch and the shift interlock solenoid. Additionally, if your vehicle's battery is dead, the shifter will be stuck in Park. What to do when your shifter is stuck? Follow these 6 steps to release a stuck shifter 1 Set the emergency brake. 2 Insert key into the ignition and turn the ignition switch to the “ON” or “RUN” position. It is not necessary to start the engine. 3 Locate the shift lock override slot...
Easy tips

Why is the thermostat on my Chrysler 300 not working?

Why is the thermostat on my Chrysler 300 not working? The job of your 300’s thermostat is to regulate the temperature of the engine. It does this by allowing water to enter the engine when it is getting hot, and by keeping coolant from entering while the vehicle warms up. Sometimes when a thermostat goes bad, it stays stuck open. This allows the coolant to continuously enter the engine. What causes a car temperature gauge to stay on low? What could cause the temperature gauge to stay on low? The most common causes of why the temperature gauge stays on...
Common questions

Where are the linkage bushings on a wiper blade?

Where are the linkage bushings on a wiper blade? They are found underneath the hood of the automobile and are necessary for the wiper arm and the blade to work properly. These linkage bushings can become damaged through constant use and need to be replaced. Where do I put the wiper bushing on my car? Loosen the hex nut holding the wiper arm in place and set it aside. Pull the wiper assembly off and repeat the process for the wiper on the other side. Pull up the screen on the front of the windshield of the vehicle to access...
Other

Why does my Chrysler minivan Wiper not work?

Why does my Chrysler minivan Wiper not work? The wipers should now run at the “low” speed. Grounding the red/white wire trips the wiper ON relay located in the power distribution center (PDC). If they don’t operate at low speed, it’s time to check the fuses and wiring. What happens when a windshield wiper relay goes bad? When the relay is faulty, the windshield wipers will only work at the same speed that the last relay signal was sent. In layman's terms, if you had your windshield wipers on the slow speed the last time they were active, and you...
Most popular

What to do when your brake light has no power?

What to do when your brake light has no power? This portion of the guide is to help you test for power when one, both lower or all three brake lights have no power. Test the Fuses: Use the owners manual or the lid of the fuse panel to find the brake light fuse. Then use a test light to check the fuses for the brake light and BCM fuses and replace if any are blown. What causes a fuse to blow on a brake light? If the fuse is blown it could be caused by a shorted wire to...
Easy lifehacks

What to do when your EGR valve is off?

What to do when your EGR valve is off? Clean out the entry port. The entry port is where the valve tubes connect to the engine (usually the intake manifold) while the EGR valve is off. Reinstall the EGR valve. Check to ensure the vacuum diaphragm moves freely, reinstall the EGR valve and reattach the exhaust return and vacuum hoses. Disconnect the negative battery cable. Where is the entry port for the EGR valve? Clean out the entry port. The entry port is where the valve tubes connect to the engine (usually the intake manifold) while the EGR valve is...
Other

Is lane departure warning same as blind spot monitoring?

Is lane departure warning same as blind spot monitoring? Here's how they're different: Lane departure warning uses a camera that looks ahead to tell if you're drifting out of lane. If your turn signal is off, it alerts you. Blind spot detection has sonar or radar sensors that look back and to the side. Can you add blind spot monitoring to a f150? Radar Blind Spot System with Cross Traffic Detection Ford F-150 2015-2020 RDBS-1520. Get award-winning Radar Blind Spot Detection now for your Truck! This is the one retrofit Radar Blind Spot monitoring and detection system that works like...